- 您現在的位置：買賣IC網 > PDF目錄1946 > MAX9238EUM+ (Maxim Integrated Products)IC DESERIALIZER 21BIT 48TSSOP PDF資料下載
參數資料
| 型號： | MAX9238EUM+ |
| 廠商： | Maxim Integrated Products |
| 文件頁數： | 3/15頁 |
| 文件大?。?/td> | 0K |
| 描述： | IC DESERIALIZER 21BIT 48TSSOP |
| 產品培訓模塊： | Lead (SnPb) Finish for COTS Obsolescence Mitigation Program |
| 標準包裝： | 39 |
| 功能： | 解串器 |
| 數據速率： | 1.386Gbps |
| 輸入類型： | LVDS |
| 輸出類型： | LVTTL，LVCMOS |
| 輸入數： | 3 |
| 輸出數： | 21 |
| 電源電壓： | 3 V ~ 3.6 V |
| 工作溫度： | -40°C ~ 85°C |
| 安裝類型： | 表面貼裝 |
| 封裝/外殼： | 48-TFSOP（0.240"，6.10mm 寬） |
| 供應商設備封裝： | 48-TSSOP |
| 包裝： | 管件 |
第1頁第2頁當前第3頁第4頁第5頁第6頁第7頁第8頁第9頁第10頁第11頁第12頁第13頁第14頁第15頁
MAX9234/MAX9236/MAX9238
Hot-Swappable, 21-Bit, DC-Balanced LVDS
Deserializers
11
Maxim Integrated
In the following example, the capacitor value for a
droop of 2% is calculated. Jitter due to this droop is
then calculated assuming a 1ns transition time:
C = - (2 x tB x DSV) / (ln (1 - D) x (RT + RO)) (Eq 1)
where:
C = AC-coupling capacitor (F).
tB = bit time (s).
DSV = digital sum variation (integer).
ln = natural log.
D = droop (% of signal amplitude).
RT = termination resistor ().
RO = output resistance ().
Equation 1 is for two series capacitors (Figure 10). The
bit time (tB) is the period of the parallel clock divided by
9. The DSV is 10. See equation 3 for four series capaci-
tors (Figure 11).
The capacitor for 2% maximum droop at 8MHz parallel
rate clock is:
C = - (2 x tB x DSV) / (ln (1 - D) x (RT + RO))
C = - (2 x 13.9ns x 10) / (ln (1 - 0.02) x (100
+ 78))
C = 0.0773F
Jitter due to droop is proportional to the droop and
transition time:
tJ = tT x D (Eq 2)
where:
tJ = jitter (s).
tT = transition time (s) (0 to 100%).
D = droop (% of signal amplitude).
Jitter due to 2% droop and assumed 1ns transition time is:
tJ = 1ns x 0.02
tJ = 20ps
The transition time in a real system depends on the fre-
quency response of the cable driven by the serializer.
The capacitor value decreases for a higher frequency
parallel clock and for higher levels of droop and jitter.
Use high-frequency, surface-mount ceramic capacitors.
Equation 1 altered for four series capacitors (Figure 11) is:
C = - (4 x tB x DSV) / (ln (1 - D) x (RT + RO)) (Eq 3)
Input Bias and Frequency Detection
The inverting and noninverting LVDS inputs are internally
connected to +1.2V through 42k
(min) to provide bias-
ing for AC-coupling (Figure 1). A frequency-detection
circuit on the clock input detects when the input is not
switching, or is switching at low frequency. In this case,
all outputs are driven low. To prevent switching due to
noise when the clock input is not driven, bias the clock
input to differential +15mV by connecting a 10k
±1%
pullup resistor between the noninverting input and VCC,
and a 10k
±1% pulldown resistor between the invert-
ing input and ground. These bias resistors, along with
the 100
±1% tolerance termination resistor, provide
+15mV of differential input.
Unused LVDS Data Inputs
At each unused LVDS data input, pull the inverting input
up to VCC using a 10k resistor, and pull the noninverting
input down to ground using a 10k
resistor. Do not con-
nect a termination resistor. The pullup and pulldown resis-
tors drive the corresponding outputs low and prevent
switching due to noise.
PWRDWN
Driving PWRDWN low puts the outputs in high imped-
ance, stops the PLL, and reduces supply current to
50A or less. Driving PWRDWN high drives the outputs
low until the PLL locks. The outputs of two deserializers
can be bused to form a 2:1 mux with the outputs con-
trolled by PWRDWN. Wait 100ns between disabling one
deserializer (driving PWRDWN low) and enabling the
second one (driving PWRDWN high) to avoid con-
tention of the bused outputs.
Input Clock and PLL Lock Time
There is no required timing sequence for the applica-
tion or reapplication of the parallel rate clock (RxCLK
IN) relative to PWRDWN, or to a power-supply ramp for
proper PLL lock. The PLL lock time is set by an internal
counter. The maximum time to lock is 32,800 clock
periods. Power and clock should be stable to meet the
lock-time specification. When the PLL is locking, the
outputs are low.
Power-Supply Bypassing
There are separate on-chip power domains for digital
circuits, outputs, PLL, and LVDS inputs. Bypass each
VCC, VCCO, PLL VCC, and LVDS VCC pin with high-fre-
quency, surface-mount ceramic 0.1F and 0.001F
capacitors in parallel as close to the device as possi-
ble, with the smallest value capacitor closest to the
supply pin.
Cables and Connectors
Interconnect for LVDS typically has a differential imped-
ance of 100
. Use cables and connectors that have
matched differential impedance to minimize impedance
discontinuities.
Twisted-pair and shielded twisted-pair cables offer
superior signal quality compared to ribbon cable and
tend to generate less EMI due to magnetic field cancel-
ing effects. Balanced cables pick up noise as common
mode, which is rejected by the LVDS receiver.
相關PDF資料 |
PDF描述 |
|---|---|
| MAX9246GUM/V+ | IC DESERIALIZER 21BIT 48TSSOP |
| MAX9247ETM+T | IC SERIALIZER LVDS 48-TQFN |
| MAX9248ETM+T | IC DESERIALIZER LVDS 48-TQFN |
| MAX9249GCM/V+ | IC SERIALIZER GMSL LVDS 48TQFP |
| MAX9257AGTL/V+ | IC SERDE PROG UART/I2C 40TQFN |
相關代理商/技術參數 |
參數描述 |
|---|---|
| MAX9238EUM+ | 功能描述:串行器/解串器 - Serdes 21-Bit DC-Balanced LVDS Deserializer RoHS:否 制造商:Texas Instruments 類型:Deserializer 數據速率:1.485 Gbit/s 輸入類型:ECL/LVDS 輸出類型:LVCMOS 輸入端數量:1 輸出端數量:20 工作電源電壓:2.375 V to 2.625 V 工作溫度范圍:0 C to + 70 C 封裝 / 箱體:TQFP-64 |
| MAX9238EUM+T | 功能描述:串行器/解串器 - Serdes 21-Bit DC-Balanced LVDS Deserializer RoHS:否 制造商:Texas Instruments 類型:Deserializer 數據速率:1.485 Gbit/s 輸入類型:ECL/LVDS 輸出類型:LVCMOS 輸入端數量:1 輸出端數量:20 工作電源電壓:2.375 V to 2.625 V 工作溫度范圍:0 C to + 70 C 封裝 / 箱體:TQFP-64 |
| MAX9238EUM-D | 功能描述:LVDS 接口集成電路 RoHS:否 制造商:Texas Instruments 激勵器數量:4 接收機數量:4 數據速率:155.5 Mbps 工作電源電壓:5 V 最大功率耗散:1025 mW 最大工作溫度:+ 85 C 封裝 / 箱體:SOIC-16 Narrow 封裝:Reel |
| MAX9238EUM-T | 功能描述:LVDS 接口集成電路 RoHS:否 制造商:Texas Instruments 激勵器數量:4 接收機數量:4 數據速率:155.5 Mbps 工作電源電壓:5 V 最大功率耗散:1025 mW 最大工作溫度:+ 85 C 封裝 / 箱體:SOIC-16 Narrow 封裝:Reel |
| MAX9238EUM-TD | 功能描述:LVDS 接口集成電路 RoHS:否 制造商:Texas Instruments 激勵器數量:4 接收機數量:4 數據速率:155.5 Mbps 工作電源電壓:5 V 最大功率耗散:1025 mW 最大工作溫度:+ 85 C 封裝 / 箱體:SOIC-16 Narrow 封裝:Reel |
發布緊急采購，3分鐘左右您將得到回復。