- 您現在的位置：買賣IC網 > PDF目錄11591 > KSZ8842-16MBLI (Micrel Inc)IC ETHERNET SW 2PORT 100-LFBGA PDF資料下載
參數資料
| 型號： | KSZ8842-16MBLI |
| 廠商： | Micrel Inc |
| 文件頁數： | 85/141頁 |
| 文件大小： | 0K |
| 描述： | IC ETHERNET SW 2PORT 100-LFBGA |
| 標準包裝： | 260 |
| 控制器類型： | 以太網開關控制器 |
| 接口： | PCI |
| 電源電壓： | 3.1 V ~ 3.5 V |
| 工作溫度： | -40°C ~ 85°C |
| 安裝類型： | 表面貼裝 |
| 封裝/外殼： | 100-LBGA |
| 供應商設備封裝： | 100-LFBGA |
| 包裝： | 托盤 |
| 產品目錄頁面： | 1081 (CN2011-ZH PDF) |
| 其它名稱： | 576-3504 |
第1頁第2頁第3頁第4頁第5頁第6頁第7頁第8頁第9頁第10頁第11頁第12頁第13頁第14頁第15頁第16頁第17頁第18頁第19頁第20頁第21頁第22頁第23頁第24頁第25頁第26頁第27頁第28頁第29頁第30頁第31頁第32頁第33頁第34頁第35頁第36頁第37頁第38頁第39頁第40頁第41頁第42頁第43頁第44頁第45頁第46頁第47頁第48頁第49頁第50頁第51頁第52頁第53頁第54頁第55頁第56頁第57頁第58頁第59頁第60頁第61頁第62頁第63頁第64頁第65頁第66頁第67頁第68頁第69頁第70頁第71頁第72頁第73頁第74頁第75頁第76頁第77頁第78頁第79頁第80頁第81頁第82頁第83頁第84頁當前第85頁第86頁第87頁第88頁第89頁第90頁第91頁第92頁第93頁第94頁第95頁第96頁第97頁第98頁第99頁第100頁第101頁第102頁第103頁第104頁第105頁第106頁第107頁第108頁第109頁第110頁第111頁第112頁第113頁第114頁第115頁第116頁第117頁第118頁第119頁第120頁第121頁第122頁第123頁第124頁第125頁第126頁第127頁第128頁第129頁第130頁第131頁第132頁第133頁第134頁第135頁第136頁第137頁第138頁第139頁第140頁第141頁
Micrel, Inc.
KSZ8842-16/32 MQL/MVL/MVLI/MBL
October 2007
48
M9999-102207-1.9
For egress rate limiting, the Leaky Bucket algorithm is applied to each output priority queue for shaping output traffic. Inter
frame gap is stretched on a per frame base to generate smooth, non-burst egress traffic. The throughput of each output
priority queue is limited by the egress rate specified.
If any egress queue receives more traffic than the specified egress rate throughput, packets may be accumulated in the
output queue and packet memory. After the memory of the queue or the port is used up, packet dropping or flow control
will be triggered. As a result of congestion, the actual egress rate may be dominated by flow control/dropping at the
ingress end, and may be therefore slightly less than the specified egress rate.
To reduce congestion, it is a good practice to make sure the egress bandwidth exceeds the ingress bandwidth.
MAC Filtering Function
Use the static table to assign a dedicated MAC address to a specific port. When a unicast MAC address is not recorded in
the static table, it is also not learned in the dynamic MAC table. The KSZ8842M includes an option that can filter or
forward unicast packets for an unknown MAC address. This option is enabled by SGCR7[7].
The unicast MAC address filtering function is useful in preventing the broadcast of unicast packets that could degrade the
quality of this port in applications such as voice over Internet Protocol (VoIP).
Configuration Interface
The KSZ8842M operates only as a managed switch.
EEPROM Interface
It is optional in the KSZ8842M to use an external EEPROM. In the case that an EEPROM is not used, the EEEN pin must
be tied Low or floating.
The external serial EEPROM with a standard microwire bus interface is used for non-volatile storage of information such
as the host MAC address, base address, and default configuration settings. The KSZ8842M can detect if the EEPROM is
a 1KB (93C46) or 4KB (93C66) EEPROM device (the 93C46 and the 93C66 are typical EEPROM devices). The
EEPROM is organized as 16-bit mode.
If the EEEN pin is pulled high, the KSZ8842M performs an automatic read of the external EEPROM words 0H to 6H after
the de-assertion of Reset. The EEPROM values are placed in certain host-accessible registers. EEPROM read/write
functions can also be performed by software read/writes to the EEPCR registers.
The KSZ8842M EEPROM format is given below.
WORD
15
8
7
0
0H
Base Address
1H
Host MAC Address Byte 2
Host MAC Address Byte 1
2H
Host MAC Address Byte 4
Host MAC Address Byte 3
3H
Host MAC Address Byte 6
Host MAC Address Byte 5
4H
Reserved
5H
Reserved
6H
ConfigParam (see Table 13)
7H-3FH
Not used for KSZ8842M (available for user to use)
Table 12. EEPROM Format
相關PDF資料 |
PDF描述 |
|---|---|
| LTC4259ACGW#PBF | IC CTRLR POE QUAD AC DISC 36SSOP |
| VNC2-64Q1B-REEL | IC USB HOST/DEVICE CTRL 64-QFN |
| V72A48C400BF2 | CONVERTER MOD DC/DC 48V 400W |
| PIC16F1827-E/SO | MCU PIC 8BIT 4K FLASH 18-SOIC |
| PIC16F1826T-I/MV | MCU PIC 8BIT 2K FLASH 28-UQFN |
相關代理商/技術參數 |
參數描述 |
|---|---|
| KSZ8842-16MBLI TR | 功能描述:以太網 IC 2-Port Ethernet Switch + Generic (8, 16-Bit) Bus Interface (I-Temp, Lead Free) RoHS:否 制造商:Micrel 產品:Ethernet Switches 收發器數量:2 數據速率:10 Mb/s, 100 Mb/s 電源電壓-最大:1.25 V, 3.45 V 電源電壓-最小:1.15 V, 3.15 V 最大工作溫度:+ 85 C 封裝 / 箱體:QFN-64 封裝:Tray |
| KSZ8842-16MQL | 功能描述:以太網 IC 2-Port Ethernet Switch/Repeater + Generic (8, 16-bit) bus interface(Lead Free) RoHS:否 制造商:Micrel 產品:Ethernet Switches 收發器數量:2 數據速率:10 Mb/s, 100 Mb/s 電源電壓-最大:1.25 V, 3.45 V 電源電壓-最小:1.15 V, 3.15 V 最大工作溫度:+ 85 C 封裝 / 箱體:QFN-64 封裝:Tray |
| KSZ8842-16MQL-EVAL | 功能描述:以太網開發工具 KSZ8842-16MQL Evaluation Board RoHS:否 制造商:Micrel 產品:Evaluation Boards 類型:Ethernet Transceivers 工具用于評估:KSZ8873RLL 接口類型:RMII 工作電源電壓: |
| KSZ8842-16MVL | 功能描述:以太網 IC 2-Port Ethernet Switch/Repeater + Generic (8, 16-bit) bus interface(Lead Free) RoHS:否 制造商:Micrel 產品:Ethernet Switches 收發器數量:2 數據速率:10 Mb/s, 100 Mb/s 電源電壓-最大:1.25 V, 3.45 V 電源電壓-最小:1.15 V, 3.15 V 最大工作溫度:+ 85 C 封裝 / 箱體:QFN-64 封裝:Tray |
| KSZ8842-16MVL TR | 功能描述:以太網 IC 2-Port Ethernet Switch/Repeater + Generic (8, 16-bit) bus interface(Lead Free) RoHS:否 制造商:Micrel 產品:Ethernet Switches 收發器數量:2 數據速率:10 Mb/s, 100 Mb/s 電源電壓-最大:1.25 V, 3.45 V 電源電壓-最小:1.15 V, 3.15 V 最大工作溫度:+ 85 C 封裝 / 箱體:QFN-64 封裝:Tray |
發布緊急采購，3分鐘左右您將得到回復。