DYNAMIC ELECTRICAL CHARACTERISTICS Figure 4." />
參數資料
型號: MCZ33989EGR2
廠商: Freescale Semiconductor
文件頁數: 7/72頁
文件大?。?/td> 0K
描述: IC SYSTEM BASIS CHIP CAN 28-SOIC
標準包裝: 1,000
系列: *
應用: *
接口: *
電源電壓: *
封裝/外殼: 28-SOIC(0.295",7.50mm 寬)
供應商設備封裝: 28-SOIC W
包裝: 帶卷 (TR)
安裝類型: 表面貼裝
Analog Integrated Circuit Device Data
Freescale Semiconductor
15
33989
ELECTRICAL CHARACTERISTICS
DYNAMIC ELECTRICAL CHARACTERISTICS
Figure 4. Wake-up Block Diagram
The block diagram in Figure 4 illustrates how the wake-up signal is generated. First the CAN signal is detected by a low
consumption receiver (WU receiver). Then the signal passes through a pulse width filter, which discards the undesired pulses.
The pulse must have a width bigger than 0.5 s and smaller than 500 s to be accepted. When a pulse is discarded the pulse
counter is reset and no wake signal is generated, otherwise when a pulse is accepted the pulse counter is incremental and after
three pulses the wake signal is asserted.
Figure 5. Transient Test Pulse for L0:L3 Inputs
Each one of the pulses must be spaced by no more than 500 s. In that case, the pulse counter is reset and no wake signal
is generated. This is accomplished by the wake timeout generator. The wake-up cycle is completed (and the wake flag reset)
when the CAN interface is brought to CAN Normal mode.
The wake-up capability of the CAN can be disabled, refer to SPI interface and register section, CAN register.
Non Differential Slew Rate (CANL or CANH)
Slew Rate 3
Slew Rate 2
Slew Rate 1
Slew Rate 0
tSL3
tSL2
tSL1
tSL0
4.0
3.0
2.0
1.0
19
13.5
8.0
5.0
40
20
15
10
V/s
Table 4. Dynamic Electrical Characteristics (continued)
Characteristics noted under conditions 7.0 V
VSUP 18 V, -40C TA 125C, GND = 0 V, unless otherwise noted. Typical
values noted reflect the approximate parameter means at TA = 25°C under nominal conditions, unless otherwise noted.
Characteristic
Symbol
Min
Typ
Max
Unit
+
WU
OUT
Latch
RST
Timeout
RST
Counter
Pulse OK
Narrow
Pulse
Pulse Width
Filter
Timeout
Generator
Standby
WU Receiver
CANH
CANL
LX
Transient Pulse
GND
Generator
1nF
(Note)
10 k
Note: Waveform in accordance to
ISO 7637 part1, test pulses 1, 2, 3a and 3b.
相關PDF資料
PDF描述
V150A12E500BG3 CONVERTER MOD DC/DC 12V 500W
VE-BWX-IW-F4 CONVERTER MOD DC/DC 5.2V 100W
VE-BWV-IW-F1 CONVERTER MOD DC/DC 5.8V 100W
MCZ33989EG IC SYSTEM BASIS CHIP CAN 28-SOIC
V150A12E500B3 CONVERTER MOD DC/DC 12V 500W
相關代理商/技術參數
參數描述
MCZ33990EF 功能描述:網絡控制器與處理器 IC CLASS B SERIAL TRANS. RoHS:否 制造商:Micrel 產品:Controller Area Network (CAN) 收發器數量: 數據速率: 電源電流(最大值):595 mA 最大工作溫度:+ 85 C 安裝風格:SMD/SMT 封裝 / 箱體:PBGA-400 封裝:Tray
MCZ33990EF 制造商:Freescale Semiconductor 功能描述:TRANCEIVER J-1850 CLASS B 8SOIC
MCZ33990EF/R2 制造商:FREESCALE 制造商全稱:Freescale Semiconductor, Inc 功能描述:Enhanced Class B Serial Transceiver
MCZ33990EFR2 功能描述:網絡控制器與處理器 IC CLASS B SERIAL TRANS RoHS:否 制造商:Micrel 產品:Controller Area Network (CAN) 收發器數量: 數據速率: 電源電流(最大值):595 mA 最大工作溫度:+ 85 C 安裝風格:SMD/SMT 封裝 / 箱體:PBGA-400 封裝:Tray
MCZ33991EG 功能描述:馬達/運動/點火控制器和驅動器 GAUGE DRIVER IC RoHS:否 制造商:STMicroelectronics 產品:Stepper Motor Controllers / Drivers 類型:2 Phase Stepper Motor Driver 工作電源電壓:8 V to 45 V 電源電流:0.5 mA 工作溫度:- 25 C to + 125 C 安裝風格:SMD/SMT 封裝 / 箱體:HTSSOP-28 封裝:Tube