- 您現在的位置：買賣IC網 > PDF目錄383588 > MCP18480 (Microchip Technology Inc.) -48V Hot Swap Controller PDF資料下載
參數資料
| 型號： | MCP18480 |
| 廠商： | Microchip Technology Inc. |
| 元件分類： | 基準電壓源/電流源 |
| 英文描述： | -48V Hot Swap Controller |
| 中文描述： | - 48V熱插拔控制器 |
| 文件頁數： | 44/64頁 |
| 文件大?。?/td> | 871K |
| 代理商： | MCP18480 |
第1頁第2頁第3頁第4頁第5頁第6頁第7頁第8頁第9頁第10頁第11頁第12頁第13頁第14頁第15頁第16頁第17頁第18頁第19頁第20頁第21頁第22頁第23頁第24頁第25頁第26頁第27頁第28頁第29頁第30頁第31頁第32頁第33頁第34頁第35頁第36頁第37頁第38頁第39頁第40頁第41頁第42頁第43頁當前第44頁第45頁第46頁第47頁第48頁第49頁第50頁第51頁第52頁第53頁第54頁第55頁第56頁第57頁第58頁第59頁第60頁第61頁第62頁第63頁第64頁
MCP18480
DS20091B-page 44
2003 Microchip Technology Inc.
6.8
DESCRIPTION OF INTERNAL
BLOCKS
The internal blocks shown in the
MCP18480 Block Dia-
gram on page 2
are discussed in Section 6.8.1 through
Section 6.8.8.
6.8.1
UV (UNDERVOLTAGE) BLOCK
The Undervoltage lockout circuit monitors the input
voltage by comparing a centertap voltage on an exter-
nal resistor divider to a 2.5V reference. The centertap
voltage is fed into the UV
TH
input pin.
If the voltage on the UV
TH
pin is below the internal 2.5V
reference, the absolute magnitude of the supply volt-
age is too low for proper system operation, resulting in
the external MOSFET being turned off. If the voltage on
the UV
TH
pin is greater than V
NEG
+ 2.5V, the supply
voltage is above the minimal operating voltage as set
by the external resistor divider network.
In telecom network applications, it is common to shut
down the DC/DC converter supply when the input volt-
age falls below -38.5V (tolerance of ±1.0V) for greater
than 100 ms. The system will not restart until the volt-
age exceeds -43.0V (tolerance of ±0.5V). This voltage
difference is produced by an open-drain NMOS output
(the UV
HYS
pin) that connects an external resistor in
parallel with the lower of the two resistors in the exter-
nal UV divider network until the supply ramps down to
-43V. When the UV
TH
pin exceeds V
NEG
+ 2.5V, the
internal NMOS transistor is turned off, disconnecting
the external resistor connected to the UV
HYS
pin. The
voltage at the UV
TH
pin increases to 2.79V. The supply
voltage would have to decrease to -38.5V in order to
assert the internal “Undervoltage Active” signal.
An internal 10 μA current source and an external
capacitor connected to the UV
D
pin adjusts the delay
between the input fault and the notification of this fault
to the system. This is usually 100 ms for -48V telecom-
type equipment. For customized adjustments, the time
delay can be expressed as Equation 6-1.
EQUATION 6-1:
INPUT FAULT DELAY
C
UV
is the capacitor connected between the UV
D
pin
and the V
NEG
pin. A value of 1 μF would provide a
delay of about 100 ms.
If the supply voltage dips below the programmed
threshold, the input comparator trips the other way. The
timing capacitor is released to ramp-up at the previ-
ously described rate and the Undervoltage block
switches when the capacitor voltage reaches 1.25V.
When the input comparator goes to a low level, the hys-
teresis FET is turned on and the trip point for
reassertion of good V
NEG
reverts to -43V.
While the Undervoltage Active signal is low (includes
Undervoltage input filter), the GATE pin driver for the
external MOSFET is disabled, the GATE pin is pulled to
the voltage of the V
NEG
pin with a 60 mA current sink
and the PWRGOOD output pin is deasserted to indi-
cate that the input voltage is out of range.
EQUATION 6-2:
UNDERVOLTAGE
HYSTERESIS
EQUATION 6-3:
UNDERVOLTAGE
CONDITION
Note:
Voltage levels discussed are with respect
to external component values selected in
Figure 4-1.
T
DELAY
V
---------2
------------------
C
UVD
10
μ
A
=
R
UVHYS
V
REFIN
-V
R
UV2
------------
1
–
----V
UVD
–
=
R
R
----------------------------------------------------
V
REFIN
V
R
UV1
UV2
R
UV2
+
)
----------------------R
>
相關PDF資料 |
PDF描述 |
|---|---|
| MCP201 | LIN Transceiver with Voltage Regulator(帶有集成Vreg的線收發器) |
| MCP2120 | low-cost, high-performance, fully-static infrared encoder/decoder.(帶有硬件/軟件波特率選擇的UART到IR編譯碼器) |
| MCP2140 | IrDA Standard Protocol Stack Controller With Fixed 9600 Baud Communication Rate(固定波特率,低成本,IrDA標準協議編譯碼器) |
| MCP2150 | DEVELOPER’S KIT USER’S GUIDE |
| MCP2155 | IrDA Standard Protocol Stack Controller Supporting DCE Applications(提供IrDA協議來處理PLUS位的編碼/譯碼功能,這是為了在一個低引腳的計數設備上實現數據傳輸功能(DCE)而提供的) |
相關代理商/技術參數 |
參數描述 |
|---|---|
| MCP18480-I/SS | 功能描述:熱插拔功率分布 48V Hot Swap RoHS:否 制造商:Texas Instruments 產品:Controllers & Switches 電流限制: 電源電壓-最大:7 V 電源電壓-最小:- 0.3 V 工作溫度范圍: 功率耗散: 安裝風格:SMD/SMT 封裝 / 箱體:MSOP-8 封裝:Tube |
| MCP18480T-I/SS | 功能描述:熱插拔功率分布 48V Hot Swap RoHS:否 制造商:Texas Instruments 產品:Controllers & Switches 電流限制: 電源電壓-最大:7 V 電源電壓-最小:- 0.3 V 工作溫度范圍: 功率耗散: 安裝風格:SMD/SMT 封裝 / 箱體:MSOP-8 封裝:Tube |
| MCP-18H | 制造商:Taiyo Electric Ind. 功能描述: |
| MCP-18-I9-LL | 制造商:YAMAICHI 制造商全稱:Yamaichi Electronics Co., Ltd. 功能描述:MatchCon |
| MCP-18-TI9-LL | 制造商:YAMAICHI 制造商全稱:Yamaichi Electronics Co., Ltd. 功能描述:MatchCon |
發布緊急采購，3分鐘左右您將得到回復。