- 您現在的位置：買賣IC網 > PDF目錄373273 > RH80532NC021256 Microprocessor PDF資料下載
參數資料
| 型號： | RH80532NC021256 |
| 元件分類： | 微處理器 |
| 英文描述： | Microprocessor |
| 中文描述： | 微處理器 |
| 文件頁數： | 54/93頁 |
| 文件大?。?/td> | 2353K |
| 代理商： | RH80532NC021256 |
第1頁第2頁第3頁第4頁第5頁第6頁第7頁第8頁第9頁第10頁第11頁第12頁第13頁第14頁第15頁第16頁第17頁第18頁第19頁第20頁第21頁第22頁第23頁第24頁第25頁第26頁第27頁第28頁第29頁第30頁第31頁第32頁第33頁第34頁第35頁第36頁第37頁第38頁第39頁第40頁第41頁第42頁第43頁第44頁第45頁第46頁第47頁第48頁第49頁第50頁第51頁第52頁第53頁當前第54頁第55頁第56頁第57頁第58頁第59頁第60頁第61頁第62頁第63頁第64頁第65頁第66頁第67頁第68頁第69頁第70頁第71頁第72頁第73頁第74頁第75頁第76頁第77頁第78頁第79頁第80頁第81頁第82頁第83頁第84頁第85頁第86頁第87頁第88頁第89頁第90頁第91頁第92頁第93頁
Mobile Intel
Pentium
4 Processor-M
54
Datasheet
250686-002
Note:
Oscillations below the reference voltage can not be subtracted from the total overshoot/undershoot
pulse duration.
3.3.4
Activity Factor
Activity Factor (AF) describes the frequency of overshoot (or undershoot) occurrence relative to a
clock. Since the highest frequency of assertion of any signal is every other clock, an AF = 1
indicates that the specific overshoot (or undershoot) waveform occurs EVERY OTHER clock
cycle. Thus, an AF = 0.01 indicates that the specific overshoot (or undershoot) waveform occurs
one time in every 200 clock cycles.
For source synchronous signals (address, data, and associated strobes), the activity factor is in
reference to the strobe edge, since the highest frequency of assertion of any source synchronous
signal is every active edge of its associated strobe. An AF = 1 indicates that the specific overshoot
(undershoot) waveform occurs every strobe cycle.
The specifications provided in
Table 29
through
Table 32
show the maximum pulse duration
allowed for a given overshoot/undershoot magnitude at a specific activity factor. Each table entry is
independent of all others, meaning that the pulse duration reflects the existence of overshoot/
undershoot events of that magnitude ONLY. A platform with an overshoot/undershoot that just
meets the pulse duration for a specific magnitude where the AF < 1, means that there can be no
other overshoot/undershoot events, even of lesser magnitude (note that if AF = 1, then the event
occurs at all times and no other events can occur).
Note:
1:
Activity factor for AGTL+ signals is referenced to BCLK[1:0] frequency.
Note:
2:
Activity factor for source synchronous (2x) signals is referenced to ADSTB[1:0]#.
Note:
3:
Activity factor for source synchronous (4x) signals is referenced to DSTBP[3:0]# and
DSTBN[3:0]#.
3.3.5
Reading Overshoot/Undershoot Specification Tables
The overshoot/undershoot specification for the Mobile Intel Pentium 4 Processor-M is not a simple
single value. Instead, many factors are needed to determine what the over/undershoot specification
is. In addition to the magnitude of the overshoot, the following parameters must also be known: the
width of the overshoot (as measured above V
CC
) and the activity factor (AF). To determine the
allowed overshoot for a particular overshoot event, the following must be done:
1. Determine the
signal group
a particular signal falls into. If the signal is an AGTL+ signal
operating in the common clock domain, use
Table 31
. For AGTL+ signals operating in the 2x
source synchronous domain, use
Table 30
. For AGTL+ signals operating in the 4x source
synchronous domain, use
Table 29
. Finally, all other signals reside in the 100-MHz domain
(asynchronous GTL+, TAP, etc.) and are referenced in
Table 32
.
2. Determine the
magnitude
of the overshoot (relative to V
SS
)
3. Determine the
activity factor
(how often does this overshoot occur)
4. Next, from the appropriate specification table, determine the
maximum pulse duration
(in
nanoseconds) allowed.
5. Compare the specified maximum pulse duration to the signal being measured. If the pulse
duration measured is less than the pulse duration shown in the table, then the signal meets the
specifications.
相關PDF資料 |
PDF描述 |
|---|---|
| RH80532NC025256 | Microprocessor |
| RH80532NC029256 | Microprocessor |
| RH80532NC033256 | Microprocessor |
| RHE070 | Poly Switch PTC DEVICES |
| RHE1000 | Poly Switch PTC DEVICES |
相關代理商/技術參數 |
參數描述 |
|---|---|
| RH80532NC025256 | 制造商:未知廠家 制造商全稱:未知廠家 功能描述:Microprocessor |
| RH80532NC029256 | 制造商:未知廠家 制造商全稱:未知廠家 功能描述:Microprocessor |
| RH80532NC033256 | 制造商:未知廠家 制造商全稱:未知廠家 功能描述:Microprocessor |
| RH80532NC049256 | 制造商:Rochester Electronics LLC 功能描述:- Bulk |
| RH80532NC049256S L8SB | 制造商:Intel 功能描述:INTEL CELERON PROCESSOR AVAILABLE AT 1.60 GHZ, 1.8 GHZ, 2.00 GHZ, 2.2 GHZ |
發布緊急采購，3分鐘左右您將得到回復。