- 您現在的位置：買賣IC網 > PDF目錄229297 > M93C06-WDS7 (STMICROELECTRONICS) 16 X 16 MICROWIRE BUS SERIAL EEPROM, PDSO8 PDF資料下載
參數資料
| 型號： | M93C06-WDS7 |
| 廠商： | STMICROELECTRONICS |
| 元件分類： | PROM |
| 英文描述： | 16 X 16 MICROWIRE BUS SERIAL EEPROM, PDSO8 |
| 封裝： | 3 X 3 MM, TSSOP-8 |
| 文件頁數： | 26/31頁 |
| 文件大小： | 533K |
| 代理商： | M93C06-WDS7 |
第1頁第2頁第3頁第4頁第5頁第6頁第7頁第8頁第9頁第10頁第11頁第12頁第13頁第14頁第15頁第16頁第17頁第18頁第19頁第20頁第21頁第22頁第23頁第24頁第25頁當前第26頁第27頁第28頁第29頁第30頁第31頁
M93C86, M93C76, M93C66, M93C56, M93C46, M93C06
4/31
SUMMARY DESCRIPTION
These electrically erasable programmable memo-
ry (EEPROM) devices are accessed through a Se-
rial Data Input (D) and Serial Data Output (Q)
using the MICROWIRE bus protocol.
Figure 2. Logic Diagram
Table 1. Signal Names
The memory array organization may be divided
into either bytes (x8) or words (x16) which may be
selected by a signal applied on Organization Se-
lect (ORG). The bit, byte and word sizes of the
memories are as shown in Table 2..
Table 2. Memory Size versus Organization
Note: 1. Not for New Design
The M93Cx6 is accessed by a set of instructions,
as summarized in Table 3., and in more detail in
Table 3. Instruction Set for the M93Cx6
A Read Data from Memory (READ) instruction
loads the address of the first byte or word to be
read in an internal address register. The data at
this address is then clocked out serially. The ad-
the data is output and, if Chip Select Input (S) is
held High, the M93Cx6 can output a sequential
stream of data bytes or words. In this way, the
memory can be read as a data stream from eight
to 16384 bits long (in the case of the M93C86), or
continuously (the address counter automatically
rolls over to 00h when the highest address is
reached).
Programming is internally self-timed (the external
clock signal on Serial Clock (C) may be stopped or
left running after the start of a Write cycle) and
does not require an Erase cycle prior to the Write
instruction. The Write instruction writes 8 or 16 bits
at a time into one of the byte or word locations of
the M93Cx6. After the start of the programming cy-
S
Chip Select Input
D
Serial Data Input
Q
Serial Data Output
C
Serial Clock
ORG
Organisation Select
VCC
Supply Voltage
VSS
Ground
AI01928
D
VCC
M93Cx6
VSS
C
Q
S
ORG
Device
Number
of Bits
Number
of 8-bit
Bytes
Number
of 16-bit
Words
M93C86
16384
2048
1024
M93C76
8192
1024
512
M93C66
4096
512
256
M93C56
2048
256
128
M93C46
1024
128
64
M93C061
256
32
16
Instruction
Description
Data
READ
Read Data from Memory
Byte or Word
WRITE
Write Data to Memory
Byte or Word
EWEN
Erase/Write Enable
EWDS
Erase/Write Disable
ERASE
Erase Byte or Word
Byte or Word
ERAL
Erase All Memory
WRAL
Write All Memory
with same Data
相關PDF資料 |
PDF描述 |
|---|---|
| MT2VDDT832UY-75XX | 8M X 32 DDR DRAM MODULE, 0.75 ns, DMA100 |
| MB84VD22183EA-85PBS | SPECIALTY MEMORY CIRCUIT, PBGA71 |
| MB84VD22184EA-90PBS | SPECIALTY MEMORY CIRCUIT, PBGA71 |
| M93C66-WMB3TP | 256 X 16 MICROWIRE BUS SERIAL EEPROM, DSO8 |
| MT48LC4M16A2P-75:G | 4M X 16 SYNCHRONOUS DRAM, 5.4 ns, PDSO54 |
相關代理商/技術參數 |
參數描述 |
|---|---|
| M93C06-WMN6 | 功能描述:電可擦除可編程只讀存儲器 256 (32x8 or 16x16) RoHS:否 制造商:Atmel 存儲容量:2 Kbit 組織:256 B x 8 數據保留:100 yr 最大時鐘頻率:1000 KHz 最大工作電流:6 uA 工作電源電壓:1.7 V to 5.5 V 最大工作溫度:+ 85 C 安裝風格:SMD/SMT 封裝 / 箱體:SOIC-8 |
| M93C06-WMN6T | 功能描述:電可擦除可編程只讀存儲器 256 (32x8 or 16x16) RoHS:否 制造商:Atmel 存儲容量:2 Kbit 組織:256 B x 8 數據保留:100 yr 最大時鐘頻率:1000 KHz 最大工作電流:6 uA 工作電源電壓:1.7 V to 5.5 V 最大工作溫度:+ 85 C 安裝風格:SMD/SMT 封裝 / 箱體:SOIC-8 |
| M93C46 | 制造商:STMICROELECTRONICS 制造商全稱:STMicroelectronics 功能描述:16Kbit, 8Kbit, 4Kbit, 2Kbit, 1Kbit and 256bit 8-bit or 16-bit wide |
| M93C46_11 | 制造商:STMICROELECTRONICS 制造商全稱:STMicroelectronics 功能描述:16 Kbit, 8 Kbit, 4 Kbit, 2 Kbit and 1 Kbit (8-bit or 16-bit wide) MICROWIRE?? serial access EEPROM |
| M93C46-ATMN6 | 功能描述:電可擦除可編程只讀存儲器 1K (64x8 or 32x16) RoHS:否 制造商:Atmel 存儲容量:2 Kbit 組織:256 B x 8 數據保留:100 yr 最大時鐘頻率:1000 KHz 最大工作電流:6 uA 工作電源電壓:1.7 V to 5.5 V 最大工作溫度:+ 85 C 安裝風格:SMD/SMT 封裝 / 箱體:SOIC-8 |
發布緊急采購，3分鐘左右您將得到回復。