- 您現在的位置：買賣IC網 > PDF目錄377895 > MB86977PFV-G-BND (FUJITSU LTD) IP PACKET FORWARDING ENGINE PDF資料下載
參數資料
| 型號： | MB86977PFV-G-BND |
| 廠商： | FUJITSU LTD |
| 元件分類： | 通信及網絡 |
| 英文描述： | IP PACKET FORWARDING ENGINE |
| 中文描述： | SPECIALTY TELECOM CIRCUIT, PQFP208 |
| 封裝： | PLASTIC, LQFP-208 |
| 文件頁數： | 13/30頁 |
| 文件大?。?/td> | 149K |
| 代理商： | MB86977PFV-G-BND |
第1頁第2頁第3頁第4頁第5頁第6頁第7頁第8頁第9頁第10頁第11頁第12頁當前第13頁第14頁第15頁第16頁第17頁第18頁第19頁第20頁第21頁第22頁第23頁第24頁第25頁第26頁第27頁第28頁第29頁第30頁
MB86977
13
3.
Filtering
Filtering can be applied to packets that are forwarded between differing segments, i.e. the D.M.Z. and LAN, the
D.M.Z. and WAN, and the WAN and LAN segments. Filtering is executed based on the following information.
Protocol type (Type field in Ethernet)
IP address
TCP/UDP port number
ICMP message type
FEF Engine-filtering function
There are two filters, one for inbound packets, and the other for outbound packets.A maximum of 64 entries can
be set per filter. Filtering can be applied to both IPv4 and IPv6 packets. Filtering can also be executed on packets
that include IP frames such as PPPoE session stage packets. In addition, filtering can also be applied to the L3/
L4 information of AH packets, and the IP addresses of ESP type IPsec packets. The relation between the filter
and FEF is shown in “NAT/IP forwarding function overview”. When the Host Interface block receives a packet
from the switch block, it is first checked by the Rx filter and then forwarded to the NAT/IP forwarding block. The
Tx filter is applied after the packet has been processed by the NAT/IP forwarding block.
Filter Logging
This device can record several characteristics of the packets dropped by the filters. There are counters that can
record the number of packets dropped, and buffers that can store the first 60 Bytes of up to four packets that
were dropped by the filters.
Each of the 64 filter Table entries (for both the input and output filters) has a counter that can count up to 255.
If the counter overflows, it is informed to the host by asserting an interrupt signal. The host may poll the counter
instead if required.
The buffers that store the headers of the packets (i.e. the first 60 bytes of the packet) can be configured to have
the packets that match the condition (1) constantly overwrite the previously stored packet data, or (2) not overwrite
the previously stored packets but assert the interrupt signal as soon as all four buffers have been occupied.
相關PDF資料 |
PDF描述 |
|---|---|
| MB86H20 | SmartMPEG |
| MB86H21 | MPEG-2 Decoder with Integrated NDS ICAM |
| MB86H22 | MPEG-2 Decoder for ext. Temperature Range |
| MB86H23 | MPEG-2 Decoder with Macrovision |
| MB87002 | 1200 BPS MSK MODEM |
相關代理商/技術參數 |
參數描述 |
|---|---|
| MB86A21PMC-G-BNDE1 | 制造商:FUJITSU 功能描述: |
| MB86A21PMC-G-JNE1 | 制造商:FUJITSU 功能描述: |
| MB86A22PMC-ES-BNDE1 | 制造商:FUJITSU 功能描述: |
| MB86A22PMC-G-JNE1 | 制造商:FUJITSU 功能描述: |
| MB86A29T | 制造商:FUJITSU 制造商全稱:Fujitsu Component Limited. 功能描述:Digital Terrestrial Broadcasting 1 segment module |
發布緊急采購，3分鐘左右您將得到回復。