- 您現在的位置：買賣IC網 > PDF目錄45024 > M30845FJGP 32-BIT, FLASH, 32 MHz, MICROCONTROLLER, PQFP144 PDF資料下載
參數資料
| 型號： | M30845FJGP |
| 元件分類： | 微控制器/微處理器 |
| 英文描述： | 32-BIT, FLASH, 32 MHz, MICROCONTROLLER, PQFP144 |
| 封裝： | 20 X 20 MM, 0.50 MM PITCH, PLASTIC, LQFP-144 |
| 文件頁數： | 41/91頁 |
| 文件大?。?/td> | 903K |
| 代理商： | M30845FJGP |
第1頁第2頁第3頁第4頁第5頁第6頁第7頁第8頁第9頁第10頁第11頁第12頁第13頁第14頁第15頁第16頁第17頁第18頁第19頁第20頁第21頁第22頁第23頁第24頁第25頁第26頁第27頁第28頁第29頁第30頁第31頁第32頁第33頁第34頁第35頁第36頁第37頁第38頁第39頁第40頁當前第41頁第42頁第43頁第44頁第45頁第46頁第47頁第48頁第49頁第50頁第51頁第52頁第53頁第54頁第55頁第56頁第57頁第58頁第59頁第60頁第61頁第62頁第63頁第64頁第65頁第66頁第67頁第68頁第69頁第70頁第71頁第72頁第73頁第74頁第75頁第76頁第77頁第78頁第79頁第80頁第81頁第82頁第83頁第84頁第85頁第86頁第87頁第88頁第89頁第90頁第91頁
45
38C2 Group
SINGLE-CHIP 8-BIT CMOS MICROCOMPUTER
MITSUBISHI MICROCOMPUTERS
PRELIMINAR
Y
Notice:
This
is not
a final
specification.
Some
parametric
limits
are
subject
to change.
WATCHDOG TIMER
The watchdog timer gives a mean of returning to the reset status
when a program cannot run on a normal loop (for example, because
of a software run-away). The watchdog timer consists of an 8-bit
counter.
Initial Value of Watchdog Timer
At reset or writing to the watchdog timer control register, each watch-
dog timer is set to “FF16.” Instructions such as STA, LDM and CLB to
generate the write signals can be used.
The written data in bits 0 to 5 are not valid, and the above values are
set.
Standard Operation of Watchdog Timer
The watchdog timer is in the stop state at reset and the watchdog
timer starts to count down by writing an optional value in the watch-
dog timer control register. An internal reset occurs at an underflow of
the watchdog timer. Then, reset is released after the reset release
time is elapsed, the program starts from the reset vector address.
Normally, writing to the watchdog timer control register before an
underflow of the watchdog timer is programmed. If writing to the watch-
dog control register is not executed, the watchdog timer does not
operate.
Fig. 44 Timing diagram of reset output
When reading the watchdog timer control register is executed, the
contents of the high-order 6-bit counter and the STP instruction dis-
able bit (bit 6), and the count source selection bit (bit 7) are read out.
When the STP instruction disable bit is “0”, the STP instruction is
valid. The STP instruction is disabled by writing to “1” to this bit. In
this time, when the STP instruction is executed, it is handled as the
undefined instruction, the internal reset occurs. This bit cannot be
cleared to “0” by program. This bit is “0” after reset.
The time until the underflow of the watchdog timer control register
after writing to the watchdog timer control register is executed is as
follows (when the bit 7 of the watchdog timer control register is “0”) ;
at frequency/2/4/8 mode (f(XIN)) = 8 MHz): 32.768 ms
at low-speed mode (f(XCIN) = 32 KHz): 8.19s
s Note
The watchdog timer continues to count even during the wait time set
by timer 1 and timer 2 to release the stop state and in the wait mode.
Accordingly, do not underflow the watchdog timer in this time.
Fig. 42 Block diagram of Watchdog timer
Fig. 43 Structure of Watchdog timer control register
b0
STP instruction disable bit
0: STP instruction enabled
1: STP instruction disabled
Watchdog timer count source selection bit
0: 1/1024 of system clock
1: 1/4 of system clock
Watchdog timer H (for read-out of high-order 6 bit)
“FF16” is set to watchdog timer by writing to these bits.
Watchdog timer control register
(WDTCON : address 003716)
b7
Internal reset
signal
Watchdog timer detected
≈ 32msec (at f(XIN)=8MHZ)
f(XIN)
XIN
XCIN
System clock control
bit (bit 6)
1/1024
Undefined instruction
Reset
RESET
Wait until reset release
1/4
Data bus
Watchdog timer H
count source
selection bit
Reset
circuit
STP instruction disable bit
Watchdog timer
H (6)
Internal reset
STP instruction
Watchdog timer
L (2)
“FF16” is set when
watchdog timer
control register is
written to.
“0”
“1”
“0”
“1”
相關PDF資料 |
PDF描述 |
|---|---|
| M30843FHGP | 32-BIT, FLASH, 32 MHz, MICROCONTROLLER, PQFP100 |
| M30845FHGP | 32-BIT, FLASH, 32 MHz, MICROCONTROLLER, PQFP144 |
| M30843FWTGP | 32-BIT, FLASH, 32 MHz, MICROCONTROLLER, PQFP100 |
| M30842MC-XXXGP | 32-BIT, MROM, 32 MHz, MICROCONTROLLER, PQFP144 |
| M30843FJGP | 32-BIT, FLASH, 32 MHz, MICROCONTROLLER, PQFP100 |
相關代理商/技術參數 |
參數描述 |
|---|---|
| M30845FJGP D3 | 制造商:Renesas Electronics Corporation 功能描述: |
| M30845FJGP D5 | 制造商:Renesas Electronics Corporation 功能描述: |
| M30845FJGP#U3 | 功能描述:IC M32C MCU FLASH 512K 144LQFP RoHS:是 類別:集成電路 (IC) >> 嵌入式 - 微控制器， 系列:M16C™ M32C/80/84 標準包裝:160 系列:S08 核心處理器:S08 芯體尺寸:8-位 速度:40MHz 連通性:I²C，LIN，SCI，SPI 外圍設備:LCD，LVD，POR，PWM，WDT 輸入/輸出數:53 程序存儲器容量:32KB（32K x 8） 程序存儲器類型:閃存 EEPROM 大小:- RAM 容量:1.9K x 8 電壓 - 電源 (Vcc/Vdd):2.7 V ~ 5.5 V 數據轉換器:A/D 12x12b 振蕩器型:內部 工作溫度:-40°C ~ 105°C 封裝/外殼:64-LQFP 包裝:托盤 |
| M30845FJGP#U5 | 功能描述:IC M32C MCU FLASH 512K 144LQFP RoHS:是 類別:集成電路 (IC) >> 嵌入式 - 微控制器， 系列:M16C™ M32C/80/84 標準包裝:96 系列:PIC® 16F 核心處理器:PIC 芯體尺寸:8-位 速度:20MHz 連通性:I²C，SPI 外圍設備:欠壓檢測/復位，POR，PWM，WDT 輸入/輸出數:11 程序存儲器容量:3.5KB（2K x 14） 程序存儲器類型:閃存 EEPROM 大小:- RAM 容量:128 x 8 電壓 - 電源 (Vcc/Vdd):2.3 V ~ 5.5 V 數據轉換器:A/D 8x10b 振蕩器型:內部 工作溫度:-40°C ~ 125°C 封裝/外殼:14-TSSOP（0.173"，4.40mm 寬） 包裝:管件 |
| M30845FJTGP | 制造商:RENESAS 制造商全稱:Renesas Technology Corp 功能描述:SINGLE-CHIP 16/32-BIT CMOS MICROCOMPUTER |
發布緊急采購，3分鐘左右您將得到回復。