- 您現在的位置：買賣IC網 > PDF目錄45229 > MC68HC11F1CPU4R2 (MOTOROLA INC) 8-BIT, EEPROM, 4 MHz, MICROCONTROLLER, PQFP80 PDF資料下載
參數資料
| 型號： | MC68HC11F1CPU4R2 |
| 廠商： | MOTOROLA INC |
| 元件分類： | 微控制器/微處理器 |
| 英文描述： | 8-BIT, EEPROM, 4 MHz, MICROCONTROLLER, PQFP80 |
| 封裝： | 14 X 14 MM, 1.40 MM HEIGHT, PLASTIC, LQFP-80 |
| 文件頁數： | 101/163頁 |
| 文件大?。?/td> | 711K |
| 代理商： | MC68HC11F1CPU4R2 |
第1頁第2頁第3頁第4頁第5頁第6頁第7頁第8頁第9頁第10頁第11頁第12頁第13頁第14頁第15頁第16頁第17頁第18頁第19頁第20頁第21頁第22頁第23頁第24頁第25頁第26頁第27頁第28頁第29頁第30頁第31頁第32頁第33頁第34頁第35頁第36頁第37頁第38頁第39頁第40頁第41頁第42頁第43頁第44頁第45頁第46頁第47頁第48頁第49頁第50頁第51頁第52頁第53頁第54頁第55頁第56頁第57頁第58頁第59頁第60頁第61頁第62頁第63頁第64頁第65頁第66頁第67頁第68頁第69頁第70頁第71頁第72頁第73頁第74頁第75頁第76頁第77頁第78頁第79頁第80頁第81頁第82頁第83頁第84頁第85頁第86頁第87頁第88頁第89頁第90頁第91頁第92頁第93頁第94頁第95頁第96頁第97頁第98頁第99頁第100頁當前第101頁第102頁第103頁第104頁第105頁第106頁第107頁第108頁第109頁第110頁第111頁第112頁第113頁第114頁第115頁第116頁第117頁第118頁第119頁第120頁第121頁第122頁第123頁第124頁第125頁第126頁第127頁第128頁第129頁第130頁第131頁第132頁第133頁第134頁第135頁第136頁第137頁第138頁第139頁第140頁第141頁第142頁第143頁第144頁第145頁第146頁第147頁第148頁第149頁第150頁第151頁第152頁第153頁第154頁第155頁第156頁第157頁第158頁第159頁第160頁第161頁第162頁第163頁
MOTOROLA
OPERATING MODES AND ON-CHIP MEMORY
MC68HC11F1
4-4
TECHNICAL DATA
During the software-based STOP mode, MCU clocks are stopped, but the MCU con-
tinues to draw power from VDD. Power supply current is directly proportional to oper-
ating frequency in CMOS integrated circuits and there is very little leakage when the
clocks are stopped. These two factors reduce power consumption while the MCU is in
STOP mode.
To reduce power consumption to a minimum, VDD can be turned off, and the MODB/
VSTBY pin can be used to supply RAM power from either a battery back-up or a sec-
ond power supply. Although this method requires external hardware, it is very effec-
tive. Refer to SECTION 2 PIN DESCRIPTIONS for information about how to connect
the standby RAM power supply. Refer to SECTION 5 RESETS AND INTERRUPTS
for a description of low power operation.
Figure 4-2 RAM Standby MODB/VSTBY Connections
4.2.2.2 Bootloader ROM
The bootloader ROM is enabled at address $BF00–$BFFF during special bootstrap
mode. The reset vector is fetched from this ROM and the MCU executes the bootload-
er firmware. In normal modes, the bootloader ROM is disabled.
4.2.2.3 EEPROM
The MC68HC11F1 contains 512 bytes of electrically erasable programmable read-
only memory (EEPROM). The default location for EEPROM is $FE00–$FFFF. Other
locations can be chosen according to the values written to EE[3:0] in the CONFIG reg-
ister. In single-chip and bootstrap modes, the EEPROM is forced on and located at the
default position. In these modes, the EEPROM cannot be remapped. In special test
mode, the EEPROM is disabled initially.
4.2.3 Registers
Table 4-1, a summary of registers and control bits, the registers are shown in ascend-
ing order within the 96-byte register block. The addresses shown are for default block
mapping ($1000–$105F), however, the register block can be remapped to any 4-Kbyte
page ($x000–$x05F) by the INIT register.
VBATT
VDD
TO MODB/VSTBY
OF M68HC11
VOUT
VDD
+
MAX
690
4.8 V
NiCd
4.7 k
相關PDF資料 |
PDF描述 |
|---|---|
| MC68HC11F1CFN5 | 8-BIT, EEPROM, 5 MHz, MICROCONTROLLER, PQCC68 |
| MC68HC11F1CPU4R2 | 8-BIT, EEPROM, 4 MHz, MICROCONTROLLER, PQFP80 |
| MC68HC11F1CFN3 | 8-BIT, EEPROM, 3 MHz, MICROCONTROLLER, PQCC68 |
| MC68HC11F1CFN2 | 8-BIT, EEPROM, 2 MHz, MICROCONTROLLER, PQCC68 |
| MC68HC11F1VFN2 | 8-BIT, EEPROM, 2 MHz, MICROCONTROLLER, PQCC68 |
相關代理商/技術參數 |
參數描述 |
|---|---|
| MC68HC11F1CPU5 | 制造商:MOTOROLA 制造商全稱:Motorola, Inc 功能描述:Technical Summary 8-Bit Microcontroller |
| MC68HC11F1CPUE5 | 制造商:Freescale Semiconductor 功能描述: |
| MC68HC11F1FB | 制造商:FREESCALE 制造商全稱:Freescale Semiconductor, Inc 功能描述:ROM-based high-performance microcontrollers |
| MC68HC11F1FB1 | 制造商:FREESCALE 制造商全稱:Freescale Semiconductor, Inc 功能描述:ROM-based high-performance microcontrollers |
| MC68HC11F1FB3 | 制造商:FREESCALE 制造商全稱:Freescale Semiconductor, Inc 功能描述:ROM-based high-performance microcontrollers |
發布緊急采購，3分鐘左右您將得到回復。