參數資料
型號: MSP430F5508IPT
廠商: TEXAS INSTRUMENTS INC
元件分類: 微控制器/微處理器
英文描述: 16-BIT, FLASH, 25 MHz, RISC MICROCONTROLLER, PQCC48
封裝: PLASTIC, VQFN-48
文件頁數: 49/99頁
文件大?。?/td> 1134K
代理商: MSP430F5508IPT
PRODUCTPREVIEW
MSP430F550x
www.ti.com
SLAS645B – JULY 2009 – REVISED JULY 2010
Crystal Oscillator, XT2
over recommended ranges of supply voltage and operating free-air temperature (unless otherwise noted)
(1) (2)
PARAMETER
TEST CONDITIONS
VCC
MIN
TYP
MAX
UNIT
fOSC = 4 MHz, XT2OFF = 0,
200
XT2BYPASS = 0, XT2DRIVEx = 0, TA = 25°C
fOSC = 12 MHz, XT2OFF = 0,
260
XT2BYPASS = 0, XT2DRIVEx = 1, TA = 25°C
XT2 oscillator crystal current
IDVCC.XT2
3.0 V
A
consumption
fOSC = 20 MHz, XT2OFF = 0,
325
XT2BYPASS = 0, XT2DRIVEx = 2, TA = 25°C
fOSC = 32 MHz, XT2OFF = 0,
450
XT2BYPASS = 0, XT2DRIVEx = 3, TA = 25°C
XT2 oscillator crystal
fXT2,HF0
XT2DRIVEx = 0, XT2BYPASS = 0(3)
4
8
MHz
frequency, mode 0
XT2 oscillator crystal
fXT2,HF1
XT2DRIVEx = 1, XT2BYPASS = 0(3)
8
16
MHz
frequency, mode 1
XT2 oscillator crystal
fXT2,HF2
XT2DRIVEx = 2, XT2BYPASS = 0(3)
16
24
MHz
frequency, mode 2
XT2 oscillator crystal
fXT2,HF3
XT2DRIVEx = 3, XT2BYPASS = 0(3)
24
32
MHz
frequency, mode 3
XT2 oscillator logic-level
fXT2,HF,SW
square-wave input frequency,
XT2BYPASS = 1(4) (3)
1.5
32
MHz
bypass mode
XT2DRIVEx = 0, XT2BYPASS = 0,
450
fXT2,HF0 = 6 MHz, CL,eff = 15 pF
XT2DRIVEx = 1, XT2BYPASS = 0,
320
fXT2,HF1 = 12 MHz, CL,eff = 15 pF
Oscillation allowance for
OAHF
HF crystals(5)
XT2DRIVEx = 2, XT2BYPASS = 0,
200
fXT2,HF2 = 20 MHz, CL,eff = 15 pF
XT2DRIVEx = 3, XT2BYPASS = 0,
200
fXT2,HF3 = 32 MHz, CL,eff = 15 pF
fOSC = 6 MHz,
XT2BYPASS = 0, XT2DRIVEx = 0,
0.5
TA = 25°C, CL,eff = 15 pF
tSTART,HF
Startup time
3.0 V
ms
fOSC = 20 MHz
XT2BYPASS = 0, XT2DRIVEx = 2,
0.3
TA = 25°C, CL,eff = 15 pF
Integrated effective load
CL,eff
1
pF
capacitance, HF mode(6) (1)
Duty cycle
Measured at ACLK, fXT2,HF2 = 20 MHz
40
50
60
%
fFault,HF
Oscillator fault frequency(7)
XT2BYPASS = 1(8)
30
300
kHz
(1)
Requires external capacitors at both terminals. Values are specified by crystal manufacturers.
(2)
To improve EMI on the XT2 oscillator the following guidelines should be observed.
(a) Keep the traces between the device and the crystal as short as possible.
(b) Design a good ground plane around the oscillator pins.
(c) Prevent crosstalk from other clock or data lines into oscillator pins XT2IN and XT2OUT.
(d) Avoid running PCB traces underneath or adjacent to the XT2IN and XT2OUT pins.
(e) Use assembly materials and praxis to avoid any parasitic load on the oscillator XT2IN and XT2OUT pins.
(f) If conformal coating is used, ensure that it does not induce capacitive/resistive leakage between the oscillator pins.
(3)
This represents the maximum frequency that can be input to the device externally. Maximum frequency achievable on the device
operation is based on the frequencies present on ACLK, MCLK, and SMCLK cannot be exceed for a given range of operation.
(4)
When XT2BYPASS is set, the XT2 circuit is automatically powered down. Input signal is a digital square wave with parametrics defined
in the Schmitt-trigger Inputs section of this datasheet.
(5)
Oscillation allowance is based on a safety factor of 5 for recommended crystals.
(6)
Includes parasitic bond and package capacitance (approximately 2 pF per pin).
Since the PCB adds additional capacitance, it is recommended to verify the correct load by measuring the ACLK frequency. For a
correct setup, the effective load capacitance should always match the specification of the used crystal.
(7)
Frequencies below the MIN specification set the fault flag. Frequencies above the MAX specification do not set the fault flag.
Frequencies in between might set the flag.
(8)
Measured with logic-level input frequency but also applies to operation with crystals.
Copyright 2009–2010, Texas Instruments Incorporated
53
相關PDF資料
PDF描述
MSP430F5510IRGC 16-BIT, FLASH, 25 MHz, RISC MICROCONTROLLER, PQCC64
MSP430F5505IRGZ 16-BIT, FLASH, 25 MHz, RISC MICROCONTROLLER, PQCC48
MSP430F5513IZQE 16-BIT, FLASH, 25 MHz, RISC MICROCONTROLLER, PBGA80
MSP430F5527IPN 16-BIT, FLASH, 25 MHz, RISC MICROCONTROLLER, PQFP80
MSP430F5519IPN 16-BIT, FLASH, 25 MHz, RISC MICROCONTROLLER, PQFP80
相關代理商/技術參數
參數描述
MSP430F5508IPTR 功能描述:16位微控制器 - MCU Mixed Signal MCU RoHS:否 制造商:Texas Instruments 核心:RISC 處理器系列:MSP430FR572x 數據總線寬度:16 bit 最大時鐘頻率:24 MHz 程序存儲器大小:8 KB 數據 RAM 大小:1 KB 片上 ADC:Yes 工作電源電壓:2 V to 3.6 V 工作溫度范圍:- 40 C to + 85 C 封裝 / 箱體:VQFN-40 安裝風格:SMD/SMT
MSP430F5508IRGCR 功能描述:16位微控制器 - MCU Mixed Signal MCU RoHS:否 制造商:Texas Instruments 核心:RISC 處理器系列:MSP430FR572x 數據總線寬度:16 bit 最大時鐘頻率:24 MHz 程序存儲器大小:8 KB 數據 RAM 大小:1 KB 片上 ADC:Yes 工作電源電壓:2 V to 3.6 V 工作溫度范圍:- 40 C to + 85 C 封裝 / 箱體:VQFN-40 安裝風格:SMD/SMT
MSP430F5508IRGCT 功能描述:16位微控制器 - MCU Mixed Signal MCU RoHS:否 制造商:Texas Instruments 核心:RISC 處理器系列:MSP430FR572x 數據總線寬度:16 bit 最大時鐘頻率:24 MHz 程序存儲器大小:8 KB 數據 RAM 大小:1 KB 片上 ADC:Yes 工作電源電壓:2 V to 3.6 V 工作溫度范圍:- 40 C to + 85 C 封裝 / 箱體:VQFN-40 安裝風格:SMD/SMT
MSP430F5508IRGZR 功能描述:16位微控制器 - MCU Mixed Signal Micro controller RoHS:否 制造商:Texas Instruments 核心:RISC 處理器系列:MSP430FR572x 數據總線寬度:16 bit 最大時鐘頻率:24 MHz 程序存儲器大小:8 KB 數據 RAM 大小:1 KB 片上 ADC:Yes 工作電源電壓:2 V to 3.6 V 工作溫度范圍:- 40 C to + 85 C 封裝 / 箱體:VQFN-40 安裝風格:SMD/SMT
MSP430F5508IRGZT 功能描述:16位微控制器 - MCU Mixed Signal MCU RoHS:否 制造商:Texas Instruments 核心:RISC 處理器系列:MSP430FR572x 數據總線寬度:16 bit 最大時鐘頻率:24 MHz 程序存儲器大小:8 KB 數據 RAM 大小:1 KB 片上 ADC:Yes 工作電源電壓:2 V to 3.6 V 工作溫度范圍:- 40 C to + 85 C 封裝 / 箱體:VQFN-40 安裝風格:SMD/SMT