- 您現在的位置：買賣IC網 > PDF目錄360868 > IP113 10/100Base-T to 100Base-FX Converter PDF資料下載
參數資料
| 型號： | IP113 |
| 英文描述： | 10/100Base-T to 100Base-FX Converter |
| 中文描述： | 10/100至100Base - FX光纖轉換器 |
| 文件頁數： | 6/27頁 |
| 文件大小： | 186K |
| 代理商： | IP113 |
第1頁第2頁第3頁第4頁第5頁當前第6頁第7頁第8頁第9頁第10頁第11頁第12頁第13頁第14頁第15頁第16頁第17頁第18頁第19頁第20頁第21頁第22頁第23頁第24頁第25頁第26頁第27頁
IP113
PIN Description
(continued)
Pin no.
LED pins used as initial setting mode during reset
Note:
Please refer to the paragraph of Initial Value Set Via Pins for detail information about pull high/ low setting.
86
X_EN
1: enable (default),
0: disable
It is internally pulled high.
92
BK_EN
IPH
Backpressure enable (BK_EN)
1: enable (default),
0: disable
It is internally pulled high.
90
AGING
1: enable, aging time 300s (default),
0: disable
It is internally pulled high.
88
R4_EN
A full duplex port will change its capability to half duplex, if the
remote full duplex port does not support IEEE802.3x and this
function is enabled.
1: enable, 0: disable (default)
It is internally pulled low.
98
103
104
OP[0]
OP[1:0] should be connected to VCC through resistors.
MODE should be connected to GND through resistors.
77,78
BP_KIND[1:0]
IPL
Backpressure type selection
Bp_kind[1:0] are valid only if Bk_en is set to high.
00: carrier base backpressure (default)
01: collision base backpressure with hashing
10: collision base backpressure without hashing
After reset, IP113 reads EEPROM with BP_KIND[1:0], which
works as EEDO and EEDI. BP_KIND[1] is an input signal and
BP_KIND[0] is an output signal during reading EEPROM. After
finishing reading EEPROM, these two pins becomes input
signal to isolate IP113 from EEPROM.
Preliminary, Specification subject to change without notice
IP113-DS-P07
Jul. 19, 2002
6
Label
Type
Description
IPH
IEEE 802.3X enable (X_en) on all ports
IPH
Address aging enable
IPL
Change capability enable (Update_r4_en)
MODE
OP[1]
IPL
Operation mode setting
It is used to enable TP port and fiber port.
相關PDF資料 |
PDF描述 |
|---|---|
| IP113M | Managed 10/100Base-TX / FX Media Converter |
| IP117AK-BSS2 | Voltage Regulator |
| IP117AK-DESC | Voltage Regulator |
| IP117AR | Voltage Regulator |
| IP117AR-883B | Voltage Regulator |
相關代理商/技術參數 |
參數描述 |
|---|---|
| IP113ALF | 制造商:未知廠家 制造商全稱:未知廠家 功能描述:10 /100Base-Tx/Fx Media Converter |
| IP113ALF-DS-R01 | 制造商:未知廠家 制造商全稱:未知廠家 功能描述:10 /100Base-Tx/Fx Media Converter |
| IP113ALF-DS-R02 | 制造商:未知廠家 制造商全稱:未知廠家 功能描述:10 /100Base-Tx/Fx Media Converter |
| IP113ALF-DS-R03 | 制造商:未知廠家 制造商全稱:未知廠家 功能描述:10 /100Base-Tx/Fx Media Converter |
| IP113ALF-DS-R04 | 制造商:未知廠家 制造商全稱:未知廠家 功能描述:10 /100Base-Tx/Fx Media Converter |
發布緊急采購，3分鐘左右您將得到回復。