- 您現在的位置：買賣IC網 > Datasheet目錄41 > LT3694IFE-1#TRPBF (Linear Technology)IC REG TRPL BUCK/LINEAR 20TSSOP Datasheet資料下載
參數資料
| 型號： | LT3694IFE-1#TRPBF |
| 廠商： | Linear Technology |
| 文件頁數： | 7/28頁 |
| 文件大小： | 338K |
| 描述： | IC REG TRPL BUCK/LINEAR 20TSSOP |
| 標準包裝： | 2,500 |
| 拓?fù)洌?/td> | 降壓（降壓）（1），線性（LDO）（2） |
| 功能： | 任何功能 |
| 輸出數： | 3 |
| 頻率 - 開關： | 250kHz ~ 2.5MHz |
| 電壓/電流 - 輸出 1： | 0.75 V ~ 16 V，2.6A |
| 電壓/電流 - 輸出 2： | 控制器 |
| 電壓/電流 - 輸出 3： | 控制器 |
| 帶 LED 驅動器： | 無 |
| 帶監控器： | 無 |
| 帶序列發生器： | 是 |
| 電源電壓： | 4 V ~ 36 V |
| 工作溫度： | -40°C ~ 125°C |
| 安裝類型： | 表面貼裝 |
| 封裝/外殼： | 20-TSSOP（0.173"，4.40mm 寬）裸露焊盤 |
| 供應商設備封裝： | 20-TSSOP-EP |
| 包裝： | 帶卷 (TR) |
第1頁第2頁第3頁第4頁第5頁第6頁當前第7頁第8頁第9頁第10頁第11頁第12頁第13頁第14頁第15頁第16頁第17頁第18頁第19頁第20頁第21頁第22頁第23頁第24頁第25頁第26頁第27頁第28頁
LT3694/LT3694-1
7
36941fb
PIN FUNCTIONS
V
IN
(Pin 1/Pins 27, 28): The V
IN
pin supplies power to the
internal switch of the 2.6A regulator and to the LT3694s
internal reference and start-up circuitry. This pin must be
locally bypassed.
EN/UVLO (Pin 2/Pin 1): The EN/UVLO pin is used to shut
down the LT3694. It can be driven from a logic level or
used as an undervoltage lockout by connecting a resistor
divider from V
IN
.
CLKOUT (Pin 3/Pin 2): Digital Clock Output. The CLKOUT
pin allows synchronization of other switching regulators
(LT3694-1 only).
SYNC (Pin 3/Pin 2): Frequency Synchronization Input.
Connect a frequency source to this input if synchronization
is desired. Connect SYNC to ground if not used (LT3694
only).
PGOOD (Pin 4/Pin 3): Open Collector Output. PGOOD is
pulled low when any of the three regulators drops out of
regulation (V
FB
< 90% of nominal value).
RT (Pin 5/Pin 4): The RT pin requires a resistor to ground
to set the operating frequency of the LT3694. If synchroniz-
ing the LT3694 to an external clock, the resistor should
be set to program the frequency at least 20% below the
synchronization frequency.
TRK/SS1, TRK/SS2 , TRK/SS3 (Pins 6, 7, 14/Pins 5, 6, 17):
The TRK/SS pins allow a regulator to track the output of
another regulator. When the TRK/SS pin is below 0.75V,
the FB pin regulates to the TRK/SS voltage. This pin can
also be used as a soft-start by connecting a capacitor from
TRK/SS to ground. The TRK/SS pins should be left open
if neither feature is used.
FB1, FB2, FB3 (Pins 15, 8, 13/Pins 18, 7, 16): Negative
Inputs of the Error Amplifiers. The LT3694 regulates each
feedback pin to the lesser of 0.75V or the corresponding
TRK/SS pin voltage. Connect the feedback resistor divider
taps to these pins.
DRV2, DRV3 (Pins 9, 12/Pins 8, 15): The DRV pins
provide the base drive for the external NPN transistors
for the LDO regulators. The DRV pins can provide up to
6V of base drive.
LIM2, LIM3 (Pins 10, 11/Pins 9, 14): The LIM pins provide
current limiting on the LDO pass transistors by sensing
a voltage on an external sense resistor connected to the
BIAS pin. These pins should be connected to BIAS if this
function is not used.
GND (Pins 10, 11, 12, 13, 25, 26) UFD Package Only:
Power and Signal Ground.
V
C1
(Pin 16/Pin 19): Output of the Internal Error Amp.
The voltage on this pin controls the peak switch cur-
rent. This pin is normally used to compensate the
control loop. The switching regulator can be shut
down by pulling the V
C1
pin to ground with an NMOS
or NPN transistor.
BIAS (Pin 17/Pin 20): The BIAS pin supplies the current
to the LT3694s internal regulator and boost circuits. This
must be connected to a voltage source above 3V, usually
to V
OUT1
. The LDO pass transistor base current will also
come from the BIAS pin if it is at least 1.8V above the
LDO output.
BST (Pin 18/Pin 21): The BST pin is used to provide a
drive voltage, higher than the input voltage, to the internal
bipolar NPN power switch.
DA (Pin 19/Pin 22): The DA pin senses the catch diode
current to prevent excessive inductor current in output
overload or short-circuit conditions.
SW (Pin 20/Pins 23, 24): Output of the Internal Power
Switch. Connect this pin to the inductor and switching
diode.
Exposed Pad (Pin 21/Pin 29): Ground. The underside
exposed pad metal of the package provides both electrical
contact to ground and a conductive thermal path to the
printed circuit board. The Exposed Pad must be soldered to
a grounded pad on the circuit board for proper operation.
(FE/UFD)
相關PDF資料 |
PDF描述 |
|---|---|
| LT4220IGN#TR | IC CTLR HOTSWAP DUAL 16-SSOP |
| LT4250LCN8 | IC CONTRLR HOT SWAP NEG 48V 8DIP |
| LT4254CGN | IC CTRLR HOTSWAP POSVOLT 16SSOP |
| LT4256-1IS8#TRPBF | IC CTRLR HOTSWAP HV LATCH 8SOIC |
| LTC1392IS8#TRPBF | IC DATA ACQ SYSTEM 10BIT 8-SOIC |
相關代理商/技術參數 |
參數描述 |
|---|---|
| LT3694IFEPBF | 制造商:LINER 制造商全稱:Linear Technology 功能描述:36V, 2.6A Monolithic Buck Regulator With Dual LDO |
| LT3694IUFD#PBF | 功能描述:IC REG TRPL BUCK/LINEAR 28QFN RoHS:是 類別:集成電路 (IC) >> PMIC - 穩壓器 - 線性 + 切換式 系列:- 標準包裝:2,500 系列:- 拓?fù)?降壓（降壓）同步（3），線性（LDO）（2） 功能:任何功能 輸出數:5 頻率 - 開關:300kHz 電壓/電流 - 輸出 1:控制器 電壓/電流 - 輸出 2:控制器 電壓/電流 - 輸出 3:控制器 帶 LED 驅動器:無 帶監控器:無 帶序列發生器:是 電源電壓:5.6 V ~ 24 V 工作溫度:-40°C ~ 85°C 安裝類型:* 封裝/外殼:* 供應商設備封裝:* 包裝:* |
| LT3694IUFD#TRPBF | 功能描述:IC REG TRPL BUCK/LINEAR 28QFN RoHS:是 類別:集成電路 (IC) >> PMIC - 穩壓器 - 線性 + 切換式 系列:- 標準包裝:2,500 系列:- 拓?fù)?降壓（降壓）同步（3），線性（LDO）（2） 功能:任何功能 輸出數:5 頻率 - 開關:300kHz 電壓/電流 - 輸出 1:控制器 電壓/電流 - 輸出 2:控制器 電壓/電流 - 輸出 3:控制器 帶 LED 驅動器:無 帶監控器:無 帶序列發生器:是 電源電壓:5.6 V ~ 24 V 工作溫度:-40°C ~ 85°C 安裝類型:* 封裝/外殼:* 供應商設備封裝:* 包裝:* |
| LT3694IUFD-1#PBF | 功能描述:IC REG TRPL BUCK/LINEAR 28QFN RoHS:是 類別:集成電路 (IC) >> PMIC - 穩壓器 - 線性 + 切換式 系列:- 標準包裝:2,500 系列:- 拓?fù)?降壓（降壓）同步（3），線性（LDO）（2） 功能:任何功能 輸出數:5 頻率 - 開關:300kHz 電壓/電流 - 輸出 1:控制器 電壓/電流 - 輸出 2:控制器 電壓/電流 - 輸出 3:控制器 帶 LED 驅動器:無 帶監控器:無 帶序列發生器:是 電源電壓:5.6 V ~ 24 V 工作溫度:-40°C ~ 85°C 安裝類型:* 封裝/外殼:* 供應商設備封裝:* 包裝:* |
| LT3694IUFD-1#TRPBF | 功能描述:IC REG TRPL BUCK/LINEAR 28QFN RoHS:是 類別:集成電路 (IC) >> PMIC - 穩壓器 - 線性 + 切換式 系列:- 標準包裝:2,500 系列:- 拓?fù)?降壓（降壓）同步（3），線性（LDO）（2） 功能:任何功能 輸出數:5 頻率 - 開關:300kHz 電壓/電流 - 輸出 1:控制器 電壓/電流 - 輸出 2:控制器 電壓/電流 - 輸出 3:控制器 帶 LED 驅動器:無 帶監控器:無 帶序列發生器:是 電源電壓:5.6 V ~ 24 V 工作溫度:-40°C ~ 85°C 安裝類型:* 封裝/外殼:* 供應商設備封裝:* 包裝:* |
發布緊急采購，3分鐘左右您將得到回復。