參數資料
型號: CS5376A-IQZ
廠商: Cirrus Logic Inc
文件頁數: 9/49頁
文件大?。?/td> 0K
描述: IC FILTER DGTL MULTI-CH 64-TQFP
標準包裝: 160
濾波器類型: 數字
濾波器數: 4
濾波器階數: 2nd
電源電壓: 3 V ~ 5 V
安裝類型: 表面貼裝
封裝/外殼: 64-LQFP
供應商設備封裝: 64-TQFP(10x10)
包裝: 管件
配用: 598-1778-ND - EVALUATION BOARD FOR CS5376
2008 Fairchild Semiconductor Corporation
www.fairchildsemi.com
FUSB2805 Rev. 1.0.3
17
F
USB2
8
0
5
USB2
.0
High
-S
pee
d
OTG
Tra
nsc
e
iv
e
rw
ith
UL
P
I
Inter
fac
e
USB Packet Timing
The USB2.0 specification defines the inter-packet
timing
and
the
UTMI/UTMI+
specifications
define
synchronization and processing delays. The ULPI Rev.
1.1 specification defines the inter-packet delays to
ensure compatibility with USB2.0 and supplemental
specifications.
Pipeline Delays
Table 6 describes the delays (in clock cycles) with
which to comply using ULPI. The USB bus events are
measured relative to D+ and D-. The ULPI timings are
relative to the clock edge on which the transition is
detected (i.e. the clock edge on which STP is detected).
Table 6.
Pipeline Delays
Parameter Name
HS PHY
Delay
FS PHY
Delay
LS PHY
Delay
Definition
RXCMD Delay(J/K)
4
Number of clocks after a change in the internal
USB bus state is detected to an RXCMD byte being
sent over the ULPI bus. Applies to all changes
except SE0.
RXCMD Delay(SE0)
4
4 to 6
16 to 18
Number of clocks between the USB bus state
indicating SE0 to an RXCMD byte being sent over
the ULPI bus. Delay is increased due to filtering.
TX Start Delay
1 to 2
6 to 10
74 to 75
Number of clocks between the FUSB2805 detecting
a TXCMD on the ULPI bus to transmitting the first K
of the SYNC pattern on the USB bus.
TX End Delay (packets)
2 to 5
NA
Number of clocks between the FUSB2805 detecting
STP on the ULPI bus to completing EOP
transmission on the USB bus.
HS EOP is completed when all eight consecutive
ones have finished transmitting on the USB bus.
FS/LS packets finish many clock cycles after STP
is asserted. The link must look for RXCMD bytes
indicating SE0-to-J transition to determine when the
transmission is completed on the USB bus.
TX End Delay (SOF)
6 to 9
NA
HS SOF packets have a long EOP. The link must
wait at least nine clocks or for an RXCMD,
indicating squelch (LINESTATE=00b), before
transmitting the next packet.
RX Start Delay
3 to 8
NA
Number of clocks after first K of SYNC pattern is
seen on the USB bus to the simultaneous assertion
of DIR and NXT or an RXCMD indicating RxActive.
Used for HS packets only.
For FS/LS packets, the link must look for RXCMD
bytes indicating J-to-K transition.
RX End Delay
3 to 8
17 to 18
122 to 123
Number of clocks after EOP occurs on the USB bus
to the FUSB2805 de-asserting DIR or indicating
RxActive LOW in an RXCMD byte.
HS EOP is completed when all eight consecutive
ones have finished transmitting on the USB bus.
FS/LS EOP occurs when SE0 starts on the USB
bus. For FS/LS, the link uses LINESTATE and not
RxEnd delay to time USB packets.
Note:
11. Please refer to ULPI Rev 1.1 specifications, section 3.8.2.6.2 for details on PHY pipeline delays.
相關PDF資料
PDF描述
CS61577-IL1Z IC LINE INTERFACE T1/E1 28PLCC
CS61584A-IQ3Z IC LINE INTERFACE T1/E1 64LQFP
CS61884-IRZ IC LN INTERF T1/E1/J1 160-LFBGA
CS8130-CS IC IR TRANSCEIVER 2-5V 20-SSOP
CS8190EDWF20G IC TACH/SPEEDO DRVR PREC 20SOICW
相關代理商/技術參數
參數描述
CS5376A-IQZR 功能描述:特殊用途放大器 LP Multi-Ch. Decimation Filter RoHS:否 制造商:Texas Instruments 通道數量:Single 共模抑制比(最小值): 輸入補償電壓: 工作電源電壓:3 V to 5.5 V 電源電流:5 mA 最大功率耗散: 最大工作溫度:+ 70 C 最小工作溫度:- 40 C 安裝風格:SMD/SMT 封裝 / 箱體:QFN-20 封裝:Reel
CS5376-BQ 制造商:Rochester Electronics LLC 功能描述:- Bulk
CS5378 制造商:CIRRUS 制造商全稱:Cirrus Logic 功能描述:Low-power Single-channel Decimation Filter
CS5378_08 制造商:CIRRUS 制造商全稱:Cirrus Logic 功能描述:Low-power Single-channel Decimation Filter
CS5378-IS 功能描述:特殊用途放大器 IC LP Single-Ch Decimation Filter RoHS:否 制造商:Texas Instruments 通道數量:Single 共模抑制比(最小值): 輸入補償電壓: 工作電源電壓:3 V to 5.5 V 電源電流:5 mA 最大功率耗散: 最大工作溫度:+ 70 C 最小工作溫度:- 40 C 安裝風格:SMD/SMT 封裝 / 箱體:QFN-20 封裝:Reel