- 您現在的位置：買賣IC網 > PDF目錄374166 > CS51311GDR14 (ZF Electronics Corporation) Synchronous CPU Buck Controller for 12V and 5V Applications PDF資料下載
參數資料
| 型號： | CS51311GDR14 |
| 廠商： | ZF Electronics Corporation |
| 英文描述： | Synchronous CPU Buck Controller for 12V and 5V Applications |
| 中文描述： | 同步降壓控制器的CPU為12V和5V的應用 |
| 文件頁數： | 17/19頁 |
| 文件大小： | 239K |
| 代理商： | CS51311GDR14 |
Application Information: continued
C
17
I
CL(NOM)
=
=
= 26A.
Maximum Current Limit Setpoint
From the overcurrent detection data in the electrical char-
acteristics table:
V
TH(MAX)
= 101mV,
I
CL(MAX)
=
=
=
= 38.7A.
Therefore, the range of load currents that will cause the
internal current sense comparator to detect an overload
condition through a 3.2m
embedded PCB trace is: 19.3A
< I
CL
< 38.7A, with 26A being the nominal overload condi-
tion.
Design Rules for Using a Droop Resistor
The basic equation for laying an embedded resistor is:
R
AR
=
ρ
×
or R =
ρ
×
,
where
A= W
×
t = cross-sectional area;
ρ
= the copper resistivity (μ
-mil);
L= length (mils);
W = width (mils);
t = thickness (mils).
For most PCBs the copper thickness, t, is 35μm (1.37 mils)
for one ounce copper;
ρ
= 717.86μ
-mil.
For a CPU load of 16A the resistance needed to create a
50mV drop at full load is:
R
DROOP
=
=
= 3.1m
.
The resistivity of the copper will drift with the temperature
according to the following guidelines:
R = 12% @ T
A
= +50
C;
R = 34% @T
A
= +100
C.
Droop Resistor Length, Width, and Thickness
The minimum width and thickness of the droop resistor
should primarily be determined on the basis of the current-
carrying capacity required, and the maximum permissible
droop resistor temperature rise. PCB manufacturer design
charts can be used in determining current- carrying capaci-
ty and sizes of etched copper conductors for various tem-
perature rises above ambient.
For single conductor applications, such as the use of the
droop resistor, PCB design charts show that for a droop
resistor with a required current-carrying capacity of 16A,
and a 45
C temperature rise above ambient, the recom-
mended cross section is 275 mil
2
.
W
×
t = 275 mil
2
,
where
W = droop resistor width;
t = droop resistor thickness.
For 1oz. copper, t= 1.37 mils, therefore W = 201 mils =
0.201 in.
R =
ρ
×
,
where
R = droop resistor value;
ρ
= 0.71786m
-mil (1 oz. copper);
L = droop resistor length;
W = droop resistor width.
R
DROOP
= 3.3m
.
3.3m
= 0.71786m
-mil
×
.
Hence, L = 1265 mils = 1.265 in.
In layouts where it is impractical to lay out a droop resistor
in a straight line 1265 mils long, the embedded PCB trace
can be “snaked” to fit within the available space.
Thermal Considerations for Power MOSFETs
In order to maintain good reliability, the junction tempera-
ture of the semiconductor components should be kept to a
maximum of 150°C or lower. The thermal impedance
(junction to ambient) required to meet this requirement can
be calculated as follows:
Thermal Impedance =
A heatsink may be added to TO-220 components to reduce
their thermal impedance. A number of PC board layout
techniques such as thermal vias and additional copper foil
area can be used to improve the power handling capability
of surface mount components.
As a consequence of large currents being turned on and off
at high frequency, switching regulators generate noise as a
consequence of their normal operation. When designing
for compliance with EMI/EMC regulations, additional
components may be added to reduce noise emissions.
These components are not required for regulator operation
and experimental results may allow them to be eliminated.
EMI Management
T
J(MAX)
- T
A
Power
Thermal Management
L
201 mils
×
1.37 mils
L
W
×
t
50mV
16A
50mV
I
OUT
L
(W
×
t)
L
A
101mV
3.3m
× 0.79
V
TH(MAX)
R
SENSE(NOM)
× 0.79
V
TH(MAX)
R
SENSE(MIN)
86mV
3.3m
V
TH(TYP)
R
SENSE(NOM)
相關PDF資料 |
PDF描述 |
|---|---|
| CS51311 | Synchronous CPU Buck Controller for 12V and 5V Applications |
| CS51311GD14 | Synchronous CPU Buck Controller for 12V and 5V Applications |
| CS51312GDR16 | Synchronous CPU Buck Controller for 12V Only Applications |
| CS51312 | Synchronous CPU Buck Controller for 12V Only Applications |
| CS51312GD16 | Synchronous CPU Buck Controller for 12V Only Applications |
相關代理商/技術參數 |
參數描述 |
|---|---|
| CS-51313D16 | 制造商:未知廠家 制造商全稱:未知廠家 功能描述:Current-Mode SMPS Controller |
| CS-51313DR16 | 制造商:未知廠家 制造商全稱:未知廠家 功能描述:Current-Mode SMPS Controller |
| CS51313GDR16 | 制造商:Rochester Electronics LLC 功能描述: 制造商:ON Semiconductor 功能描述: |
| CS-5132 | 制造商:未知廠家 制造商全稱:未知廠家 功能描述:Dual Output CPU Buck Controller |
| CS5132DW24 | 制造商:ON Semiconductor 功能描述: |
發布緊急采購，3分鐘左右您將得到回復。