參數資料
型號： MPC8245LZU333B
廠商： MOTOROLA INC
元件分類： 微控制器/微處理器
英文描述： 32-BIT, 333 MHz, RISC PROCESSOR, PBGA352
封裝： 35 X 35 MM, 1.65 MM HEIGHT, 1.27 MM PITCH, CAVITY-UP, TBGA-352
文件頁數： 33/64頁
文件大小： 940K
代理商： MPC8245LZU333B
MOTOROLA
MPC8245 Integrated Processor Hardware Specifications
39
PLL Configuration
1.6
PLL Configuration
The internal PLLs of the MPC8245 are configured by the PLL_CFG[0:4] signals. For a given
PCI_SYNC_IN (PCI bus) frequency, the PLL configuration signals set both the peripheral logic/memory
bus PLL (VCO) frequency of operation for the PCI-to-memory frequency multiplying and the MPC603e
CPU PLL (VCO) frequency of operation for memory-to-CPU frequency multiplying. The PLL
configurations for the MPC8245 is shown in Table 18 and Table 19.
DA[14:15]
F1 J2
Output
GVDD
DRV_MEM_CTRL
2, 6
Notes:
1.
Place a pull-up resistor of 120
or less on the TEST0 pin.
2.
Treat these pins as no connects (NC) unless using debug address functionality.
3.
This pin has an internal pull-up resistor which is enabled only when the MPC8245 is in the reset state. The value
of the internal pull-up resistor is not guaranteed, but is sufficient to ensure that a logic 1 is read into configuration
bits during reset.
4.
This pin is a reset configuration pin.
5.
DL[0] is a reset configuration pin and has an internal pull-up resistor which is enabled only when the MPC8245 is
in the reset state. The value of the internal pull-up resistor is not guaranteed, but is sufficient to ensure that a logic 1
is read into configuration bits during reset.
6.
Multi-pin signals such as AD[31:0] or MDL[0:31] have their physical package pin numbers listed in order,
corresponding to the signal names. Example: AD0 is on pin C22, AD1 is on pin D22, ..., AD31 is on pin V25.
7.
GNT4 is a reset configuration pin and has an internal pull-up resistor which is enabled only when the MPC8245 is
in the reset state.
8.
Recommend a weak pull-up resistor (2–10 k
) be placed on this PCI control pin to LVDD.
9.
VIH and VIL for these signals are the same as the PCI VIH and VIL entries in Table 3.
10. Recommend a weak pull-up resistor (2–10 k
) be placed on this pin to OVDD.
11. Recommend a weak pull-up resistor (2–10 k
) be placed on this pin to GVDD.
12. This pin has an internal pull-up resistor which is enabled at all times. The value of the internal pull-up resistor is
not guaranteed, but is sufficient to prevent unused inputs from floating.
13. External PCI clocking source or fan-out buffer may be required for system if using the MPC8245 DUART
functionality since PCI_CLK[0:3] are not available in DUART mode. Only PCI_CLK4 is available in DUART mode.
14. This pin is a multiplexed signal and appears more than once in this table.
15. This pin is affected by programmable PCI_HOLD_DEL parameter.
16. This pin is an open drain signal.
17. This pin can be programmed to be driven (default) or can be programmed (in PMCR2) to be open drain.
18. This pin is a sustained three-state pin as defined by the PCI Local Bus Specification.
19. OSC_IN utilizes the 3.3-V PCI interface driver which is 5-V tolerant, see Table 2 for details.
20. PLL_CFG[0:4] signals are sampled a few clocks after the negation of HRST_CPU and HRST_CTRL.
21. SDRAM_CLK[0:3] and SDRAM_SYNC_OUT signals use DRV_MEM_CTRL for chip Rev 1.1 (A). These signals
use DRV_MEM_CLK for chip Rev 1.2 (B).
22. The 266- and 300-MHz part offerings can be run at a source voltage of 1.8 ± 100 mV or 2.0 ± 100 mV. Note that
source voltage should be 2.0 ± 100 mV for 333- and 350-MHz parts.
23. This pin was formally LAVDD on the MPC8240. It is a no connect on the MPC8245. This should not pose a problem
when replacing an MPC8240 with an MPC8245.
24. The driver capability of this pin is hardwired to 40
and cannot be changed.
Table 17. MPC8245 Pinout Listing (continued)
Name
Pin Number
Type
Power
Supply
Output
Driver Type
Notes
相關PDF資料
PDF描述
MPC8245LZU300B 32-BIT, 300 MHz, RISC PROCESSOR, PBGA352
MPC8245LZU266B 32-BIT, 266 MHz, RISC PROCESSOR, PBGA352
MPC8260ACZUMIBB 32-BIT, 266 MHz, RISC PROCESSOR, PBGA480
MPC8260AZUPIBB 32-BIT, 300 MHz, RISC PROCESSOR, PBGA480
MPC8260AZUPJDB 32-BIT, 300 MHz, RISC PROCESSOR, PBGA480
相關代理商/技術參數
參數描述
MPC8245LZU333D 功能描述:微處理器 - MPU 333MHz 632.7MIPS RoHS:否 制造商:Atmel 處理器系列:SAMA5D31 核心:ARM Cortex A5 數據總線寬度:32 bit 最大時鐘頻率:536 MHz 程序存儲器大小:32 KB 數據 RAM 大小:128 KB 接口類型:CAN, Ethernet, LIN, SPI,TWI, UART, USB 工作電源電壓:1.8 V to 3.3 V 最大工作溫度:+ 85 C 安裝風格:SMD/SMT 封裝 / 箱體:FBGA-324
MPC8245LZU350D 功能描述:微處理器 - MPU 350MHz 665MIPS RoHS:否 制造商:Atmel 處理器系列:SAMA5D31 核心:ARM Cortex A5 數據總線寬度:32 bit 最大時鐘頻率:536 MHz 程序存儲器大小:32 KB 數據 RAM 大小:128 KB 接口類型:CAN, Ethernet, LIN, SPI,TWI, UART, USB 工作電源電壓:1.8 V to 3.3 V 最大工作溫度:+ 85 C 安裝風格:SMD/SMT 封裝 / 箱體:FBGA-324
MPC8245RZU400D 制造商:FREESCALE 制造商全稱:Freescale Semiconductor, Inc 功能描述:Part Number Specification for the MPC8245ARZUnnnX Series
MPC8245TVV266D 功能描述:微處理器 - MPU INTEGRATED HOST PROC RoHS:否 制造商:Atmel 處理器系列:SAMA5D31 核心:ARM Cortex A5 數據總線寬度:32 bit 最大時鐘頻率:536 MHz 程序存儲器大小:32 KB 數據 RAM 大小:128 KB 接口類型:CAN, Ethernet, LIN, SPI,TWI, UART, USB 工作電源電壓:1.8 V to 3.3 V 最大工作溫度:+ 85 C 安裝風格:SMD/SMT 封裝 / 箱體:FBGA-324
MPC8245TVV300D 功能描述:微處理器 - MPU INTEGRATED HOST PROC RoHS:否 制造商:Atmel 處理器系列:SAMA5D31 核心:ARM Cortex A5 數據總線寬度:32 bit 最大時鐘頻率:536 MHz 程序存儲器大小:32 KB 數據 RAM 大小:128 KB 接口類型:CAN, Ethernet, LIN, SPI,TWI, UART, USB 工作電源電壓:1.8 V to 3.3 V 最大工作溫度:+ 85 C 安裝風格:SMD/SMT 封裝 / 箱體:FBGA-324
發布緊急采購，3分鐘左右您將得到回復。

采購需求

(若只采購一條型號，填寫一行即可)

發布成功！您可以繼續發布采購。也可以進入我的后臺，查看報價

發布成功！您可以繼續發布采購。也可以進入我的后臺，查看報價

*型號 *數量 廠商 批號 封裝
添加更多采購

我的聯系方式

*
*
*