- 您現在的位置：買賣IC網 > PDF目錄367562 > LM2698 PDF資料下載
參數資料
| 型號： | LM2698 |
| 文件頁數： | 5/17頁 |
| 文件大小： | 503K |
| 代理商： | LM2698 |
Electrical Characteristics
(Continued)
Specifications in standard type face are for T
= 25C and those with
boldface type
apply over the full
Operating Tempera-
ture Range
( T
J
= 40C to +125C)Unless otherwise specified. V
IN
=2.2V and I
L
= 0A, unless otherwise specified.
Symbol
Parameter
Conditions
Min
(Note 6)
Typ
(Note 7)
235
Max
(Note 6)
Units
θ
JA
Thermal Resistance
Junction to Ambient
(Note 10)
Junction to Ambient
(Note 11)
Junction to Ambient
(Note 12)
Junction to Ambient
(Note 13)
Junction to Ambient
(Note 14)
C/W
225
220
200
195
Note 1:
Absolute maximum ratings are limits beyond which damage to the device may occur. Operating Ratings are conditions for which the device is intended to
be functional, but device parameter specifications may not be guaranteed. For guaranteed specifications and test conditions, see the Electrical Characteristics.
Note 2:
Shutdown and voltage frequency select should not exceed V
IN
.
Note 3:
The maximum allowable power dissipation is a function of the maximum junction temperature, T
(MAX), the junction-to-ambient thermal resistance,
θ
,
and the ambient temperature, T
. See the Electrical Characteristics table for the thermal resistance of various layouts. The maximum allowable power dissipation
at any ambient temperature is calculated using: P
(MAX) = (T
J(MAX)
T
A
)/
θ
JA
. Exceeding the maximum allowable power dissipation will cause excessive die
temperature, and the regulator will go into thermal shutdown.
Note 4:
The human body model is a 100 pF capacitor discharged through a 1.5k
resistor into each pin. The machine model is a 200pF capacitor discharged
directly into each pin.
Note 5:
ESD susceptibility using the human body model is 500V for V
C
.
Note 6:
All limits guaranteed at room temperature (standard typeface) and at temperature extremes (bold typeface). All room temperature limits are 100% tested
or guaranteed through statistical analysis.All limits at temperature extremes are guaranteed via correlation using standard Statistical Quality Control (SQC) methods.
All limits are used to calculate Average Outgoing Quality Level (AOQL).
Note 7:
Typical numbers are at 25C and represent the most likely norm.
Note 8:
This is the switch current limit at 0% duty cycle. The switch current limit will change as a function of duty cycle. See Typical performance Characteristics
section for I
CL
vs. V
IN
Note 9:
Bias current flows into FB pin.
Note 10:
Junction to ambient thermal resistance (no external heat sink) for the MSO8 package with minimal trace widths (0.010 inches) from the pins to the circuit.
See ’Scenario ’A’’ in the Power Dissipation section.
Note 11:
Junction to ambient thermal resistance for the MSO8 package with minimal trace widths (0.010 inches) from the pins to the circuit and approximately
0.0191 sq. in. of copper heat sinking. See ’Scenario ’B’’ in the Power Dissipation section.
Note 12:
Junction to ambient thermal resistance for the MSO8 package with minimal trace widths (0.010 inches) from the pins to the circuit and approximately
0.0465 sq. in. of copper heat sinking. See ’Scenario ’C’’ in the Power Dissipation section.
Note 13:
Junction to ambient thermal resistance for the MSO8 package with minimal trace widths (0.010 inches) from the pins to the circuit and approximately
0.2523 sq. in. of copper heat sinking. See ’Scenario ’D’’ in the Power Dissipation section.
Note 14:
Junction to ambient thermal resistance for the MSO8 package with minimal trace widths (0.010 inches) from the pins to the circuit and approximately
0.0098 sq. in. of copper heat sinking on the top layer and 0.0760 sq. in. of copper heat sinking on the bottom layer, with three 0.020 in. vias connecting the planes.
See ’Scenario ’E’’ in the Power Dissipation section.
L
www.national.com
5
相關PDF資料 |
PDF描述 |
|---|---|
| LM2698MM-ADJ | SIMPLE SWITCHER 1.35A Boost Regulator |
| LM2902D | Advanced LinCMOS(TM) Low-Noise Chopper-Stabilized Operational Amplifier 8-SOIC |
| LM2902 | Low power quad op amps(低功耗四運算放大器) |
| LM224 | Low power quad op amps(低功耗四運算放大器) |
| LM2902N | LinCMOS(TM) Programmable Low-Power Operational Amplifier 8-SOIC 0 to 70 |
相關代理商/技術參數 |
參數描述 |
|---|---|
| LM2698EVAL | 功能描述:電源管理IC開發工具 EVAL BOARDFOR LM2698 RoHS:否 制造商:Maxim Integrated 產品:Evaluation Kits 類型:Battery Management 工具用于評估:MAX17710GB 輸入電壓: 輸出電壓:1.8 V |
| LM2698MM-ADJ | 功能描述:直流/直流開關轉換器 RoHS:否 制造商:STMicroelectronics 最大輸入電壓:4.5 V 開關頻率:1.5 MHz 輸出電壓:4.6 V 輸出電流:250 mA 輸出端數量:2 最大工作溫度:+ 85 C 安裝風格:SMD/SMT |
| LM2698MM-ADJ/NOPB | 功能描述:直流/直流開關轉換器 1.35A BOOST REG RoHS:否 制造商:STMicroelectronics 最大輸入電壓:4.5 V 開關頻率:1.5 MHz 輸出電壓:4.6 V 輸出電流:250 mA 輸出端數量:2 最大工作溫度:+ 85 C 安裝風格:SMD/SMT |
| LM2698MM-ADJ/NOPB | 制造商:Texas Instruments 功能描述:DC/DC Converter (DC-DC) / Switching Regu |
| LM2698MMX-ADJ | 功能描述:直流/直流開關轉換器 RoHS:否 制造商:STMicroelectronics 最大輸入電壓:4.5 V 開關頻率:1.5 MHz 輸出電壓:4.6 V 輸出電流:250 mA 輸出端數量:2 最大工作溫度:+ 85 C 安裝風格:SMD/SMT |
發布緊急采購，3分鐘左右您將得到回復。