- 您現在的位置：買賣IC網 > PDF目錄98076 > SAK-XC164CS-32F20F (INFINEON TECHNOLOGIES AG) 16-BIT, FLASH, 20 MHz, RISC MICROCONTROLLER, PQFP100 PDF資料下載
參數資料
| 型號： | SAK-XC164CS-32F20F |
| 廠商： | INFINEON TECHNOLOGIES AG |
| 元件分類： | 微控制器/微處理器 |
| 英文描述： | 16-BIT, FLASH, 20 MHz, RISC MICROCONTROLLER, PQFP100 |
| 封裝： | 0.50 MM PITCH, GREEN, PLASTIC, TQFP-100 |
| 文件頁數： | 53/81頁 |
| 文件大小： | 1106K |
| 代理商： | SAK-XC164CS-32F20F |
第1頁第2頁第3頁第4頁第5頁第6頁第7頁第8頁第9頁第10頁第11頁第12頁第13頁第14頁第15頁第16頁第17頁第18頁第19頁第20頁第21頁第22頁第23頁第24頁第25頁第26頁第27頁第28頁第29頁第30頁第31頁第32頁第33頁第34頁第35頁第36頁第37頁第38頁第39頁第40頁第41頁第42頁第43頁第44頁第45頁第46頁第47頁第48頁第49頁第50頁第51頁第52頁當前第53頁第54頁第55頁第56頁第57頁第58頁第59頁第60頁第61頁第62頁第63頁第64頁第65頁第66頁第67頁第68頁第69頁第70頁第71頁第72頁第73頁第74頁第75頁第76頁第77頁第78頁第79頁第80頁第81頁
XC164-32
Derivatives
Electrical Parameters
Data Sheet
55
V1.1, 2006-08
Level inactive hold
current13)
I
–-10
A
V
OUT = 0.5 ×
V
DDP
Level active hold
current13)
I
LHA
-100
–
A
V
OUT = 0.45 V
XTAL1 input current
I
IL
CC –
±20
A0 V < V
IN < VDDI
Pin capacitance14)
(digital inputs/outputs)
C
IO
CC –
10
pF
–
1) Keeping signal levels within the limits specified in this table, ensures operation without overload conditions.
For signal levels outside these specifications, also refer to the specification of the overload current
IOV.
2) If XTAL1 is driven by a crystal, reaching an amplitude (peak to peak) of 0.4
× V
DDI is sufficient.
3) This parameter is tested for P3, P4, P9.
4) The maximum deliverable output current of a port driver depends on the selected output driver mode, see
Table 12, Current Limits for Port Output Drivers. The limit for pin groups must be respected.
5) As a rule, with decreasing output current the output levels approach the respective supply level (
VOL → VSS,
VOH → VDDP). However, only the levels for nominal output currents are guaranteed.
6) This specification is not valid for outputs which are switched to open drain mode. In this case the respective
output will float and the voltage results from the external circuitry.
7) An additional error current (
IINJ) will flow if an overload current flows through an adjacent pin. Please refer to
the definition of the overload coupling factor
KOV.
8) The driver of P3.15 is designed for faster switching, because this pin can deliver the reference clock for the
bus interface (CLKOUT). The maximum leakage current for P3.15 is, therefore, increased to 1
A.
9) This specification is valid during Reset for configuration on RD, WR, EA, PORT0
10) The maximum current may be drawn while the respective signal line remains inactive.
11) The minimum current must be drawn to drive the respective signal line active.
12) This specification is valid during Reset for configuration on ALE.
13) This specification is valid during Reset for pins P4.3-0, which can act as CS outputs, and for P3.12.
14) Not subject to production test - verified by design/characterization.
Table 11
DC Characteristics (Operating Conditions apply)1) (cont’d)
Parameter
Symbol
Limit Values
Unit Test Condition
Min.
Max.
相關PDF資料 |
PDF描述 |
|---|---|
| SAK-XC2267M-104F80LAA | 32-BIT, FLASH, 80 MHz, RISC MICROCONTROLLER, PQFP100 |
| SAK-XC2285M-104F80LAA | RISC MICROCONTROLLER, PQFP144 |
| SAK-XC2285M-56F80LAA | RISC MICROCONTROLLER, PQFP144 |
| SAF-XC2287M-72F80LAA | RISC MICROCONTROLLER, PQFP144 |
| SAF-XC2285M-72F80LAA | RISC MICROCONTROLLER, PQFP144 |
相關代理商/技術參數 |
參數描述 |
|---|---|
| SAK-XC164CS-32F20F BB-A | 功能描述:16位微控制器 - MCU 16BIT SNGL CHIP 5V 20MHz Flash RoHS:否 制造商:Texas Instruments 核心:RISC 處理器系列:MSP430FR572x 數據總線寬度:16 bit 最大時鐘頻率:24 MHz 程序存儲器大小:8 KB 數據 RAM 大小:1 KB 片上 ADC:Yes 工作電源電壓:2 V to 3.6 V 工作溫度范圍:- 40 C to + 85 C 封裝 / 箱體:VQFN-40 安裝風格:SMD/SMT |
| SAK-XC164CS-32F20F BB-A TR | 制造商:Infineon Technologies AG 功能描述: |
| SAKXC164CS32F20FBB-A | 制造商:Infineon Technologies AG 功能描述: |
| SAK-XC164CS-32F40F | 制造商:Rochester Electronics LLC 功能描述:- Bulk |
| SAK-XC164CS-32F40F BB | 制造商:Infineon Technologies AG 功能描述:MCU 16-Bit XC166 CISC/DSP/RISC 256KB Flash 2.5V/5V 100-Pin TQFP |
發布緊急采購，3分鐘左右您將得到回復。