參數資料
型號： PIC16CR77-I/ML
廠商： Microchip Technology
文件頁數： 155/172頁
文件大?。?/td> 0K
描述： IC PIC MCU 8KX14 44QFN
標準包裝： 45
系列： PIC® 16C
核心處理器： PIC
芯體尺寸： 8-位
速度： 20MHz
連通性： I²C，SPI，UART/USART
外圍設備： 欠壓檢測/復位，POR，PWM，WDT
輸入/輸出數： 33
程序存儲器容量： 14KB（8K x 14）
程序存儲器類型： ROM
RAM 容量： 368 x 8
電壓 - 電源 (Vcc/Vdd)： 2 V ~ 5.5 V
數據轉換器： A/D 8x8b
振蕩器型： 內部
工作溫度： -40°C ~ 85°C
封裝/外殼： 44-VQFN 裸露焊盤
包裝： 管件
2007 Microchip Technology Inc.
DS39599G-page 81
PIC18F2220/2320/4220/4320
7.0
DATA EEPROM MEMORY
The data EEPROM is readable and writable during nor-
mal operation over the entire VDD range. The data
memory is not directly mapped in the register file
space. Instead, it is indirectly addressed through the
Special Function Registers (SFR).
There are four SFRs used to read and write the
program and data EEPROM memory. These registers
are:
EECON1
EECON2
EEDATA
EEADR
The EEPROM data memory allows byte read and write.
When interfacing to the data memory block, EEDATA
holds the 8-bit data for read/write and EEADR holds the
address of the EEPROM location being accessed.
These devices have 256 bytes of data EEPROM with
an address range from 00h to FFh.
The EEPROM data memory is rated for high erase/write
cycle endurance. A byte write automatically erases the
location and writes the new data (erase-before-write). The
write time is controlled by an on-chip timer. The write time
will vary with voltage and temperature, as well as from
chip to chip. Please refer to parameter D122 (Table 26-1
limits.
7.1
EEADR
The address register can address 256 bytes of data
EEPROM.
7.2
EECON1 and EECON2 Registers
EECON1 is the control register for memory accesses.
EECON2 is not a physical register. Reading EECON2
will read all ‘0’s. The EECON2 register is used
exclusively in the memory write and erase sequences.
Control bit EEPGD determines if the access will be to
program or data EEPROM memory. When clear, oper-
ations will access the data EEPROM memory. When
set, program memory is accessed.
Control bit, CFGS, determines if the access will be to
the Configuration registers or to program memory/data
EEPROM memory. When set, subsequent operations
access Configuration registers. When CFGS is clear,
the EEPGD bit selects either Flash program or data
EEPROM memory.
The WREN bit enables and disables erase and write
operations. When set, erase and write operations are
allowed. When clear, erase and write operations are
disabled; the WR bit cannot be set while the WREN bit
is clear. This mechanism helps to prevent accidental
writes to memory due to errant (unexpected) code
execution.
Firmware should keep the WREN bit clear at all times
except when starting erase or write operations. Once
firmware has set the WR bit, the WREN bit may be
cleared. Clearing the WREN bit will not affect the
operation in progress.
The WRERR bit is set when a write operation is inter-
rupted by a Reset. In these situations, the user can
check the WRERR bit and rewrite the location. It is nec-
essary to reload the data and address registers
(EEDATA and EEADR), as these registers have
cleared as a result of the Reset.
Control bits, RD and WR, start read and erase/write
operations, respectively. These bits are set by firmware
and cleared by hardware at the completion of the
operation.
The RD bit cannot be set when accessing program
memory (EEPGD = 1). Program memory is read using
table read instructions. See Section 6.1 “Table Reads
and Table Writes” regarding table reads.
Note:
Interrupt flag bit, EEIF in the PIR2 register,
is set when write is complete. It must be
cleared in software.
相關PDF資料
PDF描述
PIC16CR74T-I/PT IC PIC MCU 4KX14 44TQFP
PIC16F627A-I/ML IC MCU FLASH 1KX14 EEPROM 28QFN
PIC24F08KL401-I/P IC MCU 16BIT 8KB FLASH 20-PDIP
PIC16LF727-I/P IC PIC MCU FLASH 8K 1.8V 40-DIP
PIC12C672-10/SM IC MCU OTP 2KX14 A/D 8-SOIJ
相關代理商/技術參數
參數描述
PIC16CR77T-I/ML 功能描述:IC PIC MCU 8KX14 44QFN RoHS:是 類別:集成電路 (IC) >> 嵌入式 - 微控制器， 系列:PIC® 16C 產品培訓模塊:Asynchronous Stimulus 8-bit PIC® Microcontroller Portfolio 標準包裝:42 系列:PIC® 16C 核心處理器:PIC 芯體尺寸:8-位 速度:20MHz 連通性:- 外圍設備:欠壓檢測/復位，POR，PWM，WDT 輸入/輸出數:13 程序存儲器容量:3.5KB（2K x 14） 程序存儲器類型:OTP EEPROM 大小:- RAM 容量:128 x 8 電壓 - 電源 (Vcc/Vdd):4 V ~ 5.5 V 數據轉換器:A/D 4x8b 振蕩器型:外部 工作溫度:-40°C ~ 85°C 封裝/外殼:18-SOIC（0.295"，7.50mm 寬） 包裝:管件 配用:XLT18SO-1-ND - SOCKET TRANSITION 18SOIC 300MILISPICR1-ND - ADAPTER IN-CIRCUIT PROGRAMMING309-1011-ND - ADAPTER 18-SOIC TO 18-DIP309-1010-ND - ADAPTER 18-SOIC TO 18-DIPAC164010-ND - MODULE SKT PROMATEII DIP/SOIC
PIC16CR77T-I/PT 功能描述:IC PIC MCU 8KX14 44TQFP RoHS:是 類別:集成電路 (IC) >> 嵌入式 - 微控制器， 系列:PIC® 16C 產品培訓模塊:Asynchronous Stimulus 8-bit PIC® Microcontroller Portfolio 標準包裝:42 系列:PIC® 16C 核心處理器:PIC 芯體尺寸:8-位 速度:20MHz 連通性:- 外圍設備:欠壓檢測/復位，POR，PWM，WDT 輸入/輸出數:13 程序存儲器容量:3.5KB（2K x 14） 程序存儲器類型:OTP EEPROM 大小:- RAM 容量:128 x 8 電壓 - 電源 (Vcc/Vdd):4 V ~ 5.5 V 數據轉換器:A/D 4x8b 振蕩器型:外部 工作溫度:-40°C ~ 85°C 封裝/外殼:18-SOIC（0.295"，7.50mm 寬） 包裝:管件 配用:XLT18SO-1-ND - SOCKET TRANSITION 18SOIC 300MILISPICR1-ND - ADAPTER IN-CIRCUIT PROGRAMMING309-1011-ND - ADAPTER 18-SOIC TO 18-DIP309-1010-ND - ADAPTER 18-SOIC TO 18-DIPAC164010-ND - MODULE SKT PROMATEII DIP/SOIC
PIC16CR83T-04/SO023 制造商:Microchip Technology Inc 功能描述:
PIC16F 制造商:Microchip Technology Inc 功能描述:Microchip PIC16F677-I/P Microcontroller
PIC16F1454-E/ML 制造商:Microchip Technology Inc 功能描述:7 KB FLASH, 512 BYTES RAM, 48 MHZ INT. OSC, 12 I/0, ENHANCED - Rail/Tube 制造商:Microchip Technology Inc 功能描述:IC MCU 8BIT 7KB FLASH 16QFN
發布緊急采購，3分鐘左右您將得到回復。

采購需求

(若只采購一條型號，填寫一行即可)

發布成功！您可以繼續發布采購。也可以進入我的后臺，查看報價

發布成功！您可以繼續發布采購。也可以進入我的后臺，查看報價

*型號 *數量 廠商 批號 封裝
添加更多采購

我的聯系方式

*
*
*