Vo" />
參數資料
型號: IDT82V3010PVG8
廠商: IDT, Integrated Device Technology Inc
文件頁數: 18/31頁
文件大小: 0K
描述: IC PLL WAN 51/E1/OC3 DUAL 56SSOP
標準包裝: 1,000
類型: 時鐘/頻率發生器,多路復用器
PLL:
主要目的: 電信
輸入: 時鐘
輸出: CMOS,LVDS,TTL
電路數: 1
比率 - 輸入:輸出: 2:12
差分 - 輸入:輸出: 無/是
頻率 - 最大: 32.768MHz
電源電壓: 3 V ~ 3.6 V
工作溫度: -40°C ~ 85°C
安裝類型: 表面貼裝
封裝/外殼: 56-BSSOP(0.295",7.50mm 寬)
供應商設備封裝: 56-SSOP
包裝: 帶卷 (TR)
其它名稱: 82V3010PVG8
IDT82V3010
T1/E1/OC3 Telecom Clock Generator with Dual Reference Inputs
AC Electrical Characteristics
25
Feberuary 20, 2009
Notes:
Voltages are with respect to ground (VSS) unless otherwise stated. Supply voltage and
operating temperature are as per Recommended Operating Conditions. Timing
parameters are as per Timing Parameter Measurement Voltage Levels.
1. Fref0 reference input selected.
2. Fref1 reference input selected.
3. Normal mode selected.
4. Holdover mode selected.
5. Freerun mode selected.
6. 8 kHz frequency mode selected.
7. 1.544 MHz frequency mode selected.
8. 2.048 MHz frequency mode selected.
9. 19.44 MHz frequency mode selected.
10. Master clock input OSCi at 20 MHz ±0 ppm.
11. Master clock input OSCi at 20 MHz ±32 ppm.
12. Master clock input OSCi at 20 MHz ±100 ppm.
13. Selected reference input at ±0 ppm.
14. Selected reference input at ±32 ppm.
15. Selected reference input at ±100 ppm.
16. For Freerun mode of ±0 ppm.
17. For Freerun mode of ±32 ppm.
18. For Freerun mode of ±100 ppm.
19. For capture range of ±230 ppm.
20. For capture range of ±198 ppm.
21. For capture range of ±130 ppm.
22. 25 pF capacitive load.
23. OSCi Master Clock jitter is less than 2 nspp, or 0.04 UIpp where 1 UIpp = 1/20 MHz.
24. Jitter on reference input is less than 7 nspp.
25. Applied jitter is sinusoidal.
26. Minimum applied input jitter magnitude to regain synchronization.
27. Loss of synchronization is obtained at slightly higher input jitter amplitudes.
28. Within 10 ms of the state, reference or input change.
29. 1 UIpp = 125 s for 8 kHz signals.
30. 1 UIpp = 648 ns for 1.544 MHz signals.
31. 1 UIpp = 488 ns for 2.048 MHz signals.
32. 1 UIpp = 323 ns for 3.088 MHz signals.
33. 1 UIpp = 244 ns for 4.096 MHz signals.
34. 1 UIpp = 158 ns for 6.312 MHz signals.
35. 1 UIpp = 122 ns for 8.192 MHz signals.
36. 1 UIpp = 61 ns for 16.484 MHz signals.
37. 1 UIpp = 51 ns for 19.44 MHz signals.
38. 1 UIpp = 30 ns for 32.968 MHz signals.
39. No filter.
40. 40 Hz to 100 kHz bandpass filter.
41. With respect to reference input signal frequency.
42. After a RST or TCLR.
43. Master clock duty 40% to 60%.
44. Prior to Holdover mode, device as in Normal mode and phase locked.
45. With input frequency offset of 100 ppm.
相關PDF資料
PDF描述
D38999/26MF28SN CONN PLUG 28POS STRAIGHT W/SCKT
D38999/26MG16SA CONN PLUG 16POS STRAIGHT W/SCKT
ICS894D115BGI-01 IC CLK/DATA RECOVERY 20-TSSOP
VE-2N0-MX-F2 CONVERTER MOD DC/DC 5V 75W
VI-B1P-MW-F2 CONVERTER MOD DC/DC 13.8V 100W
相關代理商/技術參數
參數描述
IDT82V3011 制造商:IDT 制造商全稱:Integrated Device Technology 功能描述:T1/E1/OC3 WAN PLL WITH SINGLE REFERENCE INPUT
IDT82V3011PV 制造商:INT_DEV_TECH 功能描述:
IDT82V3011PVG 功能描述:IC PLL WAN T1/E1/OC3 SGL 56-SSOP RoHS:是 類別:集成電路 (IC) >> 時鐘/計時 - 專用 系列:- 標準包裝:1,500 系列:- 類型:時鐘緩沖器/驅動器 PLL:是 主要目的:- 輸入:- 輸出:- 電路數:- 比率 - 輸入:輸出:- 差分 - 輸入:輸出:- 頻率 - 最大:- 電源電壓:3.3V 工作溫度:0°C ~ 70°C 安裝類型:表面貼裝 封裝/外殼:28-SSOP(0.209",5.30mm 寬) 供應商設備封裝:28-SSOP 包裝:帶卷 (TR) 其它名稱:93786AFT
IDT82V3011PVG8 功能描述:IC PLL WAN T1/E1/OC3 SGL 56-SSOP RoHS:是 類別:集成電路 (IC) >> 時鐘/計時 - 專用 系列:- 標準包裝:1,500 系列:- 類型:時鐘緩沖器/驅動器 PLL:是 主要目的:- 輸入:- 輸出:- 電路數:- 比率 - 輸入:輸出:- 差分 - 輸入:輸出:- 頻率 - 最大:- 電源電壓:3.3V 工作溫度:0°C ~ 70°C 安裝類型:表面貼裝 封裝/外殼:28-SSOP(0.209",5.30mm 寬) 供應商設備封裝:28-SSOP 包裝:帶卷 (TR) 其它名稱:93786AFT
IDT82V3012 制造商:IDT 制造商全稱:Integrated Device Technology 功能描述:T1/E1/OC3 WAN PLL WITH DUAL REFERENCE INPUTS