參數資料
型號： EVAL-AD5243SDZ
廠商： Analog Devices Inc
文件頁數： 5/20頁
文件大?。?/td> 0K
描述： BOARD EVAL FOR AD5243
標準包裝： 1
系列： *
Data Sheet
AD5243/AD5248
Rev. B | Page 13 of 20
THEORY OF OPERATION
The AD5243/AD5248 are 256-position, digitally controlled
variable resistor (VR) devices.
An internal power-on preset places the wiper at midscale
during power-on, which simplifies the fault condition recovery
at power-up.
PROGRAMMING THE VARIABLE RESISTOR AND
VOLTAGE
Rheostat Operation
The nominal resistance of the RDAC between Terminal A and
Terminal B is available in 2.5 kΩ, 10 kΩ, 50 kΩ, and 100 kΩ.
The nominal resistance (RAB) of the VR has 256 contact points
accessed by the wiper terminal and the B terminal contact. The
8-bit data in the RDAC latch is decoded to select one of the 256
possible settings.
A
W
B
A
W
B
A
W
B
04109-0-012
Figure 37. Rheostat Mode Configuration
Assuming that a 10 kΩ part is used, the first connection of the
wiper starts at the B terminal for Data 0x00. Because there is
a 160 Ω wiper contact resistance, such a connection yields a
minimum of 320 Ω (2 × 160 Ω) resistance between Terminal W
and Terminal B. The second connection is the first tap point,
which corresponds to 359 Ω (RWB = RAB/256 + 2 × RW = 39 Ω +
2 × 160 Ω) for Data 0x01. The third connection is the next tap
point, representing 398 Ω (2 × 39 Ω + 2 × 160 Ω) for Data 0x02,
and so on. Each LSB data value increase moves the wiper up the
resistor ladder until the last tap point is reached at 10,281 Ω
(RAB + 2 × RW).
D5
D4
D3
D7
D6
D2
D1
D0
RDAC
LATCH
AND
DECODER
RS
A
W
B
04109-0-013
Figure 38. AD5243 Equivalent RDAC Circuit
The general equation determining the digitally programmed
output resistance between W and B is
W
AB
WB
R
D
R
2
256
)
(
(1)
where:
D
is the decimal equivalent of the binary code loaded in the
8-bit RDAC register.
RAB
is the end-to-end resistance.
RW
is the wiper resistance contributed by the on resistance of
the internal switch.
In summary, if RAB is 10 kΩ and the A terminal is open circuited,
the following output resistance, RWB, is set for the indicated
RDAC latch codes.
Table 7. Codes and Corresponding RWB Resistance
D (Dec)
RWB (Ω)
Output State
255
10,281
Full scale (RAB 1 LSB + 2 × RW)
128
5380
Midscale
1
359
1 LSB + 2 × RW
0
320
Zero scale (wiper contact resistance)
Note that in the zero-scale condition, a finite wiper resistance of
320 Ω is present. Care should be taken to limit the current flow
between W and B in this state to a maximum pulse current of no
more than 20 mA. Otherwise, degradation or possible destruction
of the internal switch contact may occur.
Similar to the mechanical potentiometer, the resistance of the
RDAC between Wiper W and Terminal A also produces a
digitally controlled complementary resistance, RWA. When these
terminals are used, the B terminal can be opened. Setting the
resistance value for RWA starts at a maximum value of resistance
and decreases as the data loaded in the latch increases in value.
The general equation for this operation is
W
AB
WA
R
D
R
2
256
)
(
(2)
When RAB is 10 kΩ and the B terminal is open circuited, the
output resistance, RWA, is set according to the RDAC latch
codes, as listed in Table 8.
Table 8. Codes and Corresponding RWA Resistance
D (Dec)
RWA (Ω)
Output State
255
359
Full scale
128
5320
Midscale
1
10,280
1 LSB + 2 × RW
0
10,320
Zero scale
Typical device-to-device matching is process-lot dependent and
may vary by up to ±30%. Because the resistance element is pro-
cessed in thin-film technology, the change in RAB with temperature
has a very low temperature coefficient of 35 ppm/°C.
相關PDF資料
PDF描述
RSA10DRMH CONN EDGECARD 20POS .125 SQ WW
RMA10DRMH CONN EDGECARD 20POS .125 SQ WW
H3DDS-6406G IDC CABLE - HKR64S/AE64G/HKR64S
PX0840/A/5M00 CABLE PLUG IP68 USB A-B 5M
RCA22DRMH CONN EDGECARD 44POS .125 SQ WW
相關代理商/技術參數
參數描述
EVAL-AD5245EBZ 功能描述:EVAL BOARD FOR AD5245 RoHS:是 類別:編程器，開發系統 >> 評估演示板和套件 系列:- 標準包裝:1 系列:- 主要目的:電信，線路接口單元（LIU） 嵌入式:- 已用 IC / 零件:IDT82V2081 主要屬性:T1/J1/E1 LIU 次要屬性:- 已供物品:板，電源，線纜，CD 其它名稱:82EBV2081
EVAL-AD5246DBZ 功能描述:BOARD EVAL FOR AD5246DBZ RoHS:否 類別:編程器，開發系統 >> 評估演示板和套件 系列:* 標準包裝:1 系列:- 主要目的:電信，線路接口單元（LIU） 嵌入式:- 已用 IC / 零件:IDT82V2081 主要屬性:T1/J1/E1 LIU 次要屬性:- 已供物品:板，電源，線纜，CD 其它名稱:82EBV2081
EVAL-AD5246EBZ 功能描述:BOARD EVAL AD5264 RoHS:是 類別:編程器，開發系統 >> 評估演示板和套件 系列:- 標準包裝:1 系列:- 主要目的:電信，線路接口單元（LIU） 嵌入式:- 已用 IC / 零件:IDT82V2081 主要屬性:T1/J1/E1 LIU 次要屬性:- 已供物品:板，電源，線纜，CD 其它名稱:82EBV2081
EVAL-AD5247DBZ 功能描述:BOARD EVAL FOR AD5247DBZ RoHS:否 類別:編程器，開發系統 >> 評估演示板和套件 系列:* 標準包裝:1 系列:- 主要目的:電信，線路接口單元（LIU） 嵌入式:- 已用 IC / 零件:IDT82V2081 主要屬性:T1/J1/E1 LIU 次要屬性:- 已供物品:板，電源，線纜，CD 其它名稱:82EBV2081
EVAL-AD5252EBZ 功能描述:BOARD EVAL FOR AD5252 RoHS:是 類別:編程器，開發系統 >> 評估演示板和套件 系列:- 產品培訓模塊:Obsolescence Mitigation Program 標準包裝:1 系列:- 主要目的:電源管理，電池充電器 嵌入式:否 已用 IC / 零件:MAX8903A 主要屬性:1 芯鋰離子電池 次要屬性:狀態 LED 已供物品:板
發布緊急采購，3分鐘左右您將得到回復。

采購需求

(若只采購一條型號，填寫一行即可)

發布成功！您可以繼續發布采購。也可以進入我的后臺，查看報價

發布成功！您可以繼續發布采購。也可以進入我的后臺，查看報價

*型號 *數量 廠商 批號 封裝
添加更多采購

我的聯系方式

*
*
*