Under
development
Tentative Specifications REV.A
Specifications in this manual are tentative and subject to change.
Mitsubishi microcomputers
M30218 Group
SINGLE-CHIP 16-BIT CMOS MICROCOMPUTER
122
A-D converter
Item
Specification
Function
All pins perform repeat sweep A-D conversion, with emphasis on the pin or
pins selected by the A-D sweep pin select bit
Example : AN0 selected -> AN0 -> AN1 -> AN0 -> AN2 -> AN0 -> AN3, etc
Start condition
Writing “1” to A-D conversion start flag
Stop condition
Writing “0” to A-D conversion start flag
Interrupt request generation timing None generated
Input pin
Emphasis on the pin
AN0 (1 pin), AN0 and AN1 (2 pins), AN0 to AN2 (3 pins), AN0 to AN3 (4 pins)
Reading of result of A-D converter Read A-D register corresponding to selected pin (at any time)
(5) Repeat sweep mode 1
In repeat sweep mode 1, all pins are used for A-D conversion with emphasis on the pin or pins selected
using the A-D sweep pin select bit. Table JA-6 shows the specifications of repeat sweep mode 1. Figure
JA-8 shows the A-D control register in repeat sweep mode 1.
Table JA-6. Repeat sweep mode 1 specifications
Figure JA-8. A-D conversion register in repeat sweep mode 1
A-D control register 0 (Note)
Symbol
Address
When reset
ADCON0
03D616
00000XXX2
Bit name
Function
Bit symbol
b7
b6
b5
b4
b3
b2
b1
b0
Analog input pin select bit
CH0
CH1
CH2
A-D operation mode
select bit 0
1 1 : Repeat sweep mode 1
MD0
MD1
ADST
A-D conversion start flag
0 : A-D conversion disabled
1 : A-D conversion started
Frequency select bit 0
0 : fAD/4 is selected
1 : fAD/2 is selected
CKS0
W
R
A-D control register 1 (Note)
Symbol
Address
When reset
ADCON1
03D716
0016
Bit name
Function
Bit symbol
b7
b6
b5
b4
b3
b2
b1
b0
A-D sweep pin select bit
SCAN0
SCAN1
MD2
BITS
8/10-bit mode select bit
0 : 8-bit mode
1 : 10-bit mode
VCUT
Vref connect bit
1 : Repeat sweep mode 1
A-D operation mode
select bit 1
1 : Vref connected
W
R
1 1
Invalid in repeat sweep mode 0
Note: If the A-D control register is rewritten during A-D conversion, the conversion result
is indeterminate.
b4 b3
When repeat sweep mode 1 is selected
0 0 : AN0 (1 pins)
0 1 : AN0, AN1 (2 pins)
1 0 : AN0 to AN2 (3 pins)
1 1 : AN0 to AN3 (4 pins)
b1 b0
1
Note: If the A-D control register is rewritten during A-D conversion, the conversion result
is indeterminate.
Frequency select bit 1
0 : fAD/2 or fAD/4 is selected
1 : fAD is selected
CKS1
Must always be “0”.
0