參數資料
型號： RTL8100L
廠商： Electronic Theatre Controls, Inc.
英文描述： REALTEK SINGLE CHIP FAST ETHERNET CONTROLLER WITH POWER MANAGEMENT
中文描述： 瑞昱單芯片快速以太網控制器電源管理
文件頁數： 13/58頁
文件大小： 657K
代理商： RTL8100L
RTL8100B(L)
2001-11-9
Rev.1.41
13
5.2 Transmit Status Register
(TSD0-3)(Offset 0010h-001Fh, R/W)
The read-only bits (CRS, TABT, OWC, CDH, NCC3-0, TOK, TUN) will be cleared by the RTL8100B(L) when the Transmit
Byte Count (bits 12-0) in the corresponding Tx descriptor is written. It is not affected when software writes to these bits. These
registers are only permitted to write by double-word access. After a software reset, all bits except OWN bit are reset to “0”.
Bit
31
R/W
R
Symbol
CRS
Description
Carrier Sense Lost:
This bit is set to 1 when the carrier is lost during
transmission of a packet.
Transmit Abort:
This bit is set to 1 if the transmission of a packet was
aborted. This bit is read only, writing to this bit is not affected.
Out of Window Collision:
This bit is set to 1 if the RTL8100B(L)
encountered an "out of window" collision during the transmission of a
packet.
CD Heart Beat:
The NIC watches for a collision signal (ie, CD
Heartbeat signal) during the first 6.4us of the interframe gap following a
transmission. This bit is set if the transceiver fails to send this signal.
This bit is cleared in the 100 Mbps mode.
Number of Collision Count:
Indicates the number of collisions
encountered during the transmission of a packet.
Reserved
Early Tx Threshold:
Specifies the threshold level in the Tx FIFO to
begin the transmission. When the byte count of the data in the Tx FIFO
reaches this level, (or the FIFO contains at least one complete packet)
the RTL8100B(L) will transmit this packet.
000000 = 8 bytes
These fields count from 000001 to 111111 in unit of 32 bytes.
This threshold must be avoided from exceeding 2K byte.
Transmit OK:
Set to 1 indicates that the transmission of a packet was
completed successfully and no transmit underrun has occurred.
Transmit FIFO Underrun:
Set to 1 if the Tx FIFO was exhausted
during the transmission of a packet. The RTL8100B(L) can re-transfer
data if the Tx FIFO underruns and can also transmit the packet to the
wire successfully even though the Tx FIFO underruns. That is, when
TSD<TUN>=1, TSD<TOK>=0 and ISR<TOK>=1 (or ISR<TER>=1).
OWN:
The RTL8100B(L) sets this bit to 1 when the Tx DMA
operation of this descriptor was completed. The driver must set this bit
to 0 when the Transmit Byte Count (bits 0-12) is written. The default
value is 1.
Descriptor Size:
The total size in bytes of the data in this descriptor. If
the packet length is more than 1792 byte (0700h), the Tx queue will be
invalid, i.e. the next descriptor will be written only after the OWN bit of
that long packet's descriptor has been set.
30
R
TABT
29
R
OWC
28
R
CDH
27-24
R
NCC3-0
23-22
21-16
-
-
R/W
ERTXTH5-0
15
R
TOK
14
R
TUN
13
R/W
OWN
12-0
R/W
SIZE
相關PDF資料
PDF描述
RTL8101 REALTEK SINGLE CHIP FAST ETHERNET CONTROLLER WITH POWER MANAGEMENT
RTL8305S 5-PORT 10/100 MBPS SINGLE CHIP SWITCH CONTROLLER
RTL8308B REALTEK SINGLE CHIP 8-PORT 10/100 ETHERNET SWITCH CONTROLLER WITH EMBEDDED MEMORY
RTL8309SB SINGLE-CHIP 9-PORT 10/100MBPS SWITCH CONTROLLER
RTS0072 VOICE CHANGER
相關代理商/技術參數
參數描述
RTL8101 制造商:未知廠家 制造商全稱:未知廠家 功能描述:REALTEK SINGLE CHIP FAST ETHERNET CONTROLLER WITH POWER MANAGEMENT
RTL8101L 制造商:未知廠家 制造商全稱:未知廠家 功能描述:REALTEK SINGLE CHIP FAST ETHERNET CONTROLLER AND MC97 CONTROLLER WITH POWER MANAGEMENT
RTL8101LLQFP 制造商:未知廠家 制造商全稱:未知廠家 功能描述:REALTEK SINGLE CHIP FAST ETHERNET CONTROLLER AND MC97 CONTROLLER WITH POWER MANAGEMENT
RTL8101LQFP 制造商:未知廠家 制造商全稱:未知廠家 功能描述:REALTEK SINGLE CHIP FAST ETHERNET CONTROLLER AND MC97 CONTROLLER WITH POWER MANAGEMENT
RTL8110 制造商:REALTEK 制造商全稱:REALTEK 功能描述:Integrated gigabit ethernet controller(LOM)
發布緊急采購，3分鐘左右您將得到回復。

采購需求

(若只采購一條型號，填寫一行即可)

發布成功！您可以繼續發布采購。也可以進入我的后臺，查看報價

發布成功！您可以繼續發布采購。也可以進入我的后臺，查看報價

*型號 *數量 廠商 批號 封裝
添加更多采購

我的聯系方式

*
*
*