參數資料
型號: DJLXT972MTEA4
廠商: Intel Corp.
英文描述: Single-Port 10/100 Mbps PHY Transceiver
中文描述: 單端口10/100 Mbps的物理層收發器
文件頁數: 31/92頁
文件大?。?/td> 666K
代理商: DJLXT972MTEA4
Intel
LXT972M Single-Port 10/100 Mbps PHY Transceiver
Datasheet
Document Number: 302875-005
Revision Date: 27-Oct-2005
31
5.4.1
MDIO Control Mode and Hardware Control Mode
In the MDIO Control mode, the LXT972M Transceiver reads the Hardware Control Interface pins
to set the initial (default) values of the MDIO registers. Once the initial values are set, bit control
reverts to the MDIO interface.
The following modes are available using MDIO Control.
Force network link operation to:
— 100BASE-TX, Full-Duplex
— 100BASE-TX, Half-Duplex
— 10BASE-T, Full-Duplex
— 10BASE-T, Half-Duplex
Allow auto-negotiation/parallel-detection
On power-up or hardware reset, the LXT972M Transceiver reads the Hardware Control Interface
pins and sets the MDIO registers accordingly.
The following modes are available using the Hardware Control:
Auto-negotiation-enabled advertising, either:
— 10/100 BASE-T Full/Half Duplex
— 10/100 BASE-T Half Duplex
LXT972M Transceiver device ID enable
Link Hold-off
When the network link is forced to a specific configuration, the LXT972M Transceiver
immediately begins operating the network interface as commanded. When auto-negotiation is
enabled, the LXT972MTransceiver begins the auto-negotiation/parallel-detection operation.
5.4.2
Reduced-Power Modes
This section discusses the LXT972M Transceiver reduced-power modes.
5.4.2.1
Software Power Down
Software power-down control is provided by Register bit 0.11 in the Control Register. (See
Table 41 on page 76.)
During soft power-down, the following conditions are true:
The network port is shut down.
The MDIO registers remain accessible.
5.4.3
Reset for Intel
LXT972M Transceiver
The LXT972M Transceiver provides both hardware and software resets, each of which manage
differently the configuration control of auto-negotiation, speed, and duplex-mode selection.
For a software reset, Register bit 0.15 = 1. For register bit definitions used for software reset, see
Table 41, “Control Register - Address 0, Hex 0” on page 76
.
相關PDF資料
PDF描述
DK015L Teccor manufactures 15 A rms to 25 A rms rectifiers with voltages rated from 200V to 1000V
DK020L Teccor manufactures 15 A rms to 25 A rms rectifiers with voltages rated from 200V to 1000V
DK025L Teccor manufactures 15 A rms to 25 A rms rectifiers with voltages rated from 200V to 1000V
DK1001-7R ALARM SENSORS
DK2540-7R 150 Watt DC-DC Converters
相關代理商/技術參數
參數描述
DJLXTEAD0QE000 制造商:INTEL 制造商全稱:Intel Corporation 功能描述:Advanced 8-Port 10/100 Mbps PHY Transceivers
DJLXTEAD0QE001 制造商:INTEL 制造商全稱:Intel Corporation 功能描述:Advanced 8-Port 10/100 Mbps PHY Transceivers
DJLXTEAD0SE000 制造商:INTEL 制造商全稱:Intel Corporation 功能描述:Advanced 8-Port 10/100 Mbps PHY Transceivers
DJLXTEAD0SE001 制造商:INTEL 制造商全稱:Intel Corporation 功能描述:Advanced 8-Port 10/100 Mbps PHY Transceivers
DJLXTECD0QE000 制造商:INTEL 制造商全稱:Intel Corporation 功能描述:Advanced 8-Port 10/100 Mbps PHY Transceivers