- 您現在的位置：買賣IC網 > PDF目錄378017 > MSM7557 (OKI SEMICONDUCTOR CO., LTD.) Single Chip MSK Modem with Compandor for Cordless Telephone PDF資料下載
參數資料
| 型號： | MSM7557 |
| 廠商： | OKI SEMICONDUCTOR CO., LTD. |
| 英文描述： | Single Chip MSK Modem with Compandor for Cordless Telephone |
| 中文描述： | 單芯片MSK調制解調器無繩電話與Compandor |
| 文件頁數： | 6/25頁 |
| 文件大?。?/td> | 153K |
| 代理商： | MSM7557 |
6/25
MSM7557
Semiconductor
(Continued)
Name
Description
ME
TVE
TAO
X : Don't care
RVE
RVO
0
1
Output disable (potential = SG)
Output enable
CMPI
DYN
SG
GND
TAO
RVO
CE1
CE2
CE3N
CE3P
RAIO
RAI
CSH
0
0
1
0
1
X
No signal output (potential = SG)
Voice signal output
MSK modulator output
Compressor circuit input.
A 0.47
m
F capacitor should be connected between CMPI and TVIO.
Dynamic range control input.
For an application of which V
DD
is always higher than 4.5 V (Base station), by setting DYN = "1",
modem transmit carrier level, typical input signal level, limiter clamp level and compandor
standard input level are up about 8dB to improve S/N ratio.
For an application of which V
DD
is lower than 4.5 V (Hand-set) DYN shall be digital "0".
To make easier interface with the RF part, one solution is to put digital "0" on DYN pin for both Base
station and Handset.
Built-in analog signal ground. The DC voltage is half of V
DD
.
To make this voltage source impedance lower and to ensure the device performance, it is necessary to
put a bypass capacitor of more than 1
m
F between SG and V
DD
in close physical proximity to the device.
Ground pin, (0V).
Transmit analog signal output.
According to control data on ME and TVE, TAO is set as follows.
Receive voice signal output.
RVO pin state is defined by RVE control.
Capacitor connection pins to remove DC offset of the expander.
A 1
m
F capacitor between SG pin and each pin should be connected.
Capacitor connection pins for the expander attack time and recovery time.
When DYN is digital "0" level, a 0.22
m
F capacitor should be connected between CE3N and CE3P.
And when DYN is digital "1" level, a 0.47
m
F capacitor should be connected between them.
Receive side amplifier input (RAI) and output (RAIO).
Second order RC-active filter is needed like TVIO and TVI.
Refer to TVIO and TVI pin description.
Capacitor connection pin to remove DC offset of the modem shaper circuit.
A 1
m
F capacitor should be connected between GND pin and CSH.
相關PDF資料 |
PDF描述 |
|---|---|
| MSM7564-01 | CONNECTOR ACCESSORY |
| MSM7570-01 | Multi-Function ADPCM CODEC(多功能ADPCM編碼譯碼器) |
| MSM7575 | Multi-Function ADPCM CODEC(多功能ADPCM(自適應差分脈沖編碼調制）編碼譯碼器) |
| MSM7576 | LSI |
| MSM7577 | Voice Signal Level Control LSI |
相關代理商/技術參數 |
參數描述 |
|---|---|
| MSM7560 | 制造商:OKI 制造商全稱:OKI electronic componets 功能描述:Single Rail ADPCM CODEC |
| MSM7560L | 制造商:OKI 制造商全稱:OKI electronic componets 功能描述:Single Rail ADPCM CODEC |
| MSM7564-01 | 制造商:OKI 制造商全稱:OKI electronic componets 功能描述:A Single Chip 14.4 kbps Data & Fax Modem |
| MSM7566 | 制造商:OKI 制造商全稱:OKI electronic componets 功能描述:Single Rail CODEC |
| MSM7566GS-K | 制造商:OKI 制造商全稱:OKI electronic componets 功能描述:Single Rail CODEC |
發布緊急采購，3分鐘左右您將得到回復。