- 您現在的位置：買賣IC網 > PDF目錄11560 > MAX5945EAX+T (Maxim Integrated Products)IC NETWORK PWR CTRL 36-SSOP PDF資料下載
參數資料
| 型號： | MAX5945EAX+T |
| 廠商： | Maxim Integrated Products |
| 文件頁數： | 9/44頁 |
| 文件大?。?/td> | 0K |
| 描述： | IC NETWORK PWR CTRL 36-SSOP |
| 產品培訓模塊： | Lead (SnPb) Finish for COTS Obsolescence Mitigation Program |
| 標準包裝： | 1,000 |
| 控制器類型： | 網絡電源控制器 |
| 接口： | I²C |
| 電源電壓： | 3.3V |
| 電流 - 電源： | 4.2mA |
| 工作溫度： | -40°C ~ 85°C |
| 安裝類型： | 表面貼裝 |
| 封裝/外殼： | 36-BSOP（0.295"，7.50mm 寬） |
| 供應商設備封裝： | 36-SSOP |
| 包裝： | 帶卷 (TR) |
第1頁第2頁第3頁第4頁第5頁第6頁第7頁第8頁當前第9頁第10頁第11頁第12頁第13頁第14頁第15頁第16頁第17頁第18頁第19頁第20頁第21頁第22頁第23頁第24頁第25頁第26頁第27頁第28頁第29頁第30頁第31頁第32頁第33頁第34頁第35頁第36頁第37頁第38頁第39頁第40頁第41頁第42頁第43頁第44頁
MOSFET Gate Driver
Connect the gate of the external n-channel MOSFET to
GATE_. An internal 50A current source pulls GATE_ to
(VEE + 10V) to turn on the MOSFET. An internal 40A
current source pulls down GATE_ to VEE to turn off the
MOSFET.
The pullup and pulldown current controls the maximum
slew rate at the output during turn-on or turn-off. The
pullup current (gate-charging current) is programmable
using R23h[5-7]. Use the following equation to set the
maximum slew rate:
where CGD is the total capacitance between GATE and
DRAIN of the external FET. Current limit and the capac-
itive load at the drain control the slew rate during start-
up. During current-limit regulation, the MAX5945
manipulates the GATE_ voltage to control the voltage at
SENSE_. A fast pulldown activates if SENSE_ over-
shoots the limit threshold. The fast pulldown current
increases with the amount of overshoot. The maximum
fast pulldown current is 100mA.
During turn-off, when the GATE voltage reaches a value
lower than 1.2V, a strong pulldown switch is activated
to keep the FET securely off.
Digital Logic
VDD supplies power for the internal logic circuitry. VDD
ranges from +1.71V to +3.7V and determines the logic
thresholds for the CMOS connections (SDAIN,
SDAOUT, SCL, AUTO, SHD_, A_). This voltage range
enables the MAX5945 to interface with a nonisolated
low-voltage microcontroller. The MAX5945 checks the
digital supply for compatibility with the internal logic.
The MAX5945 also features a VDD undervoltage lockout
(VDDUVLO) of +1.35V. A VDDUVLO condition keeps the
MAX5945 in reset and the ports shut off. Bit 0 in the
supply event register shows the status of VDDUVLO
(Table 11) after VDD has recovered. All logic inputs and
outputs reference to DGND. DGND and AGND are
completely isolated internally to the MAX5945. In a
completely isolated system, the digital signal can be
referenced indifferently to VAGND or VEE or at voltages
even higher than AGND (up to 60V). VDD - VDGND must
be greater than 3.0V when VDGND ≤ (VEE + 3.0V)
When using the AC disconnect detection feature,
AGND must be connected directly to DGND and VDD
must be greater than +3V. In this configuration, con-
nect DGND to AGND at a single point in the system as
close to MAX5945 as possible.
Hardware Shutdown
SHD_ shuts down the respective ports without using
the serial interface. Hardware shutdown offers an emer-
gency turn-off feature that allows a fast disconnect of
the power supply from the port. Pull SHD_ low to
remove power.
Interrupt
The MAX5945 contains an open-drain logic output (INT)
that goes low when an interrupt condition exists. R00h
and R01h (Tables 5 and 6) contain the definitions of the
interrupt registers. The mask register R01h determines
events that trigger an interrupt. As a response to an
interrupt, the controller reads the status of the event reg-
ister to determine the cause of the interrupt and takes
subsequent actions. Each interrupt event register also
contains a clear-on-read (CoR) register. Reading
through the CoR register address clears the interrupt.
INT remains low when reading the interrupt through the
read-only addresses. For example, to clear a startup
fault on port 4 read address 09h (see Table 10). Use the
global pushbutton bit on register 1Ah (bit 7, Table 22) to
clear interrupts, or use a software or hardware reset.
Undervoltage and Overvoltage Protection
The MAX5945 contains several undervoltage and over-
voltage protection features. Table 11 in the Register Map
and Description section shows a detailed list of the
undervoltage and overvoltage protection features. An
internal VEE undervoltage lockout (VEEUVLO) circuit
keeps the MOSFET off and the MAX5945 in reset until
VAGND - VEE exceeds 29V for more than 3ms. An internal
VEE overvoltage (VEE_OV) circuit shuts down the ports
when (VAGND - VEE) exceeds 60V. The digital supply also
contains an undervoltage lockout (VDDUVLO).
V
t
I
C
OUT
GATE
GD
=
MAX5945
Quad Network Power Controller
for Power-Over-LAN
______________________________________________________________________________________
17
Figure 4. Foldback Current Characteristics
50V
30V
VSU_LIM
VSU_LIM / 3
(VSENSE_ - VEE)
(VOUT_ - VEE)
相關PDF資料 |
PDF描述 |
|---|---|
| ENC28J60T/ML | IC ETHERNET CTRLR W/SPI 28QFN |
| ENC28J60/SP | IC ETHERNET CTRLR W/SPI 28DIP |
| 413760-5 | CONN JACK BNC AT&T 728 HEX CRIMP |
| ENC28J60/SO | IC ETHERNET CTRLR W/SPI 28SOIC |
| ENC28J60/ML | IC ETHERNET CTRLR W/SPI 28QFN |
相關代理商/技術參數 |
參數描述 |
|---|---|
| MAX5945EVKIT | 功能描述:電源管理IC開發工具 Evaluation Kit/Evaluation System for the MAX5945 RoHS:否 制造商:Maxim Integrated 產品:Evaluation Kits 類型:Battery Management 工具用于評估:MAX17710GB 輸入電壓: 輸出電壓:1.8 V |
| MAX5945EVSYS | 功能描述:電源管理IC開發工具 Evaluation Kit/Evaluation System for the MAX5945 RoHS:否 制造商:Maxim Integrated 產品:Evaluation Kits 類型:Battery Management 工具用于評估:MAX17710GB 輸入電壓: 輸出電壓:1.8 V |
| MAX5946AETJ | 制造商:Maxim Integrated Products 功能描述:DUAL PCI-EXPRESS HOT-PLUG CONTROLLER - Rail/Tube |
| MAX5946AETX | 功能描述:熱插拔功率分布 RoHS:否 制造商:Texas Instruments 產品:Controllers & Switches 電流限制: 電源電壓-最大:7 V 電源電壓-最小:- 0.3 V 工作溫度范圍: 功率耗散: 安裝風格:SMD/SMT 封裝 / 箱體:MSOP-8 封裝:Tube |
| MAX5946AETX+ | 功能描述:熱插拔功率分布 Dual PCIe Hot-Plug Controller RoHS:否 制造商:Texas Instruments 產品:Controllers & Switches 電流限制: 電源電壓-最大:7 V 電源電壓-最小:- 0.3 V 工作溫度范圍: 功率耗散: 安裝風格:SMD/SMT 封裝 / 箱體:MSOP-8 封裝:Tube |
發布緊急采購，3分鐘左右您將得到回復。