參數資料
型號: HFBR-5207
英文描述: 622 Mbps Multimode Fiber Transceiver for ATM,SONET STS-12/SDH STM-4(應用于 ATM,SONET STS-12/SDH STM-4的622 Mbps多模式光收發器)
中文描述: 622 Mbps的多模光纖收發器(應用于自動取款機,SONET的STS-12/SDH的STM - 4的622對ATM,SONET的STS-12/SDH的STM - 4 Mbps的多模式光收發器)
文件頁數: 3/16頁
文件大?。?/td> 102K
代理商: HFBR-5207
3
The relative timing relationship
between the output re-timed data
and the recovered clock signals
is shown graphically in Figure 1.
Fundamentally, the rising edge of
the Clock and the falling edge of
the clock bar will occur at the
center of the Data or Data-bar
baud interval. Conversely, the
Clock falling edge and the Clock-
bar rising edge will be at the
edges of the Data or Data-bar
baud interval.
For input optical power greater
than the specified receiver sensi-
tivity of -26 dBm, the bit-error-
ratio will be better than 1 x 10
-10
.
As the input power is decreased
by several dB, the bit-error-ratio
degrades. Within 1 dB below the
1 x 10
-2
BER input optical power
level, the CDR will begin to lose
lock and the clock frequency will
drift from 622.08 MHz. Once
the CDR loses lock, the clock fre-
quency will sweep in the entire
VCO range, about 540 to 700 MHz.
The rate of the sweep will depend
on the input optical power. The
sweep rate gets faster the lower
the input optical power is. Once
the input optical power is 2 dB
below the lock point, the sweep
rate approaches the maximum.
At this point the clock and data
outputs look no different than the
case with no input optical power.
There will be a data edge for every
clock edge. The data output will
consist of randomly switching
data bits, i.e., noise.
Detailed Description of
Receiver Signal Detect Feature
As the input optical power is
decreased, Signal Detect will
switch from high to low (de-assert
point) somewhere between 3 dB
below sensitivity and the no light
input level. As the input optical
power is increased from very low
levels, Signal Detect will switch
from low to high (assert point)
somewhere between 2 dB below
sensitivity and no input optical
power at all. The assert level will
be at least 1.0 dB higher than the
de-assert level.
Optional Local Clock
Generation
In applications where the receiver
recovered clock frequency is not
allowed to drift upon loss of input
optical signal, this transceiver
has the ability to generate a local
clock output by multiplying an
optional, external 19.44 MHz
reference clock up to the OC-12
(622.08 MHz) rate.
This feature is possible because
the clock recovery system con-
sists of two loops: a data loop
which locks onto the incoming
optical data stream, and a second
reference loop which locks onto
the optional external reference
clock.
This optional feature is initiated
by applying a Lock-to-Reference
logic low signal to pin 2 (Lck
Ref-) which switches the loop to
the external reference clock and
disables the received data outputs.
Pin 2 (Lck Ref-) can be driven
from the Signal Detect pin 15
(SD) output or from other logic
further upstream in the ATM
interface which may be monitor-
ing the quality of the received
data stream.
Product Variations
Available by Special
Request
Transceiver Without
CDR Function
The HFBR-5208 Transceiver is
available in the smaller 1 x 9 pin-
out package style without integral
Clock and Data Recovery
functions for those designers who
prefer the flexibility of designing
with a different partitioning of the
physical layer interface.
Transceiver Specified
for Wide Temperature
Range Operation
The HFBR-5207 is specified for
operation over normal commercial
temperature range of 0
°
C to 70
°
C.
The product has been character-
ized and is available with guaran-
teed performance over wider
temperature ranges by special
request.
Other Members of HP
622 Mb/s Product Family
HFBR-5208, 1300 nm LED-
based transceiver in 1 x 9
package for 500 m links with
MMF cables
CDX2622, 1300 nm laser-based
transceiver with integral clock
and data recovery in 2 x 9
package for links with SMF
cables
XMT5360-622, 1300 nm laser-
based transmitter in pigtailed
package for 2 km and 15 km
links with SMF cables
XMT5160-622, 1300 nm laser-
based transmitter in pigtailed
package for 40 km links with
SMF cables
RCV1201D-622, receiver in
pigtailed package for 2 km,
15 km and 40 km links with
SMF cables
RGR1622, receiver with
integral clock and data
recovery in pigtailed packages
for 2 km, 15 km and 40 km
Links with SMF cables
HP is planning to have a
compatible SMF 1X9 solution
available. Please contact your
HP field sales representative
for additional information.
相關PDF資料
PDF描述
HFBR-5208M 1 x 9 Fiber Optic Transceivers for 622 Mb/s ATM/SONET/SDH Applications(應用于622 Mb/s ATM/SONET/SDH 的1 x 9光纖收發器)
HFCT-5208M 1 x 9 Fiber Optic Transceivers for 622 Mb/s ATM/SONET/SDH Applications(應用于622 Mb/s ATM/SONET/SDH 的1 x 9光纖收發器)
HFBR-5208 1300 nm LED Transceiver for ATM, SONET/SDH 622 Mb/s and General Purpose 155 - 650 Mb/s(應用于ATM, SONET/SDH 622 Mb/s和 通用155 - 650 Mb/s的1300 nm LED收發器)
HFBR-5303 850 nm VCSEL 1x9 Transceiver(850 nm VCSEL 1x9 收發器)
HFBR-53D3 850 nm VCSEL 1x9 Transceiver(850 nm VCSEL 1x9 收發器)
相關代理商/技術參數
參數描述
HFBR-5208 功能描述:光纖發射器、接收器、收發器 622Mbps ATM MMF 1x9 Trxcvr RoHS:否 制造商:Omron Electronics 產品:Transmitters 數據速率:3.5 Gbps 波長:850 nm 最大工作溫度: 最小工作溫度: 封裝 / 箱體: 封裝:
HFBR-5208AEM 功能描述:光纖發射器、接收器、收發器 1x9 622Mb/s SR ExtTe mp Txcvr Metal RoHS:否 制造商:Omron Electronics 產品:Transmitters 數據速率:3.5 Gbps 波長:850 nm 最大工作溫度: 最小工作溫度: 封裝 / 箱體: 封裝:
HFBR-5208AEMZ 功能描述:光纖發射器、接收器、收發器 1x9 622Mb/s SR ExTp Txc Metal RoHS RoHS:否 制造商:Omron Electronics 產品:Transmitters 數據速率:3.5 Gbps 波長:850 nm 最大工作溫度: 最小工作溫度: 封裝 / 箱體: 封裝:
HFBR-5208AFM 功能描述:光纖發射器、接收器、收發器 1x9 622Mb/s SR ExtTe mp Txcvr Metal RoHS:否 制造商:Omron Electronics 產品:Transmitters 數據速率:3.5 Gbps 波長:850 nm 最大工作溫度: 最小工作溫度: 封裝 / 箱體: 封裝:
HFBR-5208AFMZ 功能描述:光纖發射器、接收器、收發器 1x9 622Mb/s SR ExTp Txc Metal RoHS RoHS:否 制造商:Omron Electronics 產品:Transmitters 數據速率:3.5 Gbps 波長:850 nm 最大工作溫度: 最小工作溫度: 封裝 / 箱體: 封裝: