- 您現在的位置：買賣IC網 > PDF目錄374166 > CS5106LSW24 (ZF Electronics Corporation) Multi-Feature, Synchronous plus Auxiliary PWM Controller PDF資料下載
參數資料
| 型號： | CS5106LSW24 |
| 廠商： | ZF Electronics Corporation |
| 英文描述： | Multi-Feature, Synchronous plus Auxiliary PWM Controller |
| 中文描述： | 多特征，加上輔助同步PWM控制器 |
| 文件頁數： | 7/12頁 |
| 文件大小： | 195K |
| 代理商： | CS5106LSW24 |
C
7
PACKAGE LEAD #
LEAD SYMBOL
FUNCTION
Package Lead Description: continued
9
V
FB1
Voltage Feedback Lead for the Auxiliary PWM. A voltage which represents
the auxiliary power supply output voltage is fed to this lead. A voltage less
than RAMP1+0.13 on V
FB1
will cause GATE1 to go low.
V
SS
power/feedback input lead. See V
CC
for description of power operation.
In addition, this lead is fed to a divide by ten resistor divider and compared to
1.2V nominal at the positive side of the error amplifier.
V
CC
power input lead. This input runs off a Zener referenced supply until
V
SS
> V
CC
. Then an internal diode which runs between V
SS
and V
CC
turns on
and all main power is derived from V
SS
.
Auxiliary PWM gate drive lead. This output normally drives the FET which
drives the auxiliary transformer.
Ground lead.
Synchronous PWM gate drive lead. This output normally drives the FET
which drives the main transformer.
Synchronous PWM gate drive lead. This output normally drives the FET for
the gate drive transformer used for synchronous rectification.
Voltage feedback lead for the synchronous PWM. A voltage which represents
the main power supply output voltage is fed to this lead. A voltage less than
RAMP2+0.13 on V
FB2
will cause GATE2 to go low and GATE2B to go high.
Current ramp input lead for the synchronous PWM. A voltage which is linear
with respect to current in the primary side of the main trans former is usually
represented on this lead. A voltage exceeding V
FB2
- 0.13 on RAMP2 will
cause GATE2 to go low and GATE2B to go high.
Pulse by pulse over current protection lead for the synchronous PWM. A volt-
age exceeding 1.2V nominal on I
LIM2
will cause GATE2 to go low and GATE2B
to go high. A voltage exceeding 1.4V nominal on I
LIM2
will cause GATE2 to go
low and GATE2B to go high for at least two clock cycles.
GATE2, GATE2B non-overlap time adjustment lead. A 27k resistor from
DLYSET to ground sets the non-overlap time to 45ns nominal.
Frequency adjustment lead. A 27k resistor from FADJ to ground sets the
clock frequency to 512kHz nominal.
Clock output lead. This is a 50% duty cycle, 1V to 5V pulse whose rising edge
is in phase with GATE1. This signal can be used to synchronize other power
supplies.
Clock synchronization lead. The internal clock frequency can be adjusted
+10%, -15% by the onset of positive edges of an external clock occurring on the
SYNC
IN
lead. If the external clock frequency is out side the internal clock fre-
quency by +25%, -35% the external clock is ignored and the internal clock free
runs.
ENABLE programming input. See ENABLE for programming states. PRO-
GRAM has at least 20μA min. of available source current.
PWM enable input. If PROGRAM is HIGH then a LOW on ENABLE will
allow GATE1, GATE2 and GATE2B to switch. If PROGRAM is LOW then a
HIGH on ENABLE will allow GATE1, GATE2 and GATE2B to switch. If
ENABLE is left floating, it will pull up to a HIGH level. ENABLE has at least
100μA (min) of available source current.
10
V
SS
11
V
CC
12
GATE1
13
14
Gnd
GATE2
15
GATE2B
16
V
FB2
17
RAMP2
18
I
LIM2
19
DLYSET
20
FADJ
21
SYNC
OUT
22
SYNC
IN
23
PROGRAM
24
ENABLE
相關PDF資料 |
PDF描述 |
|---|---|
| CS5106LSWR24 | Multi-Feature, Synchronous plus Auxiliary PWM Controller |
| CS5111 | 1.4A Switching Regulator with 5V, 100mA Linear Regulator with Watchdog, RESET and ENABLE |
| CS5111YDWF24 | 1.4A Switching Regulator with 5V, 100mA Linear Regulator with Watchdog, RESET and ENABLE |
| CS5111YDWFR24 | 1.4A Switching Regulator with 5V, 100mA Linear Regulator with Watchdog, RESET and ENABLE |
| CS5112 | 1.4A Switching Regulator with 5V, 100mA Linear Regulator with Watchdog, RESET and ENABLE |
相關代理商/技術參數 |
參數描述 |
|---|---|
| CS5106LSWR24 | 功能描述:IC REG CTRLR FLYBK ISO CM 24SSOP RoHS:否 類別:集成電路 (IC) >> PMIC - 穩壓器 - DC DC 切換控制器 系列:- 標準包裝:4,000 系列:- PWM 型:電壓模式 輸出數:1 頻率 - 最大:1.5MHz 占空比:66.7% 電源電壓:4.75 V ~ 5.25 V 降壓:是 升壓:無 回掃:無 反相:無 倍增器:無 除法器:無 Cuk:無 隔離:無 工作溫度:-40°C ~ 85°C 封裝/外殼:40-VFQFN 裸露焊盤 包裝:帶卷 (TR) |
| CS-5106SW24 | 制造商:未知廠家 制造商全稱:未知廠家 功能描述:Current-Mode SMPS Controller |
| CS-5106SWR24 | 制造商:未知廠家 制造商全稱:未知廠家 功能描述:Current-Mode SMPS Controller |
| CS5107AF | 制造商:Rochester Electronics LLC 功能描述:- Bulk |
| CS-510A-2DW18 | 制造商:未知廠家 制造商全稱:未知廠家 功能描述:2-Channel Disk Read/Write Circuit |
發布緊急采購，3分鐘左右您將得到回復。