- 您現在的位置：買賣IC網 > PDF目錄383159 > ISL6580CR (INTERSIL CORP) Integrated Power Stage PDF資料下載
參數資料
| 型號： | ISL6580CR |
| 廠商： | INTERSIL CORP |
| 元件分類： | 穩壓器 |
| 英文描述： | Integrated Power Stage |
| 中文描述： | 35 A SWITCHING REGULATOR, 1000 kHz SWITCHING FREQ-MAX, PQCC56 |
| 封裝： | 8 X 8 MM, PLASTIC, QFN-56 |
| 文件頁數： | 18/31頁 |
| 文件大?。?/td> | 1391K |
| 代理商： | ISL6580CR |
第1頁第2頁第3頁第4頁第5頁第6頁第7頁第8頁第9頁第10頁第11頁第12頁第13頁第14頁第15頁第16頁第17頁當前第18頁第19頁第20頁第21頁第22頁第23頁第24頁第25頁第26頁第27頁第28頁第29頁第30頁第31頁
18
ATR Threshold Definition
The ATRL and ATRH transient voltage thresholds are set
with the user interface software and written to the dedicated
ISL6580. The voltage offsets are programmed digitally in
7.5mV increments. The ATRL and ATRH offsets may be
specified independently.
ATR and VID Stepping
The reference voltage (PVID) used for ATR sensing is
updated synchronously with VID stepping. Therefore, the
ATR transient voltage thresholds programmed by the user
track VID automatically.
ATR Connections
The dedicated ISL6580 requires that the VRM sense leads
be connected to its vsense+ and vsense– inputs. This
sensed output voltage is compared against PVID and used
to generate ATRL and ATRH as necessary. It is highly
recommended that both PCB traces be routed as a minimal
length pair to minimize differential and common-mode noise
pickup. A single-pole low-pass filter at the vsense+ and
vsense– inputs is also recommended to further suppress
high-frequency pickup noise.
The ATRL and ATRH outputs of the dedicated ISL6580 must
be connected to the ATRL and ATRH inputs of the ISL6590.
It is highly recommended that both PCB traces be routed as
a pair to minimize skew and common-mode noise.
Protection Features
The ISL6580 / ISL6590 have several protection features that
shut down the converter to prevent catastrophic and
cascade system failures. Output voltages, currents and
temperatures are monitored and compared to limits that are
set by the designer (with the user interface software). Input
Under Voltage (IUVP), Output Under Voltage (OUVP),
Output Over Voltage (OOVP) and Over Temperature Sense
are detected by each ISL6580. If any of the fault limits are
exceeded a fault bit is set in the ISL6580’s fault register. The
ISL6590 controller polls the fault register continuously via
the Back Side Bus. If any of the fault bits are set the
converter shuts down. the user interface software reads the
fault registers and indicates which type of fault caused the
shut down (in the Controls and Interface window). Input
power must be cycled off to reset most faults. IUVP is reset
by cycling the OUT_EN line. The ISL6590 controller shuts
the converter down by setting all PWMs and NDRIVEs
signals to ground and switching all MOSFETs OFF.
Over Current Protection
Over Current is handled in two ways. One is Peak Current
Limiting (‘pulse by pulse’ current limiting). If the ISL6580
senses current above the Peak Current limit set with the
user interface software, it turns the upper MOSFET off for
the remainder of one switching period. This does not shut
down the converter.
NFET
i
NFET
i
+1
PFET
i
+1
PFET
i
PWM
i
+1
PWM
i
NDRIVE
i
NDRIVE
i
+1
ATRL
ATRH
FIGURE 24. COMBINATION OF SYNCHRONOUS (NFET AND
PFET) AND ASYNCHRONOUS (ATRL AND ATRH)
SIGNALS TO GENERATE EFFECTIVE CONTROL
SIGNALS (NDRIVE AND PWM) TO ISL6580’S
FIGURE 25. SAMPLE OUTPUT VOLTAGE TRANSIENT
RESPONSE WITHOUT & WITH ATR ENGAGED
ISL6580
相關PDF資料 |
PDF描述 |
|---|---|
| ISL6580CR-T | Integrated Power Stage |
| ISL6590 | Dual Low-Noise Wide-Bandwidth Precision Amplifier 8-PDIP -40 to 85 |
| ISL6590DR | Dual Low-Noise Wide-Bandwidth Precision Amplifier 8-PDIP -40 to 85 |
| ISL6592DNZ-T | FUSE, ANTISURGE 2A |
| ISL6592 | Dual Low-Noise Wide-Bandwidth Precision Amplifier 8-TSSOP -40 to 85 |
相關代理商/技術參數 |
參數描述 |
|---|---|
| ISL6580CR-T | 功能描述:IC DRIVER HIGH SIDE FET 56-QFN RoHS:否 類別:集成電路 (IC) >> PMIC - MOSFET，電橋驅動器 - 內部開關 系列:- 標準包裝:1,000 系列:- 類型:高端/低端驅動器 輸入類型:SPI 輸出數:8 導通狀態電阻:850 毫歐，1.6 歐姆 電流 - 輸出 / 通道:205mA，410mA 電流 - 峰值輸出:500mA，1A 電源電壓:9 V ~ 16 V 工作溫度:-40°C ~ 150°C 安裝類型:表面貼裝 封裝/外殼:20-SOIC（0.295"，7.50mm 寬） 供應商設備封裝:PG-DSO-20-45 包裝:帶卷 (TR) |
| ISL6590DR-T | 功能描述:IC REG CTRLR BST PWM VM 64-QFN RoHS:否 類別:集成電路 (IC) >> PMIC - 穩壓器 - DC DC 切換控制器 系列:- 標準包裝:2,500 系列:- PWM 型:電流模式 輸出數:1 頻率 - 最大:500kHz 占空比:100% 電源電壓:8.2 V ~ 30 V 降壓:無 升壓:無 回掃:是 反相:無 倍增器:無 除法器:無 Cuk:無 隔離:是 工作溫度:0°C ~ 70°C 封裝/外殼:8-DIP（0.300"，7.62mm） 包裝:管件 產品目錄頁面:1316 (CN2011-ZH PDF) |
| ISL6592DNZ-T | 功能描述:IC DIGTL MULTIPHASE CTRLR 48LQFP RoHS:是 類別:集成電路 (IC) >> PMIC - 電源控制器，監視器 系列:- 產品培訓模塊:Lead (SnPb) Finish for COTS Obsolescence Mitigation Program 標準包裝:2,500 系列:- 應用:多相控制器 輸入電壓:- 電源電壓:9 V ~ 14 V 電流 - 電源:- 工作溫度:-40°C ~ 85°C 安裝類型:表面貼裝 封裝/外殼:40-WFQFN 裸露焊盤 供應商設備封裝:40-TQFN-EP（5x5） 包裝:帶卷 (TR) |
| ISL6592DNZ-TR5196 | 功能描述:IC DIGTL MULTIPHASE CTRLR 48LQFP RoHS:是 類別:集成電路 (IC) >> PMIC - 電源控制器，監視器 系列:- 產品培訓模塊:Lead (SnPb) Finish for COTS Obsolescence Mitigation Program 標準包裝:2,500 系列:- 應用:多相控制器 輸入電壓:- 電源電壓:9 V ~ 14 V 電流 - 電源:- 工作溫度:-40°C ~ 85°C 安裝類型:表面貼裝 封裝/外殼:40-WFQFN 裸露焊盤 供應商設備封裝:40-TQFN-EP（5x5） 包裝:帶卷 (TR) |
| ISL6594ACB | 功能描述:IC MOSFET DRVR SYNC BUCK 8-SOIC RoHS:否 類別:集成電路 (IC) >> PMIC - MOSFET，電橋驅動器 - 外部開關 系列:- 標準包裝:50 系列:- 配置:低端 輸入類型:非反相 延遲時間:40ns 電流 - 峰:9A 配置數:1 輸出數:1 高端電壓 - 最大（自引導啟動）:- 電源電壓:4.5 V ~ 35 V 工作溫度:-40°C ~ 125°C 安裝類型:表面貼裝 封裝/外殼:TO-263-6，D²Pak（5 引線+接片），TO-263BA 供應商設備封裝:TO-263 包裝:管件 |
發布緊急采購，3分鐘左右您將得到回復。