參數資料
型號: SAH-XC2712X-8F66R
廠商: INFINEON TECHNOLOGIES AG
元件分類: 微控制器/微處理器
英文描述: 32-BIT, FLASH, 66 MHz, RISC MICROCONTROLLER, PDSO38
封裝: 0.50 MM PITCH, GREEN, PLASTIC, TSSOP-38
文件頁數: 63/103頁
文件大小: 2957K
代理商: SAH-XC2712X-8F66R
XC2712X
XC2000 Family / Compact Line
Electrical Parameters
PRELIMINARY
Data Sheet
58
V1.0, 2010-12
Input high voltage
V
IH SR
0.7 x
V
DDP
V
DDP +
0.3
V
Input low voltage
V
IL SR
-0.3
0.3 x
V
DDP
V
Output High voltage6)
V
OH CC
V
DDP -
1.0
V
I
OHIOHmax
V
DDP -
0.4
V
I
OHIOHnom
7)
Output Low Voltage6)
V
OL CC
0.4
V
I
OLIOLnom
8)
1.0
V
I
OLIOLmax
1) Not subject to production test - verified by design/characterization. Hysteresis is implemented to avoid
metastable states and switching due to internal ground bounce. It cannot suppress switching due to external
system noise under all conditions.
2) If the input voltage exceeds the respective supply voltage due to ground bouncing (
VIN < VSS) or supply ripple
(
VIN > VDDP), a certain amount of current may flow through the protection diodes. This current adds to the
leakage current. An additional error current (
IINJ) will flow if an overload current flows through an adjacent pin.
Please refer to the definition of the overload coupling factor
KOV.
3) The given values are worst-case values. In production test, this leakage current is only tested at 125 °C; other
values are ensured by correlation. For derating, please refer to the following descriptions: Leakage derating
depending on temperature (
TJ = junction temperature [°C]): IOZ = 0.05 x e(1.5 + 0.028 x TJ>) [μA]. For example, at
a temperature of 95 °C the resulting leakage current is 3.2
μA. Leakage derating depending on voltage level
(DV =
VDDP - VPIN [V]): IOZ = IOZtempmax - (1.6 x DV) (μA]. This voltage derating formula is an approximation
which applies for maximum temperature.
4) Drive the indicated minimum current through this pin to change the default pin level driven by the enabled pull
device.
5) Limit the current through this pin to the indicated value so that the enabled pull device can keep the default
pin level.
6) The maximum deliverable output current of a port driver depends on the selected output driver mode. This
specification is not valid for outputs which are switched to open drain mode. In this case the respective output
will float and the voltage is determined by the external circuit.
7) As a rule, with decreasing output current the output levels approach the respective supply level (VOL->VSS,
VOH->VDDP). However, only the levels for nominal output currents are verified.
8) As a rule, with decreasing output current the output levels approach the respective supply level (
V
OL->VSS,
V
OH->VDDP). However, only the levels for nominal output currents are verified.
Table 17
DC Characteristics for Lower Voltage Range (cont’d)
Parameter
Symbol
Values
Unit Note /
Test Condition
Min.
Typ.
Max.
相關PDF資料
PDF描述
SAK-XC2712X-8F66R 32-BIT, FLASH, 66 MHz, RISC MICROCONTROLLER, PDSO38
SAK-C164CH-8FM 16-BIT, FLASH, 25 MHz, MICROCONTROLLER, PQFP80
SAK-C164CI-8EMCB 16-BIT, OTPROM, 20 MHz, MICROCONTROLLER, PQFP80
SAK-C164SV-2RF 16-BIT, MROM, 20 MHz, MICROCONTROLLER, PQFP64
SAF-C164SV-2RF 16-BIT, MROM, 20 MHz, MICROCONTROLLER, PQFP64
相關代理商/技術參數
參數描述
SAI Y-4S M8-M8 制造商:Weidmuller 功能描述:SPLITTER PLUG TO 2X RCPT M8 制造商:Weidmuller 功能描述:SPLITTER, PLUG TO 2X RCPT, M8, 4 WAY 制造商:Weidmuller 功能描述:SPLITTER, PLUG TO 2X RCPT, M8, 4 WAY, No. of Ports:2, SVHC:No SVHC (20-Jun-2013)
SAI01 制造商:SANKEN 制造商全稱:Sanken electric 功能描述:Surface-Mount, Separate Excitation Switching Type
SAI01-1 制造商:SANKEN 制造商全稱:Sanken electric 功能描述:Surface-mount and Separate Excitation Type
SAI01V1 制造商:Sanken Electric Co Ltd 功能描述:IC REG BUCK 5V 0.5A PS-4PIN
SAI02 制造商:SANKEN 制造商全稱:Sanken electric 功能描述:Surface-mount and Separate Excitation Type