- 您現在的位置：買賣IC網 > PDF目錄359133 > MC33991 (飛思卡爾半導體(中國)有限公司) Gauge Driver Integrated Circuit(標尺驅動器集成電路) PDF資料下載
參數資料
| 型號： | MC33991 |
| 廠商： | 飛思卡爾半導體(中國)有限公司 |
| 英文描述： | Gauge Driver Integrated Circuit(標尺驅動器集成電路) |
| 中文描述： | 儀表驅動集成電路（標尺驅動器集成電路） |
| 文件頁數： | 13/36頁 |
| 文件大?。?/td> | 660K |
| 代理商： | MC33991 |
第1頁第2頁第3頁第4頁第5頁第6頁第7頁第8頁第9頁第10頁第11頁第12頁當前第13頁第14頁第15頁第16頁第17頁第18頁第19頁第20頁第21頁第22頁第23頁第24頁第25頁第26頁第27頁第28頁第29頁第30頁第31頁第32頁第33頁第34頁第35頁第36頁
MOTOROLA ANALOG INTEGRATED CIRCUIT DEVICE DATA
33991
13
TIMING DESCRIPTIONS AND DIAGRAMS
Figure 4. Single 16-bit Word SPI Communication
Figure 5. Multiple 16-bit Word SPI Communication
Data Input
The Input Shift register captures data at the falling edge of
the SCLK clock. The SCLK clock pulses exactly 16 times only
inside the transmission windows (CS in a logic [0] state). By the
time the CS signal goes to logic [1] again, the contents of the
Input Shift register are transferred to the appropriate internal
register, according to the address contained in bits 15-13. The
minimum time CS should be kept high depends on the internal
clock speed. That data is specified in the SPI Interface Timing
table. It must be long enough so the internal clock is able to
capture the data from the Input Shift register and transfer it to
the internal registers.
Data Output
At the first rising edge of the SCLK clock, with the CS at logic
[0], the contents of the status word register are transferred to
the Output Shift register. The first 16 bits clocked out are the
statusbits.Ifdatacontinuestoclockinbeforethe CStransitions
to a logic [1], the device begins to shift out the data previously
clocked in FIFO after the CS first transitioned to logic [0].
COMMUNICATION MEMORY MAPS
The 33991device is capable of interfacing directly with a
microcontroller, via the 16-bit SPI protocol described and
specified below. The device is controlled by the microprocessor
and reports back status information via the SPI. This section
provides a detailed description of all registers accessible via
serial interface. The various registers control the behavior of
this device.
A message is transmitted by the master starting with the
MSB (D15) and ending with the LSB (D0). Multiple messages
can be transmitted in succession to accommodate those
applications where daisy chaining is desirable, or to confirm
transmitted data, as long as the messages are all multiples of
16 bits. Data will transfer through daisy chained devices,
illustrated in Figure 5. If an attempt is made to latch in a
message smaller than 16-bits wide, it is ignored.
The 33991uses six registers to con the device and control
the state of the four H-bridge outputs. Registers are addressed
via D15-D13 of the incoming SPI word. Refer to Table 2.
Internal registers are
loaded som etim e
C S B
S I
S C LK
D 15
D 1
D 2
D 3
D 4
D 5
D 6
D 7
D 8
D 9
D 14
D 13
D 12
D 11
D 10
O D 12
D 0
O D 13
O D 14
O D 15
O D 6
O D 7
O D 8
O D 9
O D 10
O D 11
O D 1
O D 2
O D 3
O D 4
O D 5
1.
S O is tri-stated when C S B is logic 1.
N O TE S:
O D 0
S O
O utput shift register is
loaded here
SCLK
CS
SI
SO
C S B
S I
S C LK
D 15
D 1*
D 2*
D 13*
D 14*
D 15*
D 0
D 1
D 14
D 13
D 2
D 0*
O D 13
O D 14
O D 15
D 14
D 15
O D 0
O D 1
O D 2
D 1
D 2
D 13
1.
2.
3.
4.
S O is tri-stated w hen C S B is logic 1.
D 15, D 14, D 13, ..., and D 0 refer to the first 16 bits of data into the G D IC .
D 15*, D 14*, D 13*, ... , and D 0* refer to the m ost recent entry of program data into the G D IC .
O D 15, O D 14, O D 13, ..., and O D 0 refer to the first 16 bits of fault and status data out of the G D IC .
N O TE S
:
D 0
S O
CS
SCLK
SI
SO
F
Freescale Semiconductor, Inc.
Go to: www.freescale.com
n
.
相關PDF資料 |
PDF描述 |
|---|---|
| MC33993 | Multiple Switch Detection Interface(多開關監測接口) |
| MC33997 | Switching Power Supply with Linear Regulators(帶線性穩壓器的開關電源) |
| MC33998 | Switching Power Supply with Linear Regulators(帶線性穩壓器的開關電源) |
| MC34017 | Telephone Tone Ringer(電話振鈴) |
| MC34063A | DC-DC CONVERTER CONTROL CIRCUITS |
相關代理商/技術參數 |
參數描述 |
|---|---|
| MC33991DW | 制造商:Freescale Semiconductor 功能描述:Gauge Driver Integrated Circuit |
| MC33991DWR2 | 制造商:Rochester Electronics LLC 功能描述:GUAGE DRIVER IC - Bulk |
| MC33993DWB | 功能描述:接口 - 專用 MSDI RoHS:否 制造商:Texas Instruments 產品類型:1080p60 Image Sensor Receiver 工作電源電壓:1.8 V 電源電流:89 mA 最大功率耗散: 最大工作溫度:+ 85 C 安裝風格:SMD/SMT 封裝 / 箱體:BGA-59 |
| MC33993DWBR2 | 功能描述:接口 - 專用 MSDI RoHS:否 制造商:Texas Instruments 產品類型:1080p60 Image Sensor Receiver 工作電源電壓:1.8 V 電源電流:89 mA 最大功率耗散: 最大工作溫度:+ 85 C 安裝風格:SMD/SMT 封裝 / 箱體:BGA-59 |
| MC33996EK | 功能描述:電源開關 IC - 配電 16LOW SIDE SW 1.2OHM RoHS:否 制造商:Exar 輸出端數量:1 開啟電阻（最大值）:85 mOhms 開啟時間（最大值）:400 us 關閉時間（最大值）:20 us 工作電源電壓:3.2 V to 6.5 V 電源電流（最大值）: 最大工作溫度:+ 85 C 安裝風格:SMD/SMT 封裝 / 箱體:SOT-23-5 |
發布緊急采購，3分鐘左右您將得到回復。