- 您現在的位置：買賣IC網 > PDF目錄2005 > LTC2158IUP-14#TRPBF (Linear Technology)IC ADC DUAL 14BIT 310M 64-QFN PDF資料下載
參數資料
| 型號： | LTC2158IUP-14#TRPBF |
| 廠商： | Linear Technology |
| 文件頁數： | 28/28頁 |
| 文件大小： | 0K |
| 描述： | IC ADC DUAL 14BIT 310M 64-QFN |
| 標準包裝： | 2,000 |
| 位數： | 14 |
| 采樣率（每秒）： | 310M |
| 數據接口： | 并聯，串行，SPI |
| 轉換器數目： | 2 |
| 功率耗散（最大）： | 873mW |
| 電壓電源： | 模擬和數字 |
| 工作溫度： | -40°C ~ 85°C |
| 安裝類型： | 表面貼裝 |
| 封裝/外殼： | 64-WFQFN 裸露焊盤 |
| 供應商設備封裝： | 64-QFN（9x9） |
| 包裝： | 帶卷 (TR) |
| 輸入數目和類型： | 2 個差分 |
| 配用： | DC1371A-ND - BOARD USB DATA ACQUISITION HS |
第1頁第2頁第3頁第4頁第5頁第6頁第7頁第8頁第9頁第10頁第11頁第12頁第13頁第14頁第15頁第16頁第17頁第18頁第19頁第20頁第21頁第22頁第23頁第24頁第25頁第26頁第27頁當前第28頁
9
215814f
LTC2158-14
SDI(Pin60):SerialInterfaceDataInput.Inserialprogram-
ming mode, (PAR/SER = 0V), SDI is the serial interface
data input. Data on SDI is clocked into the mode control
registers on the rising edge of SCK. In the parallel pro-
gramming mode (PAR/SER = VDD), SDI selects 3.5mA or
1.75mA LVDS output current (see Table 2). SDI can be
driven with 1.8V to 3.3V logic.
SCK (Pin 61): Serial Interface Clock Input. In serial
programming mode, (PAR/SER = 0V), SCK is the serial
interface clock input. In the parallel programming mode
(PAR/SER = VDD), SCK can be used to place the part in the
low power sleep mode (see Table 2). SCK can be driven
with 1.8V to 3.3V logic.
CS (Pin 62): Serial Interface Chip Select Input. In serial
programming mode, (PAR/SER = 0V), CS is the serial in-
terface chip select input. When CS is low, SCK is enabled
for shifting data on SDI into the mode control registers.
In the parallel programming mode (PAR/SER = VDD), CS
controls the clock duty cycle stabilizer (see Table 2). CS
can be driven with 1.8V to 3.3V logic.
PAR/SER (Pin 63): Programming Mode Selection Pin.
Connecttogroundtoenabletheserialprogrammingmode
where CS, SCK, SDI, SDO become a serial interface that
control the A/D operating modes. Connect to VDD to en-
able the parallel programming mode where CS, SCK, SDI
become parallel logic inputs that control a reduced set of
the A/D operating modes. PAR/SER should be connected
directly to ground or the VDD of the part and not be driven
by a logic signal.
LVDS Outputs
The following pins are differential LVDS outputs. The
output current level is programmable. There is an optional
internal 100 termination resistor between the pins of
each LVDS output pair.
OF–/OF+ (Pins 22/23): Over/Underflow Digital Output.
OF+ is high when an overflow or underflow has occurred.
The overflows for channel A and channel B are multiplexed
together.
DB0_1–/DB0_1+ to DB12_13–/DB12_13+ (Pins 24/25, 26/27,
28/29, 30/31, 34/35, 36/37, 38/39): Channel B Double
Data Rate Digital Outputs. Two data bits are multiplexed
onto each differential output pair. The even data bits (DB0,
DB2,DB4,DB6,DB8,DB10,DB12)appearwhenCLKOUT+
islow.Theodddatabits(DB1,DB3,DB5,DB7,DB9,DB11,
DB13) appear when CLKOUT+ is high.
CLKOUT–/CLKOUT+ (Pins 40/41): Data Output Clock.
The digital outputs normally transition at the same time
as the falling and rising edges of CLKOUT+. The phase of
CLKOUT+ can also be delayed relative to the digital outputs
by programming the mode control registers.
DA0_1–/DA0_1+ to DA12_13–/DA12_13+ (Pins 42/43, 44/45,
46/47, 50/51, 52/53, 54/55, 56/57): Channel A Double
Data Rate Digital Outputs. Two data bits are multiplexed
onto each differential output pair. The even data bits (DA0,
DA2,DA4,DA6,DA8,DA10,DA12)appearwhenCLKOUT+
islow.Theodddatabits(DA1,DA3,DA5,DA7,DA9,DA11,
DA13) appear when CLKOUT+ is high.
pin FuncTions
相關PDF資料 |
PDF描述 |
|---|---|
| LTC2172IUKG-14#TRPBF | IC ADC 14BIT SER/PAR 65M 52-QFN |
| LTC2175IUKG-14#TRPBF | IC ADC 14BIT 125MSPS QUAD 52QFN |
| LTC2202IUK#TRPBF | IC ADC 16-BIT 10MSPS 48-QFN |
| LTC2205IUK-14#PBF | IC ADC 14BIT 65MSPS 48-QFN |
| LTC2207IUK-14#PBF | IC ADC 14BIT 105MSPS 48-QFN |
相關代理商/技術參數 |
參數描述 |
|---|---|
| LTC2159 | 制造商:LINER 制造商全稱:Linear Technology 功能描述:16-Bit, 20Msps Low Power ADC |
| LTC2159CUK#PBF | 功能描述:IC ADC 16BIT PAR/SRL 20M 48-QFN RoHS:是 類別:集成電路 (IC) >> 數據采集 - 模數轉換器 系列:- 標準包裝:1 系列:- 位數:14 采樣率（每秒）:83k 數據接口:串行，并聯 轉換器數目:1 功率耗散（最大）:95mW 電壓電源:雙 ± 工作溫度:0°C ~ 70°C 安裝類型:通孔 封裝/外殼:28-DIP（0.600"，15.24mm） 供應商設備封裝:28-PDIP 包裝:管件 輸入數目和類型:1 個單端，雙極 |
| LTC2159CUK#TRPBF | 功能描述:IC ADC 16BIT PAR/SRL 20M 48-QFN RoHS:是 類別:集成電路 (IC) >> 數據采集 - 模數轉換器 系列:- 標準包裝:1 系列:- 位數:14 采樣率（每秒）:83k 數據接口:串行，并聯 轉換器數目:1 功率耗散（最大）:95mW 電壓電源:雙 ± 工作溫度:0°C ~ 70°C 安裝類型:通孔 封裝/外殼:28-DIP（0.600"，15.24mm） 供應商設備封裝:28-PDIP 包裝:管件 輸入數目和類型:1 個單端，雙極 |
| LTC2159IUK#PBF | 功能描述:IC ADC 16BIT PAR/SRL 20M 48-QFN RoHS:是 類別:集成電路 (IC) >> 數據采集 - 模數轉換器 系列:- 標準包裝:1 系列:- 位數:14 采樣率（每秒）:83k 數據接口:串行，并聯 轉換器數目:1 功率耗散（最大）:95mW 電壓電源:雙 ± 工作溫度:0°C ~ 70°C 安裝類型:通孔 封裝/外殼:28-DIP（0.600"，15.24mm） 供應商設備封裝:28-PDIP 包裝:管件 輸入數目和類型:1 個單端，雙極 |
| LTC2159IUK#TRPBF | 功能描述:IC ADC 16BIT PAR/SRL 20M 48-QFN RoHS:是 類別:集成電路 (IC) >> 數據采集 - 模數轉換器 系列:- 標準包裝:1 系列:- 位數:14 采樣率（每秒）:83k 數據接口:串行，并聯 轉換器數目:1 功率耗散（最大）:95mW 電壓電源:雙 ± 工作溫度:0°C ~ 70°C 安裝類型:通孔 封裝/外殼:28-DIP（0.600"，15.24mm） 供應商設備封裝:28-PDIP 包裝:管件 輸入數目和類型:1 個單端，雙極 |
發布緊急采購，3分鐘左右您將得到回復。