806
SAM4CP [DATASHEET]
43051E–ATPL–08/14
The following triggers are common to both modes:
Software Trigger: Each channel has a software trigger, available by setting SWTRG in TC_CCR.
SYNC: Each channel has a synchronization signal SYNC. When asserted, this signal has the same effect as a
software trigger. The SYNC signals of all channels are asserted simultaneously by writing TC_BCR (Block Control)
with SYNC set.
Compare RC Trigger: RC is implemented in each channel and can provide a trigger when the counter value
matches the RC value if CPCTRG is set in the TC_CMR.
The channel can also be configured to have an external trigger. In Capture Mode, the external trigger signal can be
selected between TIOA and TIOB. In Waveform Mode, an external event can be programmed on one of the following
signals: TIOB, XC0, XC1 or XC2. This external event can then be programmed to perform a trigger by setting bit
ENETRG in the TC_CMR.
If an external trigger is used, the duration of the pulses must be longer than the peripheral clock period in order to be
detected.
37.6.7 Capture Operating Mode
This mode is entered by clearing the WAVE bit in the TC_CMR.
Capture Mode allows the TC channel to perform measurements such as pulse timing, frequency, period, duty cycle and
phase on TIOA and TIOB signals which are considered as inputs.
Figure 37-5
shows the configuration of the TC channel when programmed in Capture Mode.
37.6.8 Capture Registers A and B
Registers A and B (RA and RB) are used as capture registers. This means that they can be loaded with the counter value
when a programmable event occurs on the signal TIOA.
The LDRA field in the TC_CMR defines the TIOA selected edge for the loading of register A, and the LDRB field defines
the TIOA selected edge for the loading of Register B.
RA is loaded only if it has not been loaded since the last trigger or if RB has been loaded since the last loading of RA.
RB is loaded only if RA has been loaded since the last trigger or the last loading of RB.
Loading RA or RB before the read of the last value loaded sets the Overrun Error Flag (LOVRS bit) in the TC_SR. In this
case, the old value is overwritten.