- 您現在的位置：買賣IC網 > PDF目錄385547 > MAX7000S (Altera Corporation) Programmable Logic Device Family PDF資料下載
參數資料
| 型號： | MAX7000S |
| 廠商： | Altera Corporation |
| 英文描述： | Programmable Logic Device Family |
| 中文描述： | 可編程邏輯器件系列 |
| 文件頁數： | 16/62頁 |
| 文件大?。?/td> | 1173K |
| 代理商： | MAX7000S |
第1頁第2頁第3頁第4頁第5頁第6頁第7頁第8頁第9頁第10頁第11頁第12頁第13頁第14頁第15頁當前第16頁第17頁第18頁第19頁第20頁第21頁第22頁第23頁第24頁第25頁第26頁第27頁第28頁第29頁第30頁第31頁第32頁第33頁第34頁第35頁第36頁第37頁第38頁第39頁第40頁第41頁第42頁第43頁第44頁第45頁第46頁第47頁第48頁第49頁第50頁第51頁第52頁第53頁第54頁第55頁第56頁第57頁第58頁第59頁第60頁第61頁第62頁
16
Altera Corporation
MAX 7000 Programmable Logic Device Family Data Sheet
When the tri-state buffer control is connected to
ground, the output is
tri-stated (high impedance) and the I/ O pin can be used as a dedicated
input. When the tri-state buffer control is connected to V
CC
, the output is
enabled.
The MAX 7000 architecture provides dual I/ O feedback, in which
macrocell and pin feedbacks are independent. When an I/ O pin is
configured as an input, the associated macrocell can be used for buried
logic.
In-System
Programma-
bility (ISP)
MAX 7000S devices are in-system programmable via an
industry-standard 4-pin Joint Test Action Group (JTAG) interface (IEEE
Std. 1149.1-1990). ISP allows quick, efficient iterations during design
development and debugging cycles. The MAX 7000S architecture
internally generates the high programming voltage required to program
EEPROM cells, allowing in-system programming with only a single 5.0 V
power supply. During in-system programming, the I/ O pins are tri-stated
and pulled-up to eliminate board conflicts. The pull-up value is nominally
50 k.
ISP simplifies the manufacturing flow by allowing devices to be mounted
on a printed circuit board with standard in-circuit test equipment before
they are programmed. MAX 7000S devices can be programmed by
downloading the information via in-circuit testers (ICT), embedded
processors, or the Altera MasterBlaster, ByteBlasterMV, ByteBlaster,
BitBlaster download cables. (The ByteBlaster cable is obsolete and is
replaced by the ByteBlasterMV cable, which can program and configure
2.5-V, 3.3-V, and 5.0-V devices.) Programming the devices after they are
placed on the board eliminates lead damage on high-pin-count packages
(e.g., QFP packages) due to device handling and allows devices to be
reprogrammed after a system has already shipped to the field. For
example, product upgrades can be performed in the field via software or
modem.
In-system programming can be accomplished with either an adaptive or
constant algorithm. An adaptive algorithm reads information from the
unit and adapts subsequent programming steps to achieve the fastest
possible programming time for that unit. Because some in-circuit testers
cannot support an adaptive algorithm, Altera offers devices tested with a
constant algorithm. Devices tested to the constant algorithm have an “F”
suffix in the ordering code.
The Jam
TM
Standard Test and Programming Language (STAPL) can be
used to program MAX 7000S devices with in-circuit testers, PCs, or
embedded processor.
相關PDF資料 |
PDF描述 |
|---|---|
| MAX7030 | RES 22.1-OHM 1% 0.1W 100PPM THICK-FILM SMD-0603 5K/REEL-7IN-PA |
| MAX7030-ATJ | Low-Cost, 315MHz, 345MHz, and 433.92MHz ASK Transceiver with Fractional-N PLL |
| MAX7030HATJ | Low-Cost, 315MHz, 345MHz, and 433.92MHz ASK Transceiver with Fractional-N PLL |
| MAX7030LATJ | Low-Cost, 315MHz, 345MHz, and 433.92MHz ASK Transceiver with Fractional-N PLL |
| MAX7030MATJ | Low-Cost, 315MHz, 345MHz, and 433.92MHz ASK Transceiver with Fractional-N PLL |
相關代理商/技術參數 |
參數描述 |
|---|---|
| MAX700C/D | 功能描述:監控電路 RoHS:否 制造商:STMicroelectronics 監測電壓數: 監測電壓: 欠電壓閾值: 過電壓閾值: 輸出類型:Active Low, Open Drain 人工復位:Resettable 監視器:No Watchdog 電池備用開關:No Backup 上電復位延遲（典型值）:10 s 電源電壓-最大:5.5 V 最大工作溫度:+ 85 C 安裝風格:SMD/SMT 封裝 / 箱體:UDFN-6 封裝:Reel |
| MAX700C/D DIE | 制造商:Maxim Integrated Products 功能描述: |
| MAX700CPA | 功能描述:監控電路 Integrated Circuits (ICs) RoHS:否 制造商:STMicroelectronics 監測電壓數: 監測電壓: 欠電壓閾值: 過電壓閾值: 輸出類型:Active Low, Open Drain 人工復位:Resettable 監視器:No Watchdog 電池備用開關:No Backup 上電復位延遲（典型值）:10 s 電源電壓-最大:5.5 V 最大工作溫度:+ 85 C 安裝風格:SMD/SMT 封裝 / 箱體:UDFN-6 封裝:Reel |
| MAX700CPA+ | 功能描述:監控電路 Power-Supply Monitor w/Reset RoHS:否 制造商:STMicroelectronics 監測電壓數: 監測電壓: 欠電壓閾值: 過電壓閾值: 輸出類型:Active Low, Open Drain 人工復位:Resettable 監視器:No Watchdog 電池備用開關:No Backup 上電復位延遲（典型值）:10 s 電源電壓-最大:5.5 V 最大工作溫度:+ 85 C 安裝風格:SMD/SMT 封裝 / 箱體:UDFN-6 封裝:Reel |
| MAX700CSA | 功能描述:監控電路 RoHS:否 制造商:STMicroelectronics 監測電壓數: 監測電壓: 欠電壓閾值: 過電壓閾值: 輸出類型:Active Low, Open Drain 人工復位:Resettable 監視器:No Watchdog 電池備用開關:No Backup 上電復位延遲（典型值）:10 s 電源電壓-最大:5.5 V 最大工作溫度:+ 85 C 安裝風格:SMD/SMT 封裝 / 箱體:UDFN-6 封裝:Reel |
發布緊急采購，3分鐘左右您將得到回復。