參數資料
型號： ISP1161ABD
廠商： NXP SEMICONDUCTORS
元件分類： 總線控制器
英文描述： Full-speed Universal Serial Bus single-chip host and device controller
中文描述： UNIVERSAL SERIAL BUS CONTROLLER, PQFP64
封裝： 10 X 10 MM, 1.40 MM HEIGHT, PLASTIC, MS-026, SOT-314-2, LQFP-64
文件頁數： 108/134頁
文件大?。?/td> 587K
代理商： ISP1161ABD
Philips Semiconductors
ISP1161A
Full-speed USB single-chip host and device controller
Product data
Rev. 03 — 23 December 2004
108 of 134
9397 750 13962
Koninklijke Philips Electronics N.V. 2004. All rights reserved.
14. Power supply
ISP1161A can operate at either 5 V or 3.3 V.
When using 5 V as ISP1161A’s power supply input, only V
CC
(pin 56) can be
connected to the 5 V power supply. An application with a 5 V power supply input is
shown in
Figure 43
. ISP1161A has an internal DC/DC regulator to provide 3.3 V for
its internal core. This internal 3.3 V can also be obtained from V
reg(3.3)
(pin 58) to
supply the 1.5 k
pull-up resistor of the DC side upstream port signal D_DP. The
signal D_DP is connected to the standard USB upstream port connector’s pin D+.
When using 3.3 V as the power supply input, the internal DC/DC regulator will be
bypassed. All four power supply pins (V
CC
, V
reg(3.3)
, V
hold1
and V
hold2
) can be used as
power supply input.
It is recommended that you connect all four power supply pins to the 3.3 V power
supply, as shown in
Figure 44
. If, however, you have board space (routing area)
constraints, you must connect at least the V
CC
and the V
reg(3.3)
to the 3.3 V power
supply.
For both 3.3 V and 5 V operation, all four power supply pins should be connected to a
decoupling capacitor.
Fig 43. Using a 5 V supply.
Fig 44. Using a 3.3 V supply.
004aaa096
1.5 k
D_DP
GND
VCC
Vreg(3.3)
Vhold1
Vhold2
to USB
upstream
port
connector
+
5 V
ISP1161A
004aaa097
1.5 k
D_DP
GND
VCC
Vreg(3.3)
Vhold1
Vhold2
to USB
upstream
port
connector
+
3.3 V
ISP1161A
相關PDF資料
PDF描述
ISP1161ABM Full-speed Universal Serial Bus single-chip host and device controller
ISP1161 Full-speed Universal Serial Bus single-chip host and device controller
ISP1161A1 Universal Serial Bus single-chip host and device controller
ISP1161A1BD Universal Serial Bus single-chip host and device controller
ISP1161A1BM Universal Serial Bus single-chip host and device controller
相關代理商/技術參數
參數描述
ISP1161ABD,118 功能描述:USB 接口集成電路 DO NOT USE ORDER ISP1161A1BD RoHS:否 制造商:Cypress Semiconductor 產品:USB 2.0 數據速率: 接口類型:SPI 工作電源電壓:3.15 V to 3.45 V 工作電源電流: 最大工作溫度:+ 85 C 安裝風格:SMD/SMT 封裝 / 箱體:WLCSP-20
ISP1161ABD,151 功能描述:USB 接口集成電路 DO NOT USE ORDER ISP1161A1BD RoHS:否 制造商:Cypress Semiconductor 產品:USB 2.0 數據速率: 接口類型:SPI 工作電源電壓:3.15 V to 3.45 V 工作電源電流: 最大工作溫度:+ 85 C 安裝風格:SMD/SMT 封裝 / 箱體:WLCSP-20
ISP1161ABD,157 功能描述:USB 接口集成電路 DO NOT USE ORDER ISP1161A1BD RoHS:否 制造商:Cypress Semiconductor 產品:USB 2.0 數據速率: 接口類型:SPI 工作電源電壓:3.15 V to 3.45 V 工作電源電流: 最大工作溫度:+ 85 C 安裝風格:SMD/SMT 封裝 / 箱體:WLCSP-20
ISP1161ABD-S 功能描述:IC USB HOST CTRL FULL-SPD 64LQFP RoHS:是 類別:集成電路 (IC) >> 接口 - 控制器 系列:- 標準包裝:4,900 系列:- 控制器類型:USB 2.0 控制器 接口:串行 電源電壓:3 V ~ 3.6 V 電流 - 電源:135mA 工作溫度:0°C ~ 70°C 安裝類型:表面貼裝 封裝/外殼:36-VFQFN 裸露焊盤 供應商設備封裝:36-QFN（6x6） 包裝:* 其它名稱:Q6396337A
ISP1161ABD-T 功能描述:IC USB HOST CTRL FULL-SPD 64LQFP RoHS:是 類別:集成電路 (IC) >> 接口 - 控制器 系列:- 標準包裝:4,900 系列:- 控制器類型:USB 2.0 控制器 接口:串行 電源電壓:3 V ~ 3.6 V 電流 - 電源:135mA 工作溫度:0°C ~ 70°C 安裝類型:表面貼裝 封裝/外殼:36-VFQFN 裸露焊盤 供應商設備封裝:36-QFN（6x6） 包裝:* 其它名稱:Q6396337A
發布緊急采購，3分鐘左右您將得到回復。

采購需求

(若只采購一條型號，填寫一行即可)

發布成功！您可以繼續發布采購。也可以進入我的后臺，查看報價

發布成功！您可以繼續發布采購。也可以進入我的后臺，查看報價

*型號 *數量 廠商 批號 封裝
添加更多采購

我的聯系方式

*
*
*