- 您現在的位置：買賣IC網 > PDF目錄3887 > PIC16C432-E/P (Microchip Technology)IC MCU CMOS 8-BIT 20MHZ 2K 20DIP PDF資料下載
參數資料
| 型號： | PIC16C432-E/P |
| 廠商： | Microchip Technology |
| 文件頁數： | 11/70頁 |
| 文件大?。?/td> | 0K |
| 描述： | IC MCU CMOS 8-BIT 20MHZ 2K 20DIP |
| 標準包裝： | 25 |
| 系列： | PIC® 16C |
| 核心處理器： | PIC |
| 芯體尺寸： | 8-位 |
| 速度： | 20MHz |
| 連通性： | LIN（本地互連網絡） |
| 外圍設備： | 欠壓檢測/復位，POR，WDT |
| 輸入/輸出數： | 12 |
| 程序存儲器容量： | 3.5KB（2K x 14） |
| 程序存儲器類型： | OTP |
| RAM 容量： | 128 x 8 |
| 電壓 - 電源 (Vcc/Vdd)： | 4.5 V ~ 5.5 V |
| 振蕩器型： | 外部 |
| 工作溫度： | -40°C ~ 125°C |
| 封裝/外殼： | 20-DIP（0.300"，7.62mm） |
| 包裝： | 管件 |
| 配用： | AC164029-ND - MODULE SKT PROMATEII 20DIP/SSOP DVA16XP201-ND - ADAPTER DEVICE FOR MPLAB-ICE |
第1頁第2頁第3頁第4頁第5頁第6頁第7頁第8頁第9頁第10頁當前第11頁第12頁第13頁第14頁第15頁第16頁第17頁第18頁第19頁第20頁第21頁第22頁第23頁第24頁第25頁第26頁第27頁第28頁第29頁第30頁第31頁第32頁第33頁第34頁第35頁第36頁第37頁第38頁第39頁第40頁第41頁第42頁第43頁第44頁第45頁第46頁第47頁第48頁第49頁第50頁第51頁第52頁第53頁第54頁第55頁第56頁第57頁第58頁第59頁第60頁第61頁第62頁第63頁第64頁第65頁第66頁第67頁第68頁第69頁第70頁
2002 Microchip Technology Inc.
Preliminary
DS41140B-page 17
PIC16C432
4.0
I/O PORTS
The PIC16C432 parts have two ports, PORTA and
PORTB. Some pins for these I/O ports are multiplexed
with an alternate function for the peripheral features on
the device. In general, when a peripheral is enabled,
that pin may not be used as a general purpose I/O pin.
4.1
PORTA and TRISA Registers
PORTA is a 5-bit wide latch. RA4 is a Schmitt Trigger
input and an open drain output. Port RA4 is multiplexed
with the T0CKI clock input. All other RA port pins have
Schmitt Trigger input levels and full CMOS output driv-
ers. All pins have data direction bits (TRIS registers),
which can configure these pins as input or output.
A ’1’ in the TRISA register puts the corresponding out-
put driver in a Hi-impedance mode. A ’0’ in the TRISA
register puts the contents of the output latch on the
selected pin(s).
Reading the PORTA register reads the status of the pins,
whereas writing to it will write to the port latch. All write
operations are read-modify-write operations. So a write
to a port implies that the port pins are first read, then this
value is modified and written to the port data latch.
The PORTA pins are multiplexed with comparator and
voltage reference functions. The operation of these
pins are selected by control bits in the CMCON
(Comparator
Control
Register)
register
and
the
VRCON (Voltage Reference Control Register) register.
When selected as a comparator input, these pins will
read as ’0’s.
FIGURE 4-1:
BLOCK DIAGRAM OF RA0
PINS
TRISA controls the direction of the RA pins, even when
they are being used as comparator inputs. The user
must make sure to keep the pins configured as inputs
when using them as comparator inputs.
The RA2 pin will also function as the output for the volt-
age reference. When in this mode, the VREF pin is a very
high impedance output. The user must configure
TRISA<2> bit as an input and use high impedance loads.
In one of the comparator modes defined by the
CMCON register, pins RA3 and RA4 become outputs
of the comparators. The TRISA<4:3> bits must be
cleared to enable outputs to use this function.
EXAMPLE 4-1:
INITIALIZING PORTA
Data
Bus
Q
D
Q
CK
P
N
WR
PORTA
WR
TRISA
Data Latch
TRIS Latch
RD TRISA
RD PORTA
Analog
Vss
VDD
I/O Pin
Q
D
Q
CK
Input Mode
D
Q
EN
To Comparator
Schmitt Trigger
Input Buffer
VDD
Note:
On RESET, the TRISA register is set to all
inputs. The digital inputs are disabled and
the comparator inputs are forced to
ground, to reduce excess current con-
sumption.
CLRF
PORTA
;Initialize PORTA by setting
;output data latches
MOVLW
0X07
;Turn comparators off and
MOVWF
CMCON
;enable pins for I/O
;functions
BSF
STATUS,
RP0
;Select Bank1
MOVLW
0x1F
;Value used to initialize
;data direction
MOVWF
TRISA
;Set RA<4:0> as inputs
;TRISA<7:5> are always
;read as ’0’.
Note 1: BACT pin is an output and must be left
open if unused.
相關PDF資料 |
PDF描述 |
|---|---|
| PIC18LF452T-I/L | IC MCU FLASH 16KX16 A/D 44PLCC |
| PIC18LF442T-I/L | IC MCU FLASH 8KX16 A/D 44PLCC |
| PIC16HV540-04I/P | IC MCU OTP 512X12 18DIP |
| PIC16LC781T-I/SO | IC MCU OTP 1KX14 A/D D/A 20SOIC |
| PIC16LC782T-I/SS | IC MCU OTP 2KX14 A/D D/A 20SSOP |
相關代理商/技術參數 |
參數描述 |
|---|---|
| PIC16C432-I/P | 功能描述:8位微控制器 -MCU 20MHz 2K EPROM RoHS:否 制造商:Silicon Labs 核心:8051 處理器系列:C8051F39x 數據總線寬度:8 bit 最大時鐘頻率:50 MHz 程序存儲器大小:16 KB 數據 RAM 大小:1 KB 片上 ADC:Yes 工作電源電壓:1.8 V to 3.6 V 工作溫度范圍:- 40 C to + 105 C 封裝 / 箱體:QFN-20 安裝風格:SMD/SMT |
| PIC16C432-I/SS | 功能描述:8位微控制器 -MCU 3.5KB 128 RAM 12 I/O RoHS:否 制造商:Silicon Labs 核心:8051 處理器系列:C8051F39x 數據總線寬度:8 bit 最大時鐘頻率:50 MHz 程序存儲器大小:16 KB 數據 RAM 大小:1 KB 片上 ADC:Yes 工作電源電壓:1.8 V to 3.6 V 工作溫度范圍:- 40 C to + 105 C 封裝 / 箱體:QFN-20 安裝風格:SMD/SMT |
| PIC16C432T-E/SS | 功能描述:8位微控制器 -MCU 3.5KB 128 RAM 12 I/O RoHS:否 制造商:Silicon Labs 核心:8051 處理器系列:C8051F39x 數據總線寬度:8 bit 最大時鐘頻率:50 MHz 程序存儲器大小:16 KB 數據 RAM 大小:1 KB 片上 ADC:Yes 工作電源電壓:1.8 V to 3.6 V 工作溫度范圍:- 40 C to + 105 C 封裝 / 箱體:QFN-20 安裝風格:SMD/SMT |
| PIC16C432T-I/SS | 功能描述:8位微控制器 -MCU 3.5KB 128 RAM 12 I/O RoHS:否 制造商:Silicon Labs 核心:8051 處理器系列:C8051F39x 數據總線寬度:8 bit 最大時鐘頻率:50 MHz 程序存儲器大小:16 KB 數據 RAM 大小:1 KB 片上 ADC:Yes 工作電源電壓:1.8 V to 3.6 V 工作溫度范圍:- 40 C to + 105 C 封裝 / 箱體:QFN-20 安裝風格:SMD/SMT |
| PIC16C433/JW | 功能描述:8位微控制器 -MCU 3.5KB 128 RAM 6 I/O RoHS:否 制造商:Silicon Labs 核心:8051 處理器系列:C8051F39x 數據總線寬度:8 bit 最大時鐘頻率:50 MHz 程序存儲器大小:16 KB 數據 RAM 大小:1 KB 片上 ADC:Yes 工作電源電壓:1.8 V to 3.6 V 工作溫度范圍:- 40 C to + 105 C 封裝 / 箱體:QFN-20 安裝風格:SMD/SMT |
發布緊急采購，3分鐘左右您將得到回復。