- 您現在的位置：買賣IC網 > PDF目錄10002 > LTC1343IGW (Linear Technology)IC TXRX SOFTWARE-SELECTBL 44SSOP PDF資料下載
參數資料
| 型號： | LTC1343IGW |
| 廠商： | Linear Technology |
| 文件頁數： | 2/28頁 |
| 文件大?。?/td> | 0K |
| 描述： | IC TXRX SOFTWARE-SELECTBL 44SSOP |
| 標準包裝： | 27 |
| 類型： | 收發器 |
| 驅動器/接收器數： | 4/4 |
| 規程： | 多協議 |
| 電源電壓： | 4.75 V ~ 5.25 V |
| 安裝類型： | 表面貼裝 |
| 封裝/外殼： | 44-BSOP（0.295"，7.50mm 寬） |
| 供應商設備封裝： | 44-SSOP |
| 包裝： | 管件 |
第1頁當前第2頁第3頁第4頁第5頁第6頁第7頁第8頁第9頁第10頁第11頁第12頁第13頁第14頁第15頁第16頁第17頁第18頁第19頁第20頁第21頁第22頁第23頁第24頁第25頁第26頁第27頁第28頁
10
LTC1343
APPLICATIONS INFORMATION
WU
U
will configure the port for DCE mode when high, and DTE
when low.
The interface protocol may be selected simply by plugging
the appropriate interface cable into the connector. The
mode pins are routed to the connector and are left uncon-
nected (1) or wired to ground (0) in the cable as shown in
Figure 11.
The pull-up resistors R1 through R4 will ensure a binary
1 when a pin is left unconnected and that the two LTC1343s
and the LTC1344 enter the no-cable mode when the cable
is removed. In the no-cable mode the LTC1343 supply
current drops to less than 200
A and all LTC1343 driver
outputs and LTC1344 resistive terminations are forced
into a high impedance state. Note that the data latch pin,
LATCH, is shorted to ground for all chips.
The interface protocol may also be selected by the serial
controller or host microprocessor as shown in Figure 12.
The mode selection pins M0, M1, M2 and DCE/DTE can be
shared between multiple interface ports, while each port
Figure 11: Single Port DCE/V.35 Mode Selection in the Cable
RL (Remote Loop-back) and RI (Ring Indicate). The
LTC1344 cable termination chip is used only for the clock
and data signals because they must support V.35 cable
termination. The control signals do not need any external
resistors.
Mode Selection
The interface protocol is selected using the mode select
pins M0, M1, M2 and CTRL/CLK (see the Mode Selection
table). The CTRL/CLK pin should be pulled high if the
LTC1343 is being used to generate control signals and
pulled low if used to generate clock and data signals.
For example, if the port is configured as a V.35 interface,
the mode selection pins should be M2 = 1, M1 = 0, M0 = 0.
For the control signals, CTRL/CLK = 1 and the drivers and
receivers will operate in RS232 (V.28) electrical mode. For
the clock and data signals, CTRL/CLK = 0 and the drivers
and receivers will operate in V.35 electrical mode, except
for the single-ended driver and receiver which will operate
in the RS232 (V.28) electrical mode. The DCE/DTE pin
NC
CABLE
1343 F11
17
18
19
21
LTC1343
CONNECTOR
20
21
19
18
17
22
21
M2
M1
LTC1344
LATCH
M0 (DATA)
23
24
1
CTRL/CLK
22
(DATA)
M0
M1
M2
DCE/DTE
LATCH
20
CTRL/CLK
22
DCE/DTE
M2
M1
M0
(DATA)
LATCH
VCC
DCE/
DTE
R1, 10k
VCC
R2, 10k
VCC
R3, 10k
VCC
R4, 10k
VCC
相關PDF資料 |
PDF描述 |
|---|---|
| IDT72V255LA10TF8 | IC FIFO SS 8192X18 10NS 64-STQFP |
| MS27484T20B41PA | CONN PLUG 41POS STRAIGHT W/PINS |
| VI-JWV-MX-S | CONVERTER MOD DC/DC 5.8V 75W |
| IDT72261LA15TFI8 | IC FIFO 8192X18 LP 15NS 64QFP |
| MS27467T17A35SC | CONN PLUG 55POS STRAIGHT W/SCKT |
相關代理商/技術參數 |
參數描述 |
|---|---|
| LTC1343IGW#PBF | 功能描述:IC TXRX SOFTWARE-SELECTBL 44SSOP RoHS:是 類別:集成電路 (IC) >> 接口 - 驅動器，接收器，收發器 系列:- 產品培訓模塊:RS-232 & USB Transceiver 標準包裝:2,000 系列:- 類型:收發器 驅動器/接收器數:1/1 規程:RS232 電源電壓:3 V ~ 5.5 V 安裝類型:表面貼裝 封裝/外殼:16-SSOP（0.209"，5.30mm 寬） 供應商設備封裝:16-SSOP 包裝:帶卷 (TR) 其它名稱:296-19849-2 |
| LTC1343IGW#TR | 功能描述:IC TXRX SOFTWARE SELECT 44SSOP RoHS:否 類別:集成電路 (IC) >> 接口 - 驅動器，接收器，收發器 系列:- 標準包裝:250 系列:- 類型:收發器 驅動器/接收器數:2/2 規程:RS232 電源電壓:3 V ~ 5.5 V 安裝類型:表面貼裝 封裝/外殼:16-TSSOP（0.173"，4.40mm 寬） 供應商設備封裝:16-TSSOP 包裝:帶卷 (TR) |
| LTC1343IGW#TRPBF | 功能描述:IC TXRX SOFTWARE-SELECTBL 44SSOP RoHS:是 類別:集成電路 (IC) >> 接口 - 驅動器，接收器，收發器 系列:- 標準包裝:250 系列:- 類型:收發器 驅動器/接收器數:2/2 規程:RS232 電源電壓:3 V ~ 5.5 V 安裝類型:表面貼裝 封裝/外殼:16-TSSOP（0.173"，4.40mm 寬） 供應商設備封裝:16-TSSOP 包裝:帶卷 (TR) |
| LTC1344ACG | 功能描述:IC CABLE TERM MULTIPROTCL 24SSOP RoHS:否 類別:集成電路 (IC) >> 接口 - 信號終端器 系列:- 產品培訓模塊:Lead (SnPb) Finish for COTS Obsolescence Mitigation Program 標準包裝:50 系列:- 類型:SCSI，SE 端子數:9 電源電壓:4 V ~ 5.25 V 工作溫度:0°C ~ 70°C 安裝類型:表面貼裝 封裝/外殼:16-SOIC（0.154"，3.90mm 寬） 供應商設備封裝:16-SOIC 包裝:管件 |
| LTC1344ACG#PBF | 功能描述:IC CABLE TERM MULTIPROTCL 24SSOP RoHS:是 類別:集成電路 (IC) >> 接口 - 信號終端器 系列:- 產品培訓模塊:Lead (SnPb) Finish for COTS Obsolescence Mitigation Program 標準包裝:50 系列:- 類型:SCSI，SE 端子數:9 電源電壓:4 V ~ 5.25 V 工作溫度:0°C ~ 70°C 安裝類型:表面貼裝 封裝/外殼:16-SOIC（0.154"，3.90mm 寬） 供應商設備封裝:16-SOIC 包裝:管件 |
發布緊急采購，3分鐘左右您將得到回復。