- 您現在的位置：買賣IC網 > PDF目錄45322 > MP80C31-30D (ATMEL CORP) 8-BIT, 30 MHz, MICROCONTROLLER, PDIP40 PDF資料下載
參數資料
| 型號： | MP80C31-30D |
| 廠商： | ATMEL CORP |
| 元件分類： | 微控制器/微處理器 |
| 英文描述： | 8-BIT, 30 MHz, MICROCONTROLLER, PDIP40 |
| 封裝： | PLASTIC, DIP-40 |
| 文件頁數： | 16/170頁 |
| 文件大小： | 4133K |
| 代理商： | MP80C31-30D |
第1頁第2頁第3頁第4頁第5頁第6頁第7頁第8頁第9頁第10頁第11頁第12頁第13頁第14頁第15頁當前第16頁第17頁第18頁第19頁第20頁第21頁第22頁第23頁第24頁第25頁第26頁第27頁第28頁第29頁第30頁第31頁第32頁第33頁第34頁第35頁第36頁第37頁第38頁第39頁第40頁第41頁第42頁第43頁第44頁第45頁第46頁第47頁第48頁第49頁第50頁第51頁第52頁第53頁第54頁第55頁第56頁第57頁第58頁第59頁第60頁第61頁第62頁第63頁第64頁第65頁第66頁第67頁第68頁第69頁第70頁第71頁第72頁第73頁第74頁第75頁第76頁第77頁第78頁第79頁第80頁第81頁第82頁第83頁第84頁第85頁第86頁第87頁第88頁第89頁第90頁第91頁第92頁第93頁第94頁第95頁第96頁第97頁第98頁第99頁第100頁第101頁第102頁第103頁第104頁第105頁第106頁第107頁第108頁第109頁第110頁第111頁第112頁第113頁第114頁第115頁第116頁第117頁第118頁第119頁第120頁第121頁第122頁第123頁第124頁第125頁第126頁第127頁第128頁第129頁第130頁第131頁第132頁第133頁第134頁第135頁第136頁第137頁第138頁第139頁第140頁第141頁第142頁第143頁第144頁第145頁第146頁第147頁第148頁第149頁第150頁第151頁第152頁第153頁第154頁第155頁第156頁第157頁第158頁第159頁第160頁第161頁第162頁第163頁第164頁第165頁第166頁第167頁第168頁第169頁第170頁
112
ATtiny4/5/9/10 [DATASHEET]
8127F–AVR–02/2013
15.4.3.4
Erasing the Configuration Section
The algorithm for erasing the Configuration section is as follows:
1.
Write the SECTION_ERASE command to the NVMCMD register
2.
Start the erase operation by writing a dummy byte to the high byte of any word location inside the configu-
ration section
3.
Wait until the NVMBSY bit has been cleared
15.4.3.5
Writing a Configuration Word
The algorithm for writing a Configuration word is as follows.
1.
Write the WORD_WRITE command to the NVMCMD register
2.
Write the low byte of the data to the low byte of a configuration word location
3.
Write the high byte of the data to the high byte of the same configuration word location. This will start the
Flash write operation.
4.
Wait until the NVMBSY bit has been cleared
15.4.4
Reading NVM Lock Bits
The Non-Volatile Memory Lock Byte can be read from the mapped location in data memory.
15.4.5
Writing NVM Lock Bits
The algorithm for writing the Lock bits is as follows.
1.
Write the WORD_WRITE command to the NVMCMD register.
2.
Write the lock bits value to the Non-Volatile Memory Lock Byte location. This is the low byte of the Non-
Volatile Memory Lock Word.
3.
Start the NVM Lock Bit write operation by writing a dummy byte to the high byte of the NVM Lock Word
location.
4.
Wait until the NVMBSY bit has been cleared.
15.5
Self programming
The ATtiny4/5/9/10 don't support internal programming.
15.6
External Programming
The method for programming the Non-Volatile Memories by means of an external programmer is referred to as
external programming. External programming can be done both in-system or in mass production.
The Non-Volatile Memories can be externally programmed via the Tiny Programming Interface (TPI). For details
on the TPI, see “Programming interface” on page 95. Using the TPI, the external programmer can access the NVM
control and status registers mapped to I/O space and the NVM memory mapped to data memory space.
15.6.1
Entering External Programming Mode
The TPI must be enabled before external programming mode can be entered. The following procedure describes,
how to enter the external programming mode after the TPI has been enabled:
1.
Make a request for enabling NVM programming by sending the NVM memory access key with the SKEY
instruction.
2.
Poll the status of the NVMEN bit in TPISR until it has been set.
相關PDF資料 |
PDF描述 |
|---|---|
| MT80C31-25D | 8-BIT, 25 MHz, MICROCONTROLLER, PQFP44 |
| MS80C31-20D | 8-BIT, 20 MHz, MICROCONTROLLER, PQCC44 |
| MS80C51T-20D | 8-BIT, MROM, 20 MHz, MICROCONTROLLER, PQCC44 |
| MT80C51T-20R | 8-BIT, MROM, 20 MHz, MICROCONTROLLER, PQFP44 |
| MS80C51-25D | 8-BIT, MROM, 25 MHz, MICROCONTROLLER, PQCC44 |
相關代理商/技術參數 |
參數描述 |
|---|---|
| MP81 | 制造商:未知廠家 制造商全稱:未知廠家 功能描述:BRIDGE RECTIFIERS |
| MP810 | 制造商:GOOD-ARK 制造商全稱:GOOD-ARK Electronics 功能描述:SILICON BRIDGE RECTIFIERS |
| MP-810 | 制造商:JAMECO BENCHPRO 功能描述:4-Piece Plier/Cutter/Screwdrivers Set |
| MP8100 | 制造商:MPS 制造商全稱:Monolithic Power Systems 功能描述:Precision High-Side Current-Sense Amplifier |
| MP8100DS | 制造商:MPS 制造商全稱:Monolithic Power Systems 功能描述:Precision High-Side Current-Sense Amplifier |
發布緊急采購，3分鐘左右您將得到回復。