- 您現在的位置：買賣IC網 > PDF目錄383644 > MT9043 (Mitel Networks Corporation) T1/E1 System Synchronizer(T1/E1 系統同步裝置（由一個數字鎖相環組成）) PDF資料下載
參數資料
| 型號： | MT9043 |
| 廠商： | Mitel Networks Corporation |
| 英文描述： | T1/E1 System Synchronizer(T1/E1 系統同步裝置（由一個數字鎖相環組成）) |
| 中文描述： | T1/E1的系統同步（T1/E1的系統同步裝置（由一個數字鎖相環組成）） |
| 文件頁數： | 4/24頁 |
| 文件大?。?/td> | 100K |
| 代理商： | MT9043 |
MT9043
Advance Information
4
40
FS2
Frequency Select 2 (Input).
This input, in conjunction with FS1, selects which of four
possible frequencies (8kHz, 1.544MHz, 2.048MHz or 19.44MHz) may be input to the PRI and
SEC inputs. See Table 1.
41
FS1
Frequency Select 1 (Input).
See pin description for FS2.
42
IC
Internal Connection.
Tie Low for Normal Operation.
43
IC
Internal Connection.
Leave Open Circuit.
44
TDO
Test Serial Data Out (CMOS Output).
JTAG serial data is output on this pin on the falling
edge of TCK. This pin is held in high impedance state when JTAG scan is not enabled.
45
TDI
Test Serial Data In (Input).
JTAG serial test instructions and data are shifted in on this pin.
This pin is internally pulled up to V
DD
.
Test Reset (Input).
Asynchronously initializes the JTAG TAP controller by putting it in the
Test-Logic-Reset state.
46
TRST
47
TCK
Test Clock (Input).
Provides the clock to the JTAG test logic. This pin is internally pulled up
to V
DD
.
Test Mode Select (Input).
JTAG signal that controls the state transitions of the TAP
controller. This pin is internally pulled up to V
DD
.
48
TMS
Pin Description
Pin #
Name
Description
Functional Description
The MT9043 is a Multitrunk System Synchronizer,
providing timing (clock) and synchronization (frame)
signals to interface circuits for T1 and E1 Primary
Rate Digital Transmission links. Figure 1 is a
functional block diagram which is described in the
following sections.
Reference Select MUX Circuit
The MT9043 accepts two simultaneous reference
input signals and operates on their falling edges.
Either the primary reference (PRI) signal or the
secondary reference (SEC) signal can be selected
as input to the TIE Corrector Circuit. The selection is
based
on
the
Control,
Selection of the device. See Table 1 and Table 4.
Mode
and
Reference
Frequency Select MUX Circuit
The MT9043 operates with one of four possible input
reference frequencies (8kHz, 1.544MHz, 2.048MHz
or 19.44MHz). The frequency select inputs (FS1 and
FS2) determine which of the
be used at the reference inputs (PRI and SEC). Both
inputs must have the same frequency applied to
them. A reset (RST) must be performed after every
frequency select input change. See Table 1.
four frequencies may
Table 1 - Input Frequency Selection
Time Interval Error (TIE) Corrector Circuit
The TIE corrector circuit, when enabled, prevents a
step change in phase on the input reference signals
(PRI or SEC) from causing a step change in phase at
the input of the DPLL block of Figure 1.
During reference input rearrangement, such as
during a switch from the primary reference (PRI) to
the secondary reference (SEC), a step change in
phase on the input signals will occur. A phase step at
the input of the DPLL would lead to unacceptable
phase changes in the output signal.
As shown in Figure 3, the TIE Corrector Circuit
receives one of the two reference (PRI or SEC)
signals, passes the signal through a programmable
delay line, and uses this delayed signal as an
internal virtual reference, which is input to the DPLL.
Therefore, the virtual reference is a delayed version
of the selected reference.
FS2
FS1
Input Frequency
0
0
19.44MHz
0
1
8kHz
1
0
1.544MHz
1
1
2.048MHz
相關PDF資料 |
PDF描述 |
|---|---|
| MT9044 | T1/E1/OC3 System Synchronizer(T1/E1/OC3 系統同步裝置（由一個數字鎖相環組成）) |
| MT90500 | Multi-Channel ATM AAL1 SAR(多通道 ATM AAL1分段及重組設備（基于通訊總線的系統與ATM網絡的接口）) |
| MT90500 | Multi-Channel ATM AAL1 SAR |
| MT90500AL | Multi-Channel ATM AAL1 SAR |
| MT90502 | Multi-Channel AAL2 SAR(多通道 ATM AAL2分段及重組設備（基于通訊總線的系統與ATM網絡的接口）) |
相關代理商/技術參數 |
參數描述 |
|---|---|
| MT9043AN | 制造商:Microsemi Corporation 功能描述: |
| MT9043AN1 | 制造商:Microsemi Corporation 功能描述:PB FREE T1/E1 SYSTEM SYNCHRONIZER 制造商:Microsemi Corporation 功能描述:FRAMER E1/T1 3.3V 48SSOP - Rail/Tube 制造商:MICROSEMI CONSUMER MEDICAL PRODUCT GROUP 功能描述:IC SYNCHRONIZER T1/E1 48SSOP 制造商:Microsemi Corporation 功能描述:IC SYNCHRONIZER T1/E1 48SSOP |
| MT9043AN48PINSSOP | 制造商:ZARLINK 制造商全稱:Zarlink Semiconductor Inc 功能描述:T1/E1 System Synchronizer |
| MT9043ANR1 | 制造商:Microsemi Corporation 功能描述:FRAMER E1 /T1 3.3V 48SSOP - Tape and Reel 制造商:MICROSEMI CONSUMER MEDICAL PRODUCT GROUP 功能描述:IC SYNCHRONIZER T1/E1 48SSOP 制造商:Microsemi Corporation 功能描述:IC SYNCHRONIZER T1/E1 48SSOP |
| MT9044 | 制造商:MITEL 制造商全稱:Mitel Networks Corporation 功能描述:T1/E1/OC3 System Synchronizer |
發布緊急采購，3分鐘左右您將得到回復。