- 您現在的位置：買賣IC網 > PDF目錄373129 > KFG1G16Q2M-DID (SAMSUNG SEMICONDUCTOR CO. LTD.) FLASH MEMORY PDF資料下載
參數資料
| 型號： | KFG1G16Q2M-DID |
| 廠商： | SAMSUNG SEMICONDUCTOR CO. LTD. |
| 英文描述： | FLASH MEMORY |
| 中文描述： | 閃存 |
| 文件頁數： | 69/125頁 |
| 文件大?。?/td> | 1632K |
| 代理商： | KFG1G16Q2M-DID |
第1頁第2頁第3頁第4頁第5頁第6頁第7頁第8頁第9頁第10頁第11頁第12頁第13頁第14頁第15頁第16頁第17頁第18頁第19頁第20頁第21頁第22頁第23頁第24頁第25頁第26頁第27頁第28頁第29頁第30頁第31頁第32頁第33頁第34頁第35頁第36頁第37頁第38頁第39頁第40頁第41頁第42頁第43頁第44頁第45頁第46頁第47頁第48頁第49頁第50頁第51頁第52頁第53頁第54頁第55頁第56頁第57頁第58頁第59頁第60頁第61頁第62頁第63頁第64頁第65頁第66頁第67頁第68頁當前第69頁第70頁第71頁第72頁第73頁第74頁第75頁第76頁第77頁第78頁第79頁第80頁第81頁第82頁第83頁第84頁第85頁第86頁第87頁第88頁第89頁第90頁第91頁第92頁第93頁第94頁第95頁第96頁第97頁第98頁第99頁第100頁第101頁第102頁第103頁第104頁第105頁第106頁第107頁第108頁第109頁第110頁第111頁第112頁第113頁第114頁第115頁第116頁第117頁第118頁第119頁第120頁第121頁第122頁第123頁第124頁第125頁
OneNAND1G(KFG1G16Q2M-DEB6)
FLASH MEMORY
69
OneNAND2G(KFH2G16Q2M-DEB6)
OneNAND4G(KFW4G16Q2M-DEB6)
The OneNAND can be write-protected to prevent re-programming or erasure of data.
The areas of write-protection are
the BootRAM, and the NAND Flash Array.
3.4.1 BootRAM Write Protection Operation
At system power-up, voltage detector in the device detects the rising edge of Vcc and releases the internal power-up reset signal
which triggers bootcode loading. And the designated size data(1KB) is copied from the first page of the first block in the NAND flash
array to the BootRAM.
After the bootcode loading is completed, the BootRAM is always locked to protect the boot code from the accidental write.
3.4.2 NAND Flash Array Write Protection Operation
The device has both hardware and software write protection of the NAND Flash array.
Hardware Write Protection Operation
The hardware write protection operation is implemented by executing a Cold or Warm Reset. On power up, the NAND Flash Array is
in its default, locked state. The entire NAND Flash array goes to a locked state after a Cold or Warm Reset.
Software Write Protection Operation
The software write protection operation is implemented by writing a Lock command (002Ah) or a Lock-tight command (002Ch) to
command register (F220h).
Lock (002Ah) and Lock-tight (002Ch) commands write protects the block defined in the Start Block Address Register F24Ch.
3.4.3 NAND Array Write Protection States
There are three lock states in the NAND Array: unlocked, locked, and locked-tight.
OneNAND1G supports lock/unlock/lock-tight by
one block
, so each block should be locked/unlocked/locked-tight individually.
Write Protection Status
The current block Write Protection status can be read in NAND Flash Write Protection Status Register(F24Eh). There are three bits -
US, LS, LTS -, which are not cleared by hot reset. These Write Protection status registers are updated when FBA is set, and when
Write Protection command is entered.
The followings summarize locking status.
example)
In default, [2:0] values are 010.
-> If host executes unlock block operation, then [2:0] values turn to 100.
-> If host executes lock-tight block operation, then [2:0] values turn to 001.
3.4 Write Protection Operation
相關PDF資料 |
PDF描述 |
|---|---|
| KFG2816D1M-PID | OneNAND SPECIFICATION |
| KFG2816U1M-DEB | OneNAND SPECIFICATION |
| KFG2816U1M-DED | OneNAND SPECIFICATION |
| KFG2816U1M-DIB | OneNAND SPECIFICATION |
| KFG2816U1M-DID | OneNAND SPECIFICATION |
相關代理商/技術參數 |
參數描述 |
|---|---|
| KFG1G16Q2M-DID5 | 制造商:SAMSUNG 制造商全稱:Samsung semiconductor 功能描述:FLASH MEMORY(54MHz) |
| KFG1G16Q2M-DID6 | 制造商:SAMSUNG 制造商全稱:Samsung semiconductor 功能描述:FLASH MEMORY(54MHz) |
| KFG1G16U2C-AIB6000 | 制造商:Samsung SDI 功能描述:NAND Flash Parallel/Serial 3.3V 1Gbit 64M x 16bit 76ns/70ns 63-Pin FBGA Tray |
| KFG1G16U2D-HIB6000 | 制造商:Samsung SDI 功能描述: |
| KFG1G16U2M-DEB | 制造商:SAMSUNG 制造商全稱:Samsung semiconductor 功能描述:FLASH MEMORY |
發(fā)布緊急采購，3分鐘左右您將得到回復。