參數資料
型號: DS2890P-000
廠商: Maxim Integrated Products
文件頁數: 5/27頁
文件大小: 0K
描述: IC POT DIGITAL 1-WIRE 100K 6TSOC
標準包裝: 120
接片: 256
電阻(歐姆): 100k
電路數: 1
溫度系數: 標準值 800 ppm/°C
存儲器類型: 易失
接口: 1 線 串行
電源電壓: 2.8 V ~ 6 V
工作溫度: -40°C ~ 85°C
安裝類型: 表面貼裝
封裝/外殼: 6-LSOJ
供應商設備封裝: 6-TSOC
包裝: 管件
DS2890
13 of 27
1-WIRE BUS SYSTEM
The 1-Wire bus is a system, which has a single bus master and one or more slaves. In all instances the
DS2890 is a slave device. The bus master is typically a microcontroller. The discussion of this bus system
is broken down into three topics: hardware configuration, transaction sequence, and 1-Wire signaling
(signal types and timing). The 1-Wire protocol defines bus transactions in terms of the bus state during
specific time slots that are initiated on the falling edge of sync pulses from the bus master.
HARDWARE CONFIGURATION
The 1-Wire bus has only a single line by definition; it is important that each device on the bus be able to
drive it at the appropriate time. To facilitate this, each device attached to the 1-Wire bus must have open
drain or 3-state outputs. The 1-Wire port of the DS2890 is open drain with an internal circuit equivalent
to that shown in Figure 9. A multi-drop bus consists of a 1-Wire bus with multiple slaves attached. At
regular speed the 1-Wire bus has a maximum data rate of 16.3 kbits per second. The speed can be boosted
to 142 kbits per second by activating the Overdrive Mode. For a discrete bus master interface as in
Figure 14, the 1-Wire bus requires a pull-up resistor with a minimum value of 2.2 k
Ω. Depending on
1-Wire communication speed, regular or overdrive, and bus load characteristics, the optimal pull-up
resistor value will be in the 1.5 k
Ω to 5 kΩ range. Figure 15 shows a DS2480B bus master configuration
with an interface to the host CPU serial port. Among many features, the DS2480B simplifies the 1-Wire
interface design, generates slew-rate controlled 1-Wire waveforms, and off-loads 1-Wire timing
generation overhead required in a discrete solution.
The idle state for the 1-Wire bus is high. If for any reason a transaction needs to be suspended, the bus
MUST be left in the idle state if the transaction is to resume. If this does not occur and the bus is left low
for more than 16 s (Overdrive Speed) or more than 120 s (regular speed), one or more devices on the
bus may be reset.
FIGURE 14. HARDWARE CONFIGURATION
RX
TX
Open Drain
Port Pin
5 A
Typ.
DS2890 1-WIRE PORT
RX = RECEIVE
TX = TRANSMIT
BUS MASTER
VPUP
DATA
RX
TX
MOSFET
100
Ω
See
Text
NOTE:
Depending on 1-Wire communication speed, regular or overdrive, and bus load characteristics, the
optimal pull-up resistor value will be in the 1.5 k
Ω to 5 kΩ range.
相關PDF資料
PDF描述
VE-26H-MW-S CONVERTER MOD DC/DC 52V 100W
VE-264-MW-S CONVERTER MOD DC/DC 48V 100W
VE-262-MW-S CONVERTER MOD DC/DC 15V 100W
DS1844E-010 IC POT DIG QUAD 10K 20-TSSOP
74VHC153SJ MULTIPLEXER DUAL 4IN 16SOP
相關代理商/技術參數
參數描述
DS2890P-000+ 功能描述:IC POT DIGITAL 1-WIRE 100K 6TSOC RoHS:是 類別:集成電路 (IC) >> 數據采集 - 數字電位器 系列:- 產品培訓模塊:Lead (SnPb) Finish for COTS Obsolescence Mitigation Program 標準包裝:2,500 系列:- 接片:32 電阻(歐姆):50k 電路數:1 溫度系數:標準值 50 ppm/°C 存儲器類型:易失 接口:3 線串行(芯片選擇,遞增,增/減) 電源電壓:2.7 V ~ 5.5 V 工作溫度:-40°C ~ 85°C 安裝類型:表面貼裝 封裝/外殼:SOT-23-6 細型,TSOT-23-6 供應商設備封裝:TSOT-23-6 包裝:帶卷 (TR)
DS2890P-000+T&R 制造商:Maxim Integrated Products 功能描述:IC POT DIGITAL 1-WIRE 100K 6TSOC
DS2890P-000+T&R 功能描述:IC POT DIGITAL 1-WIRE 100K 6TSOC RoHS:是 類別:集成電路 (IC) >> 數據采集 - 數字電位器 系列:- 產品培訓模塊:Lead (SnPb) Finish for COTS Obsolescence Mitigation Program 標準包裝:2,500 系列:- 接片:32 電阻(歐姆):50k 電路數:1 溫度系數:標準值 50 ppm/°C 存儲器類型:易失 接口:3 線串行(芯片選擇,遞增,增/減) 電源電壓:2.7 V ~ 5.5 V 工作溫度:-40°C ~ 85°C 安裝類型:表面貼裝 封裝/外殼:SOT-23-6 細型,TSOT-23-6 供應商設備封裝:TSOT-23-6 包裝:帶卷 (TR)
DS2890T 制造商:DALLAS 制造商全稱:Dallas Semiconductor 功能描述:1-Wire Digital Potentiometer
DS2890T-000 功能描述:數字電位計 IC RoHS:否 制造商:Maxim Integrated 電阻:200 Ohms 溫度系數:35 PPM / C 容差:25 % POT 數量:Dual 每 POT 分接頭:256 弧刷存儲器:Volatile 緩沖刷: 數字接口:Serial (3-Wire, SPI) 描述/功能:Dual Volatile Low Voltage Linear Taper Digital Potentiometer 工作電源電壓:1.7 V to 5.5 V 電源電流:27 uA 最大工作溫度:+ 125 C 安裝風格:SMD/SMT 封裝 / 箱體:TQFN-16 封裝:Reel