參數資料
型號： MCP455SB
廠商： Microchip Technology Inc.
英文描述： 400000 SYSTEM GATE 1.8 VOLT FPGA - NOT RECOMMENDED for NEW DESIGN
中文描述： 13.56 MHz讀/寫無源RFID器件
文件頁數： 15/50頁
文件大?。?/td> 1172K
代理商： MCP455SB
2003 Microchip Technology Inc.
DS40232H-page 15
MCRF450/451/452/455
5.0
DETECTION AND ENCODING
This section encodes data with the Manchester format
and also detects commands from the Interrogator.
5.1
Demodulator (Detector)
This circuit demodulates the Interrogator commands
and sends them to the PPM decoder.
5.2
Fast Mode Oscillator
This oscillator generates a clock frequency that is used
for decoding Fast mode commands.
5.3
PPM Signal Decoder
This section decodes the PPM signals and sends the
results to the command decoder and CRC/parity
checker.
5.4
Command Decoder
This section decodes the Interrogator commands and
sends the results to the Anti-collision/command
controller.
5.5
CRC/Parity Generator and
Checker
This section generates Cyclic Redundancy Code
(CRC) and parity bits for transmitting and receiving
data. The device utilizes a 16-bit CRC for error
detection. Its polynomial and initial values are:
CRC Polynomial: X
16
+X
12
+X
5
+X
0
Initial Value: $FFFF
This polynomial is also known as CRC CCITT
(Consultative Committee for International Telegraph
and Telephone). The Interrogator also uses the same
CRC for data processing. The device uses the CRC in
the following ways:
1.
CRC for blocks (except Blocks 0 and 2):
The
Interrogator will send a Write command with
CRC. When the device receives this command,
it checks the CRC prior to any processing. If it is
a correct CRC, the device programs the block
data and also stores the CRC in the EEPROM.
As soon as the data is written into memory, both
the programmed data and Stored CRC (SCRC)
are sent back to the Interrogator as verification.
The device also sends the programmed data
and SCRC when there is a response to the
Read command.
If the CRC is incorrect, the device ignores the
incoming message (does not respond to the
Interrogator) and waits for the next command
with a correct CRC.
2.
CRC for Blocks 0 and 2:
When reading Block
0 or 2, a Calculated CRC (CCRC) is sent. This
is because both the TF and FR bits in Block 0
are non write-protectable, while the rest of the
bits in the block are write-protectable. This
means the SCRC in the block no longer repre-
sents the CRC of the block data, if only the TF or
the FR bit is reprogrammed. This is also true for
Block 2, which is a write protection block. The
write-protected bit cannot be reprogrammed
once it has been written. Therefore, the SCRC in
Blocks 0 and 2 are not used. Instead, the device
calculates the current CRC of the block and
sends it to the Interrogator.
3.
CRC for FRR response:
For the Fast Read (FR)
response (this is the device response to an FRR
command), the CCRC of the tag ID and FRF
(Blocks 3-5) data is sent. The data length of the
FRF is determined by DF bits (see Table 7-6).
5.6
Data Encoder
This section multiplexes serial data, encodes it into
Manchester format and sends it to the modulation
circuit. See Figure 3-2 for the Manchester waveform.
相關PDF資料
PDF描述
MCP455SN 400000 SYSTEM GATE 1.8 VOLT FPGA - NOT RECOMMENDED for NEW DESIGN
MCP455W 13.56 MHz Read/Write Passive RFID Device
MCP455X 13.56 MHz Read/Write Passive RFID Device
MCP452WFB 13.56 MHz Read/Write Passive RFID Device
MCP6001E 200000 SYSTEM GATE 1.8 VOLT FPGA - NOT RECOMMENDED for NEW DESIGN
相關代理商/技術參數
參數描述
MCP4561-103E/MS 功能描述:數字電位計 IC Sngl 8B NV I2C POT RoHS:否 制造商:Maxim Integrated 電阻:200 Ohms 溫度系數:35 PPM / C 容差:25 % POT 數量:Dual 每 POT 分接頭:256 弧刷存儲器:Volatile 緩沖刷: 數字接口:Serial (3-Wire, SPI) 描述/功能:Dual Volatile Low Voltage Linear Taper Digital Potentiometer 工作電源電壓:1.7 V to 5.5 V 電源電流:27 uA 最大工作溫度:+ 125 C 安裝風格:SMD/SMT 封裝 / 箱體:TQFN-16 封裝:Reel
MCP4561-103E/MS 制造商:Microchip Technology Inc 功能描述:Digital Potentiometer IC
MCP4561-104E/MS 功能描述:數字電位計 IC Sngl 8B NV I2C POT RoHS:否 制造商:Maxim Integrated 電阻:200 Ohms 溫度系數:35 PPM / C 容差:25 % POT 數量:Dual 每 POT 分接頭:256 弧刷存儲器:Volatile 緩沖刷: 數字接口:Serial (3-Wire, SPI) 描述/功能:Dual Volatile Low Voltage Linear Taper Digital Potentiometer 工作電源電壓:1.7 V to 5.5 V 電源電流:27 uA 最大工作溫度:+ 125 C 安裝風格:SMD/SMT 封裝 / 箱體:TQFN-16 封裝:Reel
MCP4561-104E/MS 制造商:Microchip Technology Inc 功能描述:; LEADED PROCESS COMPATIBLE:YES; PEAK RE
MCP4561-502E/MS 功能描述:數字電位計 IC Sngl 8B NV I2C POT RoHS:否 制造商:Maxim Integrated 電阻:200 Ohms 溫度系數:35 PPM / C 容差:25 % POT 數量:Dual 每 POT 分接頭:256 弧刷存儲器:Volatile 緩沖刷: 數字接口:Serial (3-Wire, SPI) 描述/功能:Dual Volatile Low Voltage Linear Taper Digital Potentiometer 工作電源電壓:1.7 V to 5.5 V 電源電流:27 uA 最大工作溫度:+ 125 C 安裝風格:SMD/SMT 封裝 / 箱體:TQFN-16 封裝:Reel
發布緊急采購，3分鐘左右您將得到回復。

采購需求

(若只采購一條型號，填寫一行即可)

發布成功！您可以繼續發布采購。也可以進入我的后臺，查看報價

發布成功！您可以繼續發布采購。也可以進入我的后臺，查看報價

*型號 *數量 廠商 批號 封裝
添加更多采購

我的聯系方式

*
*
*