- 您現在的位置：買賣IC網 > PDF目錄367627 > P1803ACRP SIDAC|210V V(BO) MAX|800MA I(S)|TO-220VAR PDF資料下載
參數資料
| 型號： | P1803ACRP |
| 英文描述： | SIDAC|210V V(BO) MAX|800MA I(S)|TO-220VAR |
| 中文描述： | SIDAC的|高達210V五（公報）最大| 800mA的我（縣）|對220VAR |
| 文件頁數： | 93/161頁 |
| 文件大?。?/td> | 986K |
| 代理商： | P1803ACRP |
第1頁第2頁第3頁第4頁第5頁第6頁第7頁第8頁第9頁第10頁第11頁第12頁第13頁第14頁第15頁第16頁第17頁第18頁第19頁第20頁第21頁第22頁第23頁第24頁第25頁第26頁第27頁第28頁第29頁第30頁第31頁第32頁第33頁第34頁第35頁第36頁第37頁第38頁第39頁第40頁第41頁第42頁第43頁第44頁第45頁第46頁第47頁第48頁第49頁第50頁第51頁第52頁第53頁第54頁第55頁第56頁第57頁第58頁第59頁第60頁第61頁第62頁第63頁第64頁第65頁第66頁第67頁第68頁第69頁第70頁第71頁第72頁第73頁第74頁第75頁第76頁第77頁第78頁第79頁第80頁第81頁第82頁第83頁第84頁第85頁第86頁第87頁第88頁第89頁第90頁第91頁第92頁當前第93頁第94頁第95頁第96頁第97頁第98頁第99頁第100頁第101頁第102頁第103頁第104頁第105頁第106頁第107頁第108頁第109頁第110頁第111頁第112頁第113頁第114頁第115頁第116頁第117頁第118頁第119頁第120頁第121頁第122頁第123頁第124頁第125頁第126頁第127頁第128頁第129頁第130頁第131頁第132頁第133頁第134頁第135頁第136頁第137頁第138頁第139頁第140頁第141頁第142頁第143頁第144頁第145頁第146頁第147頁第148頁第149頁第150頁第151頁第152頁第153頁第154頁第155頁第156頁第157頁第158頁第159頁第160頁第161頁
SIDACtor
Data Book
FCC PART 68
Teccor Electronics
(972) 580-7777
4 - 19
R
R
8%(4
Overview
FCC Part 68 applies to all terminal equipment that is connected to the public network
and is unique in the fact that it is mandated by U.S. law.
The purpose of FCC Part 68 is to provide a set of uniform standards that will protect
the telephone network from any damage or interference caused by the connection of
terminal equipment. The FCC standard includes environmental simulations such as
vibration tests, temperature and humidity cycling, drop tests and tests for hazardous
voltages and currents, as well as tests for signal power levels, line balance, on-hook
impedance, and billing protection; all of which must be met before and after the
environmental tests are applied.
Over-Voltage Test
FCC compliant equipment must undergo an over-voltage test that includes a Type A
and Type B Metallic Voltage Surge and a Type A and Type B Longitudinal Voltage
Surge. These surges are part of FCC's environmental simulation, and although there is
a provision which allows the EUT to reach an open circuit failure mode during the Type
A tests, failures must:
1. Arise from an intentional design which will cause the phone to be either
disconnected from the public network or repaired rapidly.
2. Be designed such that it is substantially apparent to the end user that the
terminal equipment is not operable. A common example of an acceptable
failure would be an open circuit due to an open connection on either Tip or
Ring.
For Type B surges, equipment protection circuitry is not allowed to fail. The EUT must
be designed to withstand Type B surges and continue to function in all operational
states.
Metallic Voltage Surge
The Type A and Type B Metallic Voltage Surges are applied in both the positive and
negative polarity across Tip and Ring during all operational states (on-hook, off-hook,
ringing, etc.). The Type A surge is an 800V, 100A peak surge while the Type B surge is
a 1000V, 25A peak surge (Table 4-16).
Longitudinal Voltage Surge
The Type A and Type B Longitudinal Voltage Surges are applied in both positive and
negative polarity during all operational states. The Type A surge is a 1500V, 200A
peak surge applied to the EUT with Tip and Ring tied together with respect to ground.
The Type B Longitudinal Voltage Surge is a simultaneous surge in which 1500V and
37.5A are applied to Tip with respect to ground and Ring with respect to ground
concurrently (Table 4-16).
相關PDF資料 |
PDF描述 |
|---|---|
| P2200AA61RP | 16-pin, 1.75KB, Flash, 72B RAM, 2x Comparator, 8HMz internal osc,Hi Volt Support, -40C to +85C, 14-PDIP, TUBE |
| P2202AA | 16 PIN, 1.75KB FLASH, 64B RAM, 6 I/O, 8MHZ INTERNAL OSCILLATOR, -40C to +125C, 16-QFN, T/R |
| P2202AARP | 14 PIN, 4KB FLASH, 128 RAM, 12 I/O, -40C to +85C, 16-QFN, T/R |
| P2202AB | 14 PIN, 4KB FLASH, 128 RAM, 12 I/O, -40C to +85C, 14-TSSOP, T/R |
| P2202ABRP | SIDAC|130V V(BO) MAX|800MA I(S)|TO-220VAR |
相關代理商/技術參數 |
參數描述 |
|---|---|
| P1803U | 制造商:TECCOR 制造商全稱:TECCOR 功能描述:solid state crowbar devices |
| P1803U_L | 制造商:LITTELFUSE 制造商全稱:Littelfuse 功能描述:Balanced Three-chip SIDACtor |
| P1803UALRP | 功能描述:硅對稱二端開關元件 3Chp 150V 50A RoHS:否 制造商:Bourns 轉折電流 VBO:40 V 最大轉折電流 IBO:800 mA 不重復通態電流: 額定重復關閉狀態電壓 VDRM:25 V 關閉狀態漏泄電流（在 VDRM IDRM 下）: 保持電流（Ih 最大值）:50 mA 開啟狀態電壓:5 V 關閉狀態電容 CO:120 pF 最大工作溫度:+ 150 C 安裝風格:SMD/SMT 封裝 / 箱體:DO-214AA |
| P1803UALTP | 功能描述:硅對稱二端開關元件 3Chp 150V 50A RoHS:否 制造商:Bourns 轉折電流 VBO:40 V 最大轉折電流 IBO:800 mA 不重復通態電流: 額定重復關閉狀態電壓 VDRM:25 V 關閉狀態漏泄電流（在 VDRM IDRM 下）: 保持電流（Ih 最大值）:50 mA 開啟狀態電壓:5 V 關閉狀態電容 CO:120 pF 最大工作溫度:+ 150 C 安裝風格:SMD/SMT 封裝 / 箱體:DO-214AA |
| P1803UALXX | 制造商:LITTELFUSE 制造商全稱:Littelfuse 功能描述:The series provides a single port surface mount solution that enables voice |
發布緊急采購，3分鐘左右您將得到回復。