參數資料
型號： DM9161E
廠商： Electronic Theatre Controls, Inc.
英文描述： 10/100 Mbps FAST ETHERNET PHYSICAL LAYER SINGLE CHIP TRANSCEIVER
中文描述： 10/100 Mbps快速以太網物理層單芯片收發器
文件頁數： 18/47頁
文件大?。?/td> 561K
代理商： DM9161E
DM9161
10/100 Mbps Fast Ethernet Physical Layer Single Chip Transceiver
18
Final
Version: DM9161-DS-F02
May 10,2002
7.2.2.4 Clock Recovery Module
The Clock Recovery Module accepts NRZI data from the
MLT-3 to NRZI decoder. The Clock Recovery Module locks
onto the data stream and extracts the 125Mhz reference
clock. The extracted and synchronized clock and data are
presented to the NRZI to NRZ Decoder.
7.2.2.5 NRZI to NRZ
The transmit data stream is required to be NRZI encoded in
for compatibility with the TP-PMD standard for 100Base-TX
transmission over Category-5 unshielded twisted pair cable.
This conversion process must be reversed on the receive
end. The NRZI to NRZ decoder, receives the NRZI data
stream from the Clock Recovery Module and converts
it to a NRZ data stream to be presented to the Serial to
Parallel conversion block.
7.2.2.6 Serial to Parallel
The Serial to Parallel Converter receives a serial data
stream from the NRZI to NRZ converter, and converts
the data stream to parallel data to be presented to the
descrambler.
7.2.2.7 Descrambler
Because the scrambling process requires to control the
radiated emissions of transmit data streams, the receiver
must descramble the receive data streams. The
descrambler receives scrambled parallel data streams from
the Serial to Parallel converter, descrambles the data
streams, and presents the data streams to the Code Group
alignment block.
7.2.2.8 Code Group Alignment
The Code Group Alignment block receives un-aligned
5B data from the descrambler and converts it into 5B
code group data. Code Group Alignment occurs after
the J/K is detected, and subsequent data is aligned on
a fixed boundary.
7.2.2.9 4B5B Decoder
The 4B5B Decoder functions as a look-up table that
translates incoming 5B code groups into 4B (Nibble) data.
When receiving a frame, the first 2 5-bit code groups
received are the start-of-frame delimiter (J/K symbols). The
J/K symbol pair is stripped and two nibbles of preamble
pattern are substituted. The last two code groups are the
end-of-frame delimiter (T/R symbols).
The T/R symbol pair is also stripped from the nibble
presented to the Reconciliation layer.
7.2.3 10Base-T Operation
The 10Base-T transceiver is IEEE 802.3u compliant. When
the DM9161 is operating in 10Base-T mode, the coding
scheme is Manchester. Data processed for transmit is
presented to the MII interface in nibble format, converted to a
serial bit stream, then Manchester encoded. When receiving,
the Manchester encoded bit stream is decoded and
converted into nibble format for presentation to the MII
interface.
7.2.4 Collision Detection
For half-duplex operation, a collision is detected when the
transmit and receive channels are active simultaneously.
When a collision has been detected, it will be reported by the
COL signal on the MII interface. Collision detection is
disabled in Full Duplex operation.
7.2.5 Carrier Sense
Carrier Sense (CRS) is asserted in half-duplex operation
during transmission or reception of data. During full-duplex
mode, CRS is asserted only during receive operations.
7.2.6 Auto-Negotiation
The objective of Auto-negotiation is to provide a means to
exchange information between segment linked devices and
to automatically configure both devices to take maximum
advantage of their abilities. It is important to note that Auto-
negotiation does not test the link segment characteristics.
The Auto-Negotiation function provides a means for a device
to advertise supported modes of operation to a remote link
partner, acknowledge the receipt and understanding of
common modes of operation, and to reject un-shared
modes of operation. This allows devices on both ends of a
segment to establish a link at the best common mode of
operation. If more than one common mode exists between
the two devices, a mechanism is provided to allow the
devices to resolve to a single mode of operation using a
predetermined priority resolution function.
相關PDF資料
PDF描述
DM9301 100Mbps Ethernet Fiber/Twisted Pair Single Chip Media Converter
DM9301F 100Mbps Ethernet Fiber/Twisted Pair Single Chip Media Converter
DM9324 5-Bit Comparator
DM9324N 5-Bit Comparator
DM9328 Dual 8-Bit Shift Register
相關代理商/技術參數
參數描述
DM9161EP 制造商:DAVICOM 功能描述:IC TRX 10/100MBPS ENET PHY48LQFP 制造商:DAVICOM 功能描述:IC, TRX, 10/100MBPS, ENET PHY,48LQFP 制造商:DAVICOM 功能描述:CONTROLLER, ETHERNET, 100MBPS, LQFP-48; Data Rate:100Mbps; Ethernet Type:IEEE 802.3u; Supply Voltage Max:3.3V; Digital IC Case Style:LQFP; No. of Pins:48; IC Interface Type:MII, RMII; Package / Case:48-LQFP ;RoHS Compliant: Yes
DM9161電路圖-1 制造商:未知廠家 制造商全稱:未知廠家 功能描述:DM9161電路圖-1
DM9162 制造商:DAVICOM 制造商全稱:DAVICOM 功能描述:10/100 Mbps Fast Ethernet Physical Layer Single Chip Transceiver
DM9162EP 制造商:DAVICOM 制造商全稱:DAVICOM 功能描述:10/100 Mbps Fast Ethernet Physical Layer Single Chip Transceiver
DM9162NP 制造商:DAVICOM 制造商全稱:DAVICOM 功能描述:10/100 Mbps Fast Ethernet Physical Layer Single Chip Transceiver
發布緊急采購，3分鐘左右您將得到回復。

采購需求

(若只采購一條型號，填寫一行即可)

發布成功！您可以繼續發布采購。也可以進入我的后臺，查看報價

發布成功！您可以繼續發布采購。也可以進入我的后臺，查看報價

*型號 *數量 廠商 批號 封裝
添加更多采購

我的聯系方式

*
*
*