- 您現在的位置：買賣IC網 > PDF目錄367627 > P2500AA61RP MCU CMOS 80 LD 33MHZ 8K EPRM, 0C to +70C, 80-TQFP, TRAY PDF資料下載
參數資料
| 型號： | P2500AA61RP |
| 英文描述： | MCU CMOS 80 LD 33MHZ 8K EPRM, 0C to +70C, 80-TQFP, TRAY |
| 中文描述： | SIDAC的| 290V五（公報）最大| 800mA的我（縣）|對220VAR |
| 文件頁數： | 79/161頁 |
| 文件大?。?/td> | 986K |
| 代理商： | P2500AA61RP |
第1頁第2頁第3頁第4頁第5頁第6頁第7頁第8頁第9頁第10頁第11頁第12頁第13頁第14頁第15頁第16頁第17頁第18頁第19頁第20頁第21頁第22頁第23頁第24頁第25頁第26頁第27頁第28頁第29頁第30頁第31頁第32頁第33頁第34頁第35頁第36頁第37頁第38頁第39頁第40頁第41頁第42頁第43頁第44頁第45頁第46頁第47頁第48頁第49頁第50頁第51頁第52頁第53頁第54頁第55頁第56頁第57頁第58頁第59頁第60頁第61頁第62頁第63頁第64頁第65頁第66頁第67頁第68頁第69頁第70頁第71頁第72頁第73頁第74頁第75頁第76頁第77頁第78頁當前第79頁第80頁第81頁第82頁第83頁第84頁第85頁第86頁第87頁第88頁第89頁第90頁第91頁第92頁第93頁第94頁第95頁第96頁第97頁第98頁第99頁第100頁第101頁第102頁第103頁第104頁第105頁第106頁第107頁第108頁第109頁第110頁第111頁第112頁第113頁第114頁第115頁第116頁第117頁第118頁第119頁第120頁第121頁第122頁第123頁第124頁第125頁第126頁第127頁第128頁第129頁第130頁第131頁第132頁第133頁第134頁第135頁第136頁第137頁第138頁第139頁第140頁第141頁第142頁第143頁第144頁第145頁第146頁第147頁第148頁第149頁第150頁第151頁第152頁第153頁第154頁第155頁第156頁第157頁第158頁第159頁第160頁第161頁
SIDACtor
Data Book
GR 1089-Core
Teccor Electronics
(972) 580-7777
4 - 5
R
R
Passing Criteria
Passing criteria for the First Level Lightning Surge Test and the First Level AC Power
Fault Test is that the EUT will not be damaged and it will operate as intended after the
stress is removed. Passing criteria for the Second Level Lightning Surge Test and
Second Level AC Power Fault Test is that the EUT may be damaged, but it may not
become a fire, fragmentation, or electrical safety hazard. Passing criteria for the
Current Limiter Test is that the EUT may be damaged, but it may not exceed the
acceptable time/current criteria (i.e., it can not cause the wiring simulator in Figure 4-2
to open) nor become a fire, fragmentation, or electrical safety hazard.
The indicator used in measuring fire, fragmentation, and electrical safety hazards is a
bleached, untreated cotton cheesecloth which is wrapped around the EUT.
Compliance with testing is determined by the absence of ignition, charring, and the
ejection of molten material or fragments.
Lightning Fault Immunity Test
Metallic Voltage
- is defined as the potential difference between Tip and Ring. Metallic
voltages occur when there is an imperfect balance on the twisted pair. This imbalance
typically arises due to unmatched components, but can also occur when longitudinal
surges are converted to metallic surges due to asymmetrical operation of over-voltage
protectors.
Longitudinal Voltage
- is defined by Bellcore as half of the sum of the potential
difference seen between the Tip conductor and earth ground and the Ring conductor
and earth ground. During transient activity, damaging voltages are propagated over
the phone lines raising the potential difference of each line with respect to earth
ground. It is this potential difference that is often attributed to failed network equipment
and is simulated in Tests 1, 2, 3, and 5 in Table 4-2.
Test 4 in Table 4-2 simulates transients that are coupled to the network equipment via
ground conductors. These transients occur when nearby lightning strikes produce
large surge currents which generate excessive voltage due to the resistive path of the
protector and power grounds.
First Level Lightning Surge Test
To pass the First Level Lightning Surge Test, the EUT must be undamaged and
continue to operate properly after the stress is removed. This is referred to as passing
“
operationally
”
. The conditions for the First Level criteria are shown in Table 4-2. The
applicants have the option to submit their equipment to meet surges 1, 2, 4 and 5 or
surges 3, 4, and 5.
相關PDF資料 |
PDF描述 |
|---|---|
| P2600EA | MCU CMOS 28 LD 40MHZ 8K OTP, -40C to +125C, 28-SPDIP, TUBE |
| P2600EARP1 | MCU CMOS 28 LD 40MHZ 8K OTP, -40C to +85C, 28-SPDIP, TUBE |
| P2702AA | MCU CMOS 84 LD LOW PWR, -40C to +85C, 84-PLCC, TUBE |
| P2702AARP | SIDAC|160V V(BO) MAX|800MA I(S)|TO-220VAR |
| P2702AB | SIDAC|160V V(BO) MAX|800MA I(S)|TO-220VAR |
相關代理商/技術參數 |
參數描述 |
|---|---|
| P2500ATL | 制造商:SEMIKRON 制造商全稱:Semikron International 功能描述:Standard silicon rectifier diodes |
| P2500B | 制造商:SEMIKRON 制造商全稱:Semikron International 功能描述:Standard silicon rectifier diodes |
| P2500BTL | 制造商:SEMIKRON 制造商全稱:Semikron International 功能描述:Standard silicon rectifier diodes |
| P2500D | 制造商:SEMIKRON 制造商全稱:Semikron International 功能描述:Standard silicon rectifier diodes |
| P2500DTL | 制造商:SEMIKRON 制造商全稱:Semikron International 功能描述:Standard silicon rectifier diodes |
發布緊急采購，3分鐘左右您將得到回復。