- 您現在的位置：買賣IC網 > PDF目錄45037 > M37754M8C-XXXHP 16-BIT, MROM, 40 MHz, MICROCONTROLLER, PQFP100 PDF資料下載
參數資料
| 型號： | M37754M8C-XXXHP |
| 元件分類： | 微控制器/微處理器 |
| 英文描述： | 16-BIT, MROM, 40 MHz, MICROCONTROLLER, PQFP100 |
| 封裝： | 0.50 MM PITCH, FINE PITCH, PLASTIC, QFP-100 |
| 文件頁數： | 73/114頁 |
| 文件大?。?/td> | 1116K |
| 代理商： | M37754M8C-XXXHP |
第1頁第2頁第3頁第4頁第5頁第6頁第7頁第8頁第9頁第10頁第11頁第12頁第13頁第14頁第15頁第16頁第17頁第18頁第19頁第20頁第21頁第22頁第23頁第24頁第25頁第26頁第27頁第28頁第29頁第30頁第31頁第32頁第33頁第34頁第35頁第36頁第37頁第38頁第39頁第40頁第41頁第42頁第43頁第44頁第45頁第46頁第47頁第48頁第49頁第50頁第51頁第52頁第53頁第54頁第55頁第56頁第57頁第58頁第59頁第60頁第61頁第62頁第63頁第64頁第65頁第66頁第67頁第68頁第69頁第70頁第71頁第72頁當前第73頁第74頁第75頁第76頁第77頁第78頁第79頁第80頁第81頁第82頁第83頁第84頁第85頁第86頁第87頁第88頁第89頁第90頁第91頁第92頁第93頁第94頁第95頁第96頁第97頁第98頁第99頁第100頁第101頁第102頁第103頁第104頁第105頁第106頁第107頁第108頁第109頁第110頁第111頁第112頁第113頁第114頁
61
PRELIMINAR
Y
Notice:
This
is not
a final
specification.
Some
parametric
limits
are
subject
to change.
MITSUBISHI MICROCOMPUTERS
M37754M8C-XXXGP, M37754M8C-XXXHP
M37754S4CGP, M37754S4CHP
SINGLE-CHIP 16-BIT CMOS MICROCOMPUTER
WATCHDOG TIMER
The watchdog timer is used to detect unexpected execution se-
quence caused by software runaway and others. Figure 74 shows
the block diagram of the watchdog timer.
The watchdog timer consists of a 12-bit binary counter.
The watchdog timer counts clock Wf32/Pf32, which is obtained by di-
viding the peripheral devices’ clock Pf2 by 16; or clock Wf512/Pf512,
which is obtained by doing it by 256. The watchdog timer frequency
select register shown in Figure 75 selects which clock is counted.
Wf512/Pf512 is selected when its contents are “0”, and Wf32/Pf32 is
selected when they are “1”. They are cleared to “0” after reset.
The watchdog timer clock select bit (bit 3 of particular function select
register 1; Figure 62) selects use of clock Wf512/Wf32 or Pf512/Pf32
as the clock source of watchdog timer. When selecting Wf512/Wf32,
the clock source of watchdog timer (Wf512/Wf32) is not active during
Hold state. When selecting Pf512/Pf32, the clock source of watchdog
timer (Pf512/Pf32) is active during Hold state, however, current con-
sumption can be reduced. It is because the Wf512/Wf32 division cir-
cuit stops.
FFF16 is set in the watchdog timer when “L” or 2Vcc is applied to the
______
RESET pin, STP instruction is executed, data is written to the watch-
dog timer, or the most significant bit of the watchdog timer becomes
“0”.
After FFF16 is set in the watchdog timer, when the watchdog timer
counts the clock source by 2048 counts, the most significant bit of
watchdog timer becomes “0”, the watchdog timer interrupt request
bit is set to “1”, and FFF16 is set again in the watchdog timer.
Normally, a program is written so that data is written in the watchdog
timer before the most significant bit of the watchdog timer becomes
“0”. If this routine is not executed owing to unexpected program ex-
ecution and others, the most significant bit of the watchdog timer
becomes “0” and an interrupt is generated.
The microcomputer can be reset by writing “1” to bit 3 (software re-
set bit) of processor mode register 0 in the interrupt routine, de-
scribed in Figure 16 in the interrupt section, and generating a reset
pulse.
______
The watchdog timer stops its function when the RESET pin voltage
is raised to double the Vcc voltage.
The watchdog timer can also be used to return from when the clock
is stopped by the STP instruction. Refer to the section on the clock
generating circuit for more details.
The watchdog timer also becomes Hold state during Hold state and
the clock input to it is stopped.
Watchdog timer frequency select register
Watchdog timer clock select bit
Write to watchdog timer
STP instruction
S
R
Q
2Vcc
detection
Wachdog timer
Set FFF16
RESET
1/16
Wf32
Wf512
Clock source for peripheral
devices
1/8
1/2
1/8
Pf32
Pf512
Pf16
Hold request
Address 6016
Pf16
STP return select bit
Fig. 74 Watchdog timer block diagram
76543210
Watchdog timer frequency
select register
0 : W f512 or Pf512 selected
1 : W f32 or Pf32 selected
This bit must be fixed to “0.”
6543210
0
Address
6116
Fig. 75 Watchdog timer frequency select register bit configuration
Pf2
相關PDF資料 |
PDF描述 |
|---|---|
| M37754S4CHP | 16-BIT, 40 MHz, MICROCONTROLLER, PQFP100 |
| M37754S4CHP | 16-BIT, 40 MHz, MICROCONTROLLER, PQFP100 |
| M37754M8C-XXXGP | 16-BIT, MROM, 40 MHz, MICROCONTROLLER, PQFP100 |
| M37777E9AGS | 16-BIT, UVPROM, 16 MHz, MICROCONTROLLER, CQCC100 |
| M34550M6A-XXXFP | 4-BIT, MROM, 1.6 MHz, MICROCONTROLLER, PQFP80 |
相關代理商/技術參數 |
參數描述 |
|---|---|
| M37754S4CGP | 制造商:MITSUBISHI 制造商全稱:Mitsubishi Electric Semiconductor 功能描述:SINGLE-CHIP 16BIT CMOS MICROCOMPUTER |
| M37754S4CHP | 制造商:RENESAS 制造商全稱:Renesas Technology Corp 功能描述:SINGLE-CHIP 16-BIT CMOS MICROCOMPUTER |
| M3775PR-H400CL | 制造商:Bonitron 功能描述:OVERVOLTAGE BRAKING RESISTOR |
| M3775RK-0.75A | 制造商:Bonitron 功能描述:OVERVOLTAGE BRAKING RESISTOR |
| M3775RK-C0.50A | 制造商:Bonitron 功能描述:OVERVOLTAGE BRAKING RESISTOR |
發布緊急采購，3分鐘左右您將得到回復。