參數資料
型號: HMS81C2020AQ
廠商: Electronic Theatre Controls, Inc.
英文描述: CMOS Single-Chip 8-Bit Microcontroller with A/D Converter & VFD Driver
中文描述: CMOS單芯片8位微控制器與A / D轉換器
文件頁數: 46/107頁
文件大?。?/td> 1482K
代理商: HMS81C2020AQ
HMS81C2012A/2020A
42
SEP. 2004 Ver 2.00
11. WATCHDOG TIMER
The watchdog timer rapidly detects the CPU malfunction
such as endless looping caused by noise or the like, and re-
sumes the CPU to the normal state.
The watchdog timer signal for detecting malfunction can
be selected either a reset CPU or a interrupt request.
When the watchdog timer is not being used for malfunc-
tion detection, it can be used as a timer to generate an in-
terrupt at fixed intervals. The purpose of the watchdog
timer is to detect the malfunction (runaway) of program
due to external noise or other causes and return the opera-
tion to the normal condition.
The watchdog timer has two types of clock source.
The first type is an on-chip RC oscillator which does not
require any external components. This RC oscillator is sep-
arate from the external oscillator of the Xin pin. It means
that the watchdog timer will run, even if the clock on the
Xin pin of the device has been stopped, for example, by en-
tering the STOP mode.
The other type is a prescaled system clock.
The watchdog timer consists of 7-bit binary counter and
the watchdog timer data register. When the value of 7-bit
binary counter is equal to the lower 7 bits of WDTR, the
interrupt request flag is generated. This can be used as
WDT interrupt or reset the CPU in accordance with the bit
WDTON.
Note:
Because the watchdog timer counter is enabled af-
ter clearing Basic Interval Timer, after the bit WDTON set to
"1", maximum error of timer is depend on prescaler ratio of
Basic Interval Timer. The 7-bit binary counter is cleared by
setting WDTCL(bit7 of WDTR) and the WDTCL is cleared
automatically after 1 machine cycle.
The RC oscillated watchdog timer is activated by setting
the bit RCWDT as shown below.
LDM
LDM
STOP
NOP
NOP
:
CKCTLR,#3FH; enable the RC-osc WDT
WDTR,#0FFH; set the WDT period
; enter the STOP mode
; RC-osc WDT running
The RCWDT oscillation period is vary with temperature,
VDD and process variations from part to part (approxi-
mately, 40~120uS). The following equation shows the
RCWDT oscillated watchdog timer time-out.
T
RCWDT
=CLK
RCWDT
×2
8
×[
WDTR.6~0]+(CLK
RCWDT
×2
8
)/2
where, CLK
RCWDT
= 40~120uS
In addition, this watchdog timer can be used as a simple 7-
bit timer by interrupt WDTIF. The interval of watchdog
timer interrupt is decided by Basic Interval Timer. Interval
equation is as below.
T
WDT
= [WDTR.6~0]
×
Interval of BIT
Figure 11-1 Block Diagram of Watchdog Timer
to reset CPU
BASIC INTERVAL TIMERsource
enable
Watchdog
Counter (7-bit)
7-bit compare data
comparator
Watchdog Timer interrupt
clear
clear
WDTIF
WDTCL
“0”
“1”
WDTON in CKCTLR [0EC
H
]
Watchdog Timer
Register
WDTR
Internal bus line
7
[0ED
H
]
相關PDF資料
PDF描述
HMS81C20XXA CMOS Single-Chip 8-Bit Microcontroller with A/D Converter & VFD Driver
HMS81C20XXA-HK CMOS Single-Chip 8-Bit Microcontroller with A/D Converter & VFD Driver
HN2716 2048-word x 8bit Erasable and Electrically Programmable Only Memory
HN27512 512K (64K X 8 BIT ) UV AND OTP EPROM
HN27512P-25 512K (64K X 8 BIT ) UV AND OTP EPROM
相關代理商/技術參數
參數描述
HMS81C20XXA 制造商:未知廠家 制造商全稱:未知廠家 功能描述:CMOS Single-Chip 8-Bit Microcontroller with A/D Converter & VFD Driver
HMS81C20XXA-HK 制造商:未知廠家 制造商全稱:未知廠家 功能描述:CMOS Single-Chip 8-Bit Microcontroller with A/D Converter & VFD Driver
HMS81C2112A 制造商:未知廠家 制造商全稱:未知廠家 功能描述:[VFD MCU: High Voltage IO/ADC/HS PWM/SCI]
HMS81C2120A 制造商:未知廠家 制造商全稱:未知廠家 功能描述:[VFD MCU: High Voltage IO/ADC/HS PWM/SCI]
HMS81C4260 制造商:HYNIX 制造商全稱:Hynix Semiconductor 功能描述:HYNIX SEMICONDUCTOR INC. 8-BIT SINGLE-CHIP MICROCONTROLLERS