- 您現在的位置：買賣IC網 > PDF目錄2011 > MAX5725AAUP+T (Maxim Integrated Products)IC DAC 12BIT SRL 20TSSOP PDF資料下載
參數資料
| 型號： | MAX5725AAUP+T |
| 廠商： | Maxim Integrated Products |
| 文件頁數： | 19/35頁 |
| 文件大?。?/td> | 0K |
| 描述： | IC DAC 12BIT SRL 20TSSOP |
| 標準包裝： | 2,500 |
| 設置時間： | 4.5µs |
| 位數： | 12 |
| 數據接口： | DSP，MICROWIRE?，QSPI?，串行，SPI? |
| 轉換器數目： | 1 |
| 電壓電源： | 模擬和數字 |
| 功率耗散（最大）： | 1.08W |
| 工作溫度： | -40°C ~ 125°C |
| 安裝類型： | 表面貼裝 |
| 封裝/外殼： | 20-TSSOP（0.173"，4.40mm 寬） |
| 供應商設備封裝： | 20-TSSOP |
| 包裝： | 帶卷 (TR) |
| 輸出數目和類型： | 8 電流，單極 |
第1頁第2頁第3頁第4頁第5頁第6頁第7頁第8頁第9頁第10頁第11頁第12頁第13頁第14頁第15頁第16頁第17頁第18頁當前第19頁第20頁第21頁第22頁第23頁第24頁第25頁第26頁第27頁第28頁第29頁第30頁第31頁第32頁第33頁第34頁第35頁
MAX5723/MAX5724/MAX5725
Ultra-Small, Octal-Channel, 8-/10-/12-Bit Buffered
Output DACs with Internal Reference and SPI Interface
26
Maxim Integrated
POWER Command
The POWER command (B[23:20] = 0100) updates the
power mode settings of the selected DACs. DACs that
are not selected do not update their power settings in
response to the command. The new power setting is
determined by bits PD[1:0] (B[7:6]) while the affected
DAC(s) are selected using B[15:8]). If all DACs are pow-
ered down and the RF2 bit is not set, the device enters
a STANDBY mode (all analog circuitry is disabled). This
command is inaccessible when a watchdog timeout has
occurred and the watchdog timer is configured with a
safety level of high or max.
Available power modes (PD[1:0]):
Normal (00): DAC channel is active (default).
PD 1kω (01): Power down with 1kω termination to GND.
PD 100kω (10): Power down with 100kω termination to
GND.
PD Hi-Z (11): Power down with high-impedance output.
CONFIG Command
The CONFIG command (B[23:16] = 0101) updates the
watchdog, gate, load, and clear mode settings of the
selected DACs. DACs which are not selected do not
update their settings in response to the command. The
new mode settings to be written are determined by bits
B[7:3] while the affected DAC(s) are selected by B[15:8].
This command is inaccessible when a watchdog timeout
has occurred and the watchdog timer is configured with
a safety level of high or max.
Watchdog Configuration:
WDOG Config settings are written by WC[1:0] (B[7:6]):
DISABLE (WC = 00): Watchdog timeout does not affect
the operation of the selected DAC.
GATE (WC = 01): DAC code is gated to DEFAULT value
in response to watchdog timeouts. Unless otherwise
prohibited by the watchdog safety level, LDAC, CLR,
and write operations to the CODE and DAC registers are
accepted but will not be reflected on the DAC output until
the watchdog timeout status is reset.
CLR (WC = 10): CODE and DAC register contents are
cleared to DEFAULT value in response to watchdog time-
outs. All writes to CODE and DAC registers are ignored
and LDAC or CLR input activity has no effect until the
watchdog timeout status is reset, regardless of watchdog
safety level.
HOLD (WC = 11): DAC code is held at its previously
programmed value in response to watchdog timeout.
All writes to DAC and CODE registers are ignored and
LDAC or CLR input activity has no effect until the watch-
dog timeout status is reset, regardless of watchdog
safety level.
Note: For the watchdog to timeout and have an impact,
the function must first be enabled and configured using
the WDOG command.
Table 7. POWER Command Format
B23 B22 B21 B20 B19 B18 B17 B16 B15 B14 B13 B12 B11 B10 B9 B8 B7
B6 B5 B4 B3 B2 B1 B0
0
1
0
7
6
5
4
3
2
1
0
PD1 PD0 X
X
POWER Command
Reserved
Multiple DAC Selection
Power
Mode:
00 =
Normal
01 = 1k
W
10 =
100k
W
11 = Hi-Z
Don’t Care
Default Value
→
1
0
X
Command Byte
Data High Byte
Data Low Byte
相關PDF資料 |
PDF描述 |
|---|---|
| MAX5735BUTN+ | IC DAC 16BIT 32CHAN SER 56-TQFN |
| MAX5741AUB+T | IC DAC 10BIT QUAD LP SER 10-UMAX |
| MAX5754UTN+ | IC DAC 14BIT 32CHAN SER 56-TQFN |
| MAX5774UCB+D | IC DAC 14BIT 32CHAN SER 64-TQFP |
| MAX5811PEUT+T | IC DAC SERIAL 10BIT 1CH SOT23-6 |
相關代理商/技術參數 |
參數描述 |
|---|---|
| MAX5725AEVKIT# | 功能描述:數據轉換 IC 開發工具 MAX5725 Eval Kit RoHS:否 制造商:Texas Instruments 產品:Demonstration Kits 類型:ADC 工具用于評估:ADS130E08 接口類型:SPI 工作電源電壓:- 6 V to + 6 V |
| MAX5725AWP+T | 功能描述:數模轉換器- DAC 8Ch 12Bit Buffered Output DAC RoHS:否 制造商:Texas Instruments 轉換器數量:1 DAC 輸出端數量:1 轉換速率:2 MSPs 分辨率:16 bit 接口類型:QSPI, SPI, Serial (3-Wire, Microwire) 穩定時間:1 us 最大工作溫度:+ 85 C 安裝風格:SMD/SMT 封裝 / 箱體:SOIC-14 封裝:Tube |
| MAX5725BAUP+ | 功能描述:數模轉換器- DAC MAX5725BAUP+ RoHS:否 制造商:Maxim Integrated 轉換器數量: DAC 輸出端數量: 轉換速率: 分辨率: 接口類型: 穩定時間: 最大工作溫度: 安裝風格: 封裝 / 箱體: 封裝:Tube |
| MAX5725BAUP+T | 制造商:Maxim Integrated Products 功能描述:ULTRA-SMALL, OCTAL-CHANNEL, 8-/10-/12-BIT BUFFERED OUTPUT DA - Tape and Reel 制造商:Maxim Integrated Products 功能描述:IC DAC 12BIT SPI/SRL 8CH 20TSSOP 制造商:Maxim Integrated Products 功能描述:Digital to Analog Converters - DAC MAX5725BAUP+T |
| MAX5725EVKIT# | 制造商:Maxim Integrated Products 功能描述:EV KIT FOR MAX5725 12B 8 CHANNEL DAC WITH SPI INTERFACE - Boxed Product (Development Kits) |
發布緊急采購，3分鐘左右您將得到回復。