- 您現在的位置：買賣IC網 > PDF目錄360744 > ICS2002 Wavedec Digital Audio Codec PDF資料下載
參數資料
| 型號： | ICS2002 |
| 元件分類： | Codec |
| 英文描述： | Wavedec Digital Audio Codec |
| 中文描述： | Wavedec數字音頻編解碼器 |
| 文件頁數： | 19/21頁 |
| 文件大?。?/td> | 550K |
| 代理商： | ICS2002 |
IRA1 DAC De-glitcher Control
Bits 7:3 - Volume bits 7:3 (read only)
Bit 2 - DAC Enable Bit (read only, for test)
Bits 1:0 - DAC De-glitch Width
Code
00
01
10
11
Notes
De-glitcher disabled
Minimum de-glitch width
Nominal de-glitch width
Maximum de-glitch width
This value is determined by the clock rate at which the
chip is run. ICS will provide the proper value for an
application. This register is also used for test purposes.
This register is not initialized in any way and should be
programmed before muting is removed.
IRA2 reserved
IRA3 reserved
ADC and Analog Control Registers
IRA4 ADC Control
Bits 7:3 - reserved
Bit 2 - ADC Test Mode
This bit is for factory testing use only, and must always
be programmed to zero by an application. It is reset to
zero by a zero in ADCRUN, and hence takes two writes
of $05 to this register to activate for safety.
Bit 1 - reserved
Bit 0 - ADC Run
When written to a one, this bit enables the ADC hard-
ware to run. Note that the ADC Timing Control register
should be programmed appropriately first. Also note
that the DSP must be running (and programmed prop-
erly) for the conversion results to be retrieved. The
Sample Rate Generator determines the rate at which the
conversion data is loaded into the Record FIFO.
This bit is cleared to zero by MCR.
Note that this bit, when 0, shuts down the successive
approximation logic, the dynamic comparators and
various logic functions. When the ADC is not being
used, disabling it via this bit reduces background noise
in the playback section and power consumption, and
thus is recommended.
IRA5 Analog Volume/Mute
Bits 7:5 - reserved
Bits 4:1 - Analog Volume
These bits set the analog output level, in 1.5dB steps.
All bits one gives 0dB attenuation of the DAC output
signal, and all bits zero gives full attenuation. These bits
are unaffected by any reset mechanism.
Bit 0 - Audio Enable
This bit disconnects the audio output of the output
buffer amp and sets the BUFOUT pin to the nominal
bias voltage when cleared to zero. When set to one, it
passes the output of the output buffer amp to the
BUFOUT pin.
The main function of this bit is to prevent sudden DC
offset changes on the BUFOUT pin when entering and
leaving power-down mode. By proper software proce-
dure, noiseless transitions can be made.
This bit is cleared to zero by MCR.
IRA6 ADC Timing Control
This register is used to control the ADC internal opera-
tion timing.
Bits 7:4 - Comparator Timing Control
These bits control the time of comparator input switch-
ing. Bits 7:5 are the count, and bit 4 is 0 for half cycle
and 1 full cycle delays.
Bits 3:1 - Cycle Timing Control
These bits control the number of clocks used for each
step of the successive approximation process. For the
full 64 step DSP cycle, the value of these bits should be
7. For a 40 step cycle, the value should be 4.
Bit 0 - reserved
ICS2002
19
相關PDF資料 |
PDF描述 |
|---|---|
| ICS2002Y | Wavedec Digital Audio Codec |
| ICS2008B | SMPTE Time Code Receiver/Generator |
| ICS200 | SMPTE Time Code Receiver/Generator |
| ICS2008BEP | SMPTE Time Code Receiver/Generator |
| ICS2008BY-10 | ER 35C 35#16 PIN PLUG |
相關代理商/技術參數 |
參數描述 |
|---|---|
| ICS2002V | 制造商:未知廠家 制造商全稱:未知廠家 功能描述:Soundcard Circuits |
| ICS2002Y | 制造商:ICS 制造商全稱:ICS 功能描述:Wavedec Digital Audio Codec |
| ICS2008AV | 制造商:未知廠家 制造商全稱:未知廠家 功能描述: |
| ICS2008AY | 制造商:未知廠家 制造商全稱:未知廠家 功能描述:Industrial Control IC |
| ICS2008B | 制造商:IDT 制造商全稱:Integrated Device Technology 功能描述:SMPTE Time Code Receiver/Generator |
發布緊急采購，3分鐘左右您將得到回復。