- 您現在的位置：買賣IC網 > PDF目錄377953 > MBM29PDS322TE10 (Fujitsu Limited) 32M (2M x 16) BIT Page Dual Operation PDF資料下載
參數資料
| 型號： | MBM29PDS322TE10 |
| 廠商： | Fujitsu Limited |
| 英文描述： | 32M (2M x 16) BIT Page Dual Operation |
| 中文描述： | 32M的（2米× 16）位頁雙操作 |
| 文件頁數： | 25/66頁 |
| 文件大小： | 694K |
| 代理商： | MBM29PDS322TE10 |
第1頁第2頁第3頁第4頁第5頁第6頁第7頁第8頁第9頁第10頁第11頁第12頁第13頁第14頁第15頁第16頁第17頁第18頁第19頁第20頁第21頁第22頁第23頁第24頁當前第25頁第26頁第27頁第28頁第29頁第30頁第31頁第32頁第33頁第34頁第35頁第36頁第37頁第38頁第39頁第40頁第41頁第42頁第43頁第44頁第45頁第46頁第47頁第48頁第49頁第50頁第51頁第52頁第53頁第54頁第55頁第56頁第57頁第58頁第59頁第60頁第61頁第62頁第63頁第64頁第65頁第66頁
MBM29PDS322TE/BE
10/11
25
Sector Erase
Sector erase is a six bus cycle operation. There are two “unlock” write cycles. These are followed by writing the
“set-up” command. Two more “unlock” write cycles are then followed by the Sector Erase command. The sector
address (any address location within the desired sector) is latched on the falling edge of CE or WE whichever
happens later, while the command (Data = 30h) is latched on the rising edge of CE or WE which happens first.
After time-out of “t
TOW
” from the rising edge of the last sector erase command, the sector erase operation will begin.
Multiple sectors may be erased concurrently by writing the six bus cycle operations on Table4. This sequence
is followed with writes of the Sector Erase command to addresses in other sectors desired to be concurrently
erased. The time between writes must be less than “t
TOW
” otherwise that command will not be accepted and
erasure will not start. It is recommended that processor interrupts be disabled during this time to guarantee this
condition. The interrupts can be re-enabled after the last Sector Erase command is written. A time-out of “t
TOW
”
from the rising edge of last CE or WE whichever happens first will initiate the execution of the Sector Erase
command(s). If another falling edge of CE or WE, whichever happens first occurs within the “t
TOW
” time-out
window the timer is reset. (Monitor DQ
3
to determine if the sector erase timer window is still open, see section
DQ
3
, Sector Erase Timer.) Resetting the device once execution has begun will corrupt the data in the sector. In
that case, restart the erase on those sectors and allow them to complete. (Refer to the Write Operation Status
section for Sector Erase Timer operation.) Loading the sector erase buffer may be done in any sequence and
with any number of sectors (0 to 70).
Sector erase does not require the user to program the device prior to erase. The device automatically program
all memory locations in the sector(s) to be erased prior to electrical erase (Preprogram function). When erasing
a sector or sectors the remaining unselected sectors are not affected. The system is not required to provide any
controls or timings during these operations.
The system can determine the status of the erase operation by using DQ
7
(Data Polling), DQ
6
(Toggle Bit), or
RY/BY.
The sector erase begins after the “t
TOW
” time out from the rising edge of CE or WE whichever happens first for
the last sector erase command pulse and terminates when the data on DQ
7
is “1” (See Write Operation Status
section.) at which time the device returns to the read mode. Data polling and Toggle Bit must be performed at
an address within any of the sectors being erased.
Multiple Sector Erase Time; [Sector Erase Time + Sector Program Time (Preprogramming)]
×
Number of Sector
Erase
In case of multiple sector erase across bank boundaries, a read from bank (read-while-erase) can not perform.
Figure 21 illustrates the Embedded Erase
TM
Algorithm using typical command strings and bus operations.
相關PDF資料 |
PDF描述 |
|---|---|
| MBM29PDS322BE | 32M (2M x 16) BIT Page Dual Operation |
| MBM29PDS322TE | 32M (2M x 16) BIT Page Dual Operation |
| MBM29PDS322TE11 | 32M (2M x 16) BIT Page Dual Operation |
| MBM29PDS322TE11PBT | 32M (2M x 16) BIT Page Dual Operation |
| MBM29PDS322BE10 | 32M (2M x 16) BIT Page Dual Operation |
相關代理商/技術參數 |
參數描述 |
|---|---|
| MBM30000 | 功能描述:BRACKET SIDE MOUNT RoHS:是 類別:工業控制，儀表 >> 配件 系列:* 標準包裝:1 系列:Aero-Motive® 130117 附件類型:拖車帶 適用于相關產品:標準盒式跟蹤系統 其它名稱:WM6183 |
| MBM30035001 | 制造商:LG Corporation 功能描述:Card,Technical |
| MBM30035015 | 制造商:LG Corporation 功能描述:Card,Technical |
| MBM300A6 | 制造商:HITACHI 制造商全稱:Hitachi Semiconductor 功能描述:IGBT MODULE RANGE WITH SOFT AND FAST (SFD) FREE-WHEELING DIODES |
| MBM300GR12A | 制造商:n/a 功能描述:IGBT Module |
發布緊急采購，3分鐘左右您將得到回復。