- 您現在的位置：買賣IC網 > PDF目錄98046 > MTDF1P02HDR2 (ON SEMICONDUCTOR) 1600 mA, 20 V, 2 CHANNEL, P-CHANNEL, Si, SMALL SIGNAL, MOSFET PDF資料下載
參數資料
| 型號： | MTDF1P02HDR2 |
| 廠商： | ON SEMICONDUCTOR |
| 元件分類： | 小信號晶體管 |
| 英文描述： | 1600 mA, 20 V, 2 CHANNEL, P-CHANNEL, Si, SMALL SIGNAL, MOSFET |
| 封裝： | MICROPAK-8 |
| 文件頁數： | 8/12頁 |
| 文件大?。?/td> | 137K |
| 代理商： | MTDF1P02HDR2 |
MTDF1P02HD
http://onsemi.com
5
POWER MOSFET SWITCHING
Switching behavior is most easily modeled and predicted
by recognizing that the power MOSFET is charge
controlled. The lengths of various switching intervals (
t)
are determined by how fast the FET input capacitance can
be charged by current from the generator.
The published capacitance data is difficult to use for
calculating rise and fall because drain–gate capacitance
varies greatly with applied voltage. Accordingly, gate
charge data is used. In most cases, a satisfactory estimate of
average input current (IG(AV)) can be made from a
rudimentary analysis of the drive circuit so that
t = Q/IG(AV)
During the rise and fall time interval when switching a
resistive load, VGS remains virtually constant at a level
known as the plateau voltage, VSGP. Therefore, rise and fall
times may be approximated by the following:
tr = Q2 x RG/(VGG – VGSP)
tf = Q2 x RG/VGSP
where
VGG = the gate drive voltage, which varies from zero to VGG
RG = the gate drive resistance
and Q2 and VGSP are read from the gate charge curve.
During the turn–on and turn–off delay times, gate current is
not constant. The simplest calculation uses appropriate
values from the capacitance curves in a standard equation for
voltage change in an RC network. The equations are:
td(on) = RG Ciss In [VGG/(VGG – VGSP)]
td(off) = RG Ciss In (VGG/VGSP)
The capacitance (Ciss) is read from the capacitance curve at
a voltage corresponding to the off–state condition when
calculating td(on) and is read at a voltage corresponding to the
on–state when calculating td(off).
At high switching speeds, parasitic circuit elements
complicate the analysis. The inductance of the MOSFET
source lead, inside the package and in the circuit wiring
which is common to both the drain and gate current paths,
produces a voltage at the source which reduces the gate drive
current. The voltage is determined by Ldi/dt, but since di/dt
is a function of drain current, the mathematical solution is
complex.
The
MOSFET
output
capacitance
also
complicates the mathematics. And finally, MOSFETs have
finite internal gate resistance which effectively adds to the
resistance of the driving source, but the internal resistance
is difficult to measure and, consequently, is not specified.
The resistive switching time variation versus gate
resistance (Figure 9) shows how typical switching
performance is affected by the parasitic circuit elements. If
the parasitics were not present, the slope of the curves would
maintain a value of unity regardless of the switching speed.
The circuit used to obtain the data is constructed to minimize
common inductance in the drain and gate circuit loops and
is believed readily achievable with board mounted
components. Most power electronic loads are inductive; the
data in the figure is taken with a resistive load, which
approximates an optimally snubbed inductive load. Power
MOSFETs may be safely operated into an inductive load;
however, snubbing reduces switching losses.
Figure 9. Capacitance Variation
10
20
-10
VDS, DRAIN-TO-SOURCE VOLTAGE (VOLTS)
800
600
400
C,
CAP
ACIT
ANCE
(pF)
200
0
Ciss
Crss
Coss
TJ = 25°C
VGS = 0 V
VGS VDS
相關PDF資料 |
PDF描述 |
|---|---|
| MTDF2N06HDR2 | 1500 mA, 60 V, 2 CHANNEL, N-CHANNEL, Si, SMALL SIGNAL, MOSFET |
| MTDF2N06HD | 1500 mA, 60 V, 2 CHANNEL, N-CHANNEL, Si, SMALL SIGNAL, MOSFET |
| MTM23224 | 1200 mA, 20 V, N-CHANNEL, Si, SMALL SIGNAL, MOSFET |
| MTM24N50E | 24 A, 500 V, 0.25 ohm, N-CHANNEL, Si, POWER, MOSFET, TO-204AE |
| MHM25N10HX | 25 A, 100 V, 0.065 ohm, N-CHANNEL, Si, POWER, MOSFET, TO-254AA |
相關代理商/技術參數 |
參數描述 |
|---|---|
| MTDF2N06HDR2 | 制造商:Rochester Electronics LLC 功能描述:- Bulk 制造商:Motorola Inc 功能描述: |
| MTD-H5 | 功能描述:HSPA+ USB CELLULAR MODEM 制造商:multi-tech systems 系列:QuickCarrier? USB-D 零件狀態:Not Recommended For New Designs 功能:收發器，HSPA，調制解調器 調制或協議:HSPA+ 頻率:850MHz，900MHz，1.7GHz，1.9GHz，2.1GHz 應用:- 接口:USB 靈敏度:- 功率 - 輸出:- 數據速率（最大值）:21Mbps 特性:USB 供電 電壓 - 電源:5V，USB 標準包裝:10 |
| MTD-H5-2.0 | 功能描述:HSPA+ USB CELLULAR MODEM 制造商:multi-tech systems 系列:- 零件狀態:有效 功能:- 調制或協議:HSPA+ 頻率:850MHz，900MHz，1.7GHz，1.8GHz，1.9GHz，2.1GHz 應用:通用 接口:USB 靈敏度:- 功率 - 輸出:- 數據速率（最大值）:21Mbps 特性:- 電壓 - 電源:5V 標準包裝:10 |
| MTDK1S6R | 制造商:CYSTEKEC 制造商全稱:Cystech Electonics Corp. 功能描述:N-CHANNEL MOSFET (dual transistors) |
| MTDK3S6R | 制造商:CYSTEKEC 制造商全稱:Cystech Electonics Corp. 功能描述:ESD protected N-CHANNEL MOSFET |
發布緊急采購，3分鐘左右您將得到回復。